參數資料
型號： MT9079
廠商： Mitel Networks Corporation
英文描述： Advanced Controller for E1(先進的E1幀調節器和控制器)
中文描述： 高級控制器素E1（先進的素E1幀調節器和控制器）
文件頁數： 15/60頁
文件大?。?/td> 347K
代理商： MT9079
MT9079
4-221
8) When CRC-4 multiframing has been achieved,
the primary basic frame alignment and resulting
multiframe alignment will be adjusted to the basic
frame
alignment
determined
synchronization. Therefore, the primary basic frame
alignment will not be updated during the CRC-4
multiframing search, but will be updated when the
CRC-4 multiframing search is complete.
during
CRC-4
Channel Signalling
When control bit TxCAS is low the MT9079 is in
Channel Associated Signalling mode (CAS); when
TxCAS is high it is in Common Channel Signalling
(CCS) mode. The CAS mode ABCD signalling
nibbles can be passed either via the micro-ports
(RPSIG = 1) or through related channels of the
CSTo1 and CSTi2 serial links (RPSIG = 0), see
Figure 4. Memory page five contains the receive
ABCD nibbles and page six the transmit ABCD
nibbles for micro-port CAS access.
In CAS operation an ABCD signalling bit debounce
of 14 msec. can be selected (DBNCE = 1). This is
consistent with the signalling recognition time of
CCITT Q.422. It should be noted that there may be
as much as 2 msec. added to this duration because
signalling
equipment
state
synchronous with the PCM 30 multiframe.
changes
are
not
If basic frame synchronization is lost (page 3,
address 10H, SYNC = 1) all receive CAS signalling
nibbles are frozen. Receive CAS nibbles will become
unfrozen when basic frame synchronization is
acquired.
When the SIGI interrupt is unmasked, IRQ will
become active when a signalling nibble state change
is detected in any of the 30 receive channels. The
SIGI interrupt mask is located on page 1, address
1CH, bit 0; and the SIGI interrupt vector (page 4,
address 12H) is 01H.
Loopbacks
In order to meet PRI Layer 1 requirements and to
assist in circuit fault sectionalization the MT9079 has
six loopback functions. These are as follows:
a) Digital loopback (DSTi to DSTo at the PCM 30
side). Bit DLBK = 0 normal; DLBK = 1 activate.
b) Remote loopback (RxA and RxB to TxA and TxB
respectively at the PCM 30 side). Bit RLBK = 0
normal; RLBK = 1 activate.
c) ST-BUS loopback (DSTi to DSTo at the system
side). Bit SLBK = 0 normal; SLBK = 1 activate.
d) Payload loopback (RxA and RxB to TxA and TxB
respectively at the system side with FAS and NFAS
operating normally). Bit PLBK = 0 normal; PLBK = 1
activate. The payload loopback is effectively a
physical connection of DSTo to DSTi within the
MT9079. Channel zero and the DL originate at the
point of loopback.
e) Local and remote time slot loopback. Local time
slot loopback control bit LTSL = 0 normal; LTSL = 1
activate, will loop around transmit ST-BUS time slots
to the DSTo stream. Remote time slot loopback bits
RTSL = 0 normal; RTSL = 1 activate, will loop around
receive PCM 30 time slots towards the remote PCM
30 end.
The digital, remote, ST-BUS and payload loopbacks
are located on page 1, address 15H, control bits 3 to
0. The remote and local time slot loopbacks are
controlled through control bits 4 and 5 of the per time
slot control words, pages 7 and 8.
MT9079
Tx
DSTi
DSTo
System
PCM30
MT9079
Tx
DSTo
System
PCM30
Rx
MT9079
Tx
DSTi
DSTo
System
PCM30
MT9079
Tx
DSTi
DSTo
System
PCM30
Rx
MT9079
Tx
DSTi
DSTo
System
PCM30
Rx
相關PDF資料
PDF描述
MT9080B SMX - Switch Matrix Module(用于消費類轉換應用的開關矩陣模塊)
MT90810 Flexible MVIP(Multi-Vendor Integration Protocol) Interface Circuit(彈性MVIP接口電路)
MT90812 Integrated Digital Switch (IDX)(集成數字開關)
MT90840AK Distributed Hyperchannel Switch
MT90840AP Distributed Hyperchannel Switch
相關代理商/技術參數
參數描述
MT9079AC 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:CMOS ST-BUS? FAMILY Advanced Controller for E1
MT9079AE 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:CMOS ST-BUS? FAMILY Advanced Controller for E1
MT9079AL 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:CMOS ST-BUS⑩ FAMILY Advanced Controller for E1
MT9079AP 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:CMOS ST-BUS⑩ FAMILY Advanced Controller for E1
MT9079APR 制造商:Microsemi Corporation 功能描述:FRAMER E1 5V 44PLCC - Tape and Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*