參數資料
型號： MB95F263KPF-G-SNE2
廠商： Fujitsu Semiconductor America Inc
文件頁數： 66/87頁
文件大小： 0K
描述： IC MCU 8BIT 12KB FLASH 20SOP
標準包裝： 1,325
系列： 8FX MB95260H
核心處理器： F²MC-8FX
芯體尺寸： 8-位
速度： 16MHz
連通性： LIN，SIO，UART/USART
外圍設備： LVD，POR，PWM，WDT
輸入/輸出數： 16
程序存儲器容量： 12KB（12K x 8）
程序存儲器類型： 閃存
RAM 容量： 496 x 8
電壓 - 電源 (Vcc/Vdd)： 2.4 V ~ 5.5 V
數據轉換器： A/D 6x8/10b
振蕩器型： 外部
工作溫度： -40°C ~ 85°C
封裝/外殼： 20-SOIC（0.295"，7.50mm 寬）
包裝： 托盤
其它名稱： 865-1210
2011 Microchip Technology Inc.
DS70118J-page 73
dsPIC30F2010
12.4.2
PWM PERIOD
The PWM period is specified by writing to the PRx reg-
ister. The PWM period can be calculated using
EQUATION 12-1:
PWM PERIOD
PWM frequency is defined as 1/[PWM period].
When the selected TMRx is equal to its respective
period register, PRx, the following four events occur on
the next increment cycle:
TMRx is cleared.
The OCx pin is set.
- Exception 1: If PWM duty cycle is 0x0000,
the OCx pin will remain low.
- Exception 2: If duty cycle is greater than PRx,
the pin will remain high.
The PWM duty cycle is latched from OCxRS into
OCxR.
The corresponding timer interrupt flag is set.
See Figure 12-1 for key PWM period comparisons.
Timer3 is referred to in the figure for clarity.
12.5
Output Compare Operation During
CPU Sleep Mode
When the CPU enters the Sleep mode, all internal
clocks are stopped. Therefore, when the CPU enters
the Sleep state, the output compare channel will drive
the pin to the active state that was observed prior to
entering the CPU Sleep state.
For example, if the pin was high when the CPU
entered the Sleep state, the pin will remain high. Like-
wise, if the pin was low when the CPU entered the
Sleep state, the pin will remain low. In either case, the
output compare module will resume operation when
the device wakes up.
12.6
Output Compare Operation During
CPU Idle Mode
When the CPU enters the Idle mode, the output
compare module can operate with full functionality.
The output compare channel will operate during the
CPU Idle mode if the OCSIDL bit (OCxCON<13>) is at
logic ‘0’ and the selected time base (Timer2 or Timer3)
is enabled and the TSIDL bit of the selected timer is
set to logic ‘0’.
FIGURE 12-1:
PWM OUTPUT TIMING
12.7
Output Compare Interrupts
The output compare channels have the ability to gener-
ate an interrupt on a compare match, for whichever
Match mode has been selected.
For all modes except the PWM mode, when a compare
event occurs, the respective interrupt flag (OCxIF) is
asserted and an interrupt will be generated, if enabled.
The OCxIF bit is located in the corresponding IFS
status register, and must be cleared in software. The
interrupt is enabled via the respective compare inter-
rupt enable (OCxIE) bit, located in the corresponding
IEC Control register.
For the PWM mode, when an event occurs, the respec-
tive timer interrupt flag (T2IF or T3IF) is asserted and
an interrupt will be generated, if enabled. The IF bit is
located in the IFS0 status register, and must be cleared
in software. The interrupt is enabled via the respective
timer interrupt enable bit (T2IE or T3IE), located in the
IEC0 Control register. The output compare interrupt
flag is never set during the PWM mode of operation.
PWM period = [(PRx) + 1] 4 TOSC
(TMRx prescale value)
Period
Duty Cycle
TMR3 = Duty Cycle (OCxR)
TMR3 = PR3
T3IF = 1
(Interrupt Flag)
OCxR = OCxRS
TMR3 = PR3
(Interrupt Flag)
OCxR = OCxRS
T3IF = 1
相關PDF資料
PDF描述
MB95F274KPF-G-SNE2 IC MCU 8BIT 20KB FLASH 8SOP
MB95F283KPF-G-SNE1 IC MCU 8BIT 12KB FLASH 16SOP
MB95F316EPMC-G-SNE2 IC MCU 8BIT 36KB FLASH 80LQFP
MB95F334HPMC-G-SNE2 IC MCU 8BIT 20KB FLASH 32LQFP
MB95F353EPF-G-SNE2 IC MCU 8BIT 12KB FLASH 24SOP
相關代理商/技術參數
參數描述
MB95F264KPF-ES-SNE2 制造商:FUJITSU 功能描述:
MB95F264KPF-G-SNE2 功能描述:IC MCU 8BIT 20KB FLASH 20SOP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:8FX MB95260H 標準包裝:250 系列:LPC11Uxx 核心處理器:ARM? Cortex?-M0 芯體尺寸:32-位 速度:50MHz 連通性:I²C，Microwire，SPI，SSI，SSP，UART/USART，USB 外圍設備:欠壓檢測/復位，POR，WDT 輸入/輸出數:40 程序存儲器容量:96KB（96K x 8） 程序存儲器類型:閃存 EEPROM 大小:4K x 8 RAM 容量:10K x 8 電壓 - 電源 (Vcc/Vdd):1.8 V ~ 3.6 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:48-LQFP 包裝:托盤 其它名稱:568-9587
MB95F272KPF-G-SNE2 功能描述:IC MCU 8BIT 8KB FLASH 8SOP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:8FX MB95270H 標準包裝:250 系列:LPC11Uxx 核心處理器:ARM? Cortex?-M0 芯體尺寸:32-位 速度:50MHz 連通性:I²C，Microwire，SPI，SSI，SSP，UART/USART，USB 外圍設備:欠壓檢測/復位，POR，WDT 輸入/輸出數:40 程序存儲器容量:96KB（96K x 8） 程序存儲器類型:閃存 EEPROM 大小:4K x 8 RAM 容量:10K x 8 電壓 - 電源 (Vcc/Vdd):1.8 V ~ 3.6 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:48-LQFP 包裝:托盤 其它名稱:568-9587
MB95F273KPF-G-SNE2 功能描述:IC MCU 8BIT 12KB FLASH 8SOP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:8FX MB95270H 標準包裝:250 系列:LPC11Uxx 核心處理器:ARM? Cortex?-M0 芯體尺寸:32-位 速度:50MHz 連通性:I²C，Microwire，SPI，SSI，SSP，UART/USART，USB 外圍設備:欠壓檢測/復位，POR，WDT 輸入/輸出數:40 程序存儲器容量:96KB（96K x 8） 程序存儲器類型:閃存 EEPROM 大小:4K x 8 RAM 容量:10K x 8 電壓 - 電源 (Vcc/Vdd):1.8 V ~ 3.6 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:48-LQFP 包裝:托盤 其它名稱:568-9587
MB95F274KPF-G-SNE2 功能描述:IC MCU 8BIT 20KB FLASH 8SOP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:8FX MB95270H 標準包裝:60 系列:BlueStreak ; LH7 核心處理器:ARM7 芯體尺寸:32-位 速度:84MHz 連通性:EBI/EMI，SPI，SSI，SSP，UART/USART 外圍設備:欠壓檢測/復位，DMA，LCD，POR，PWM，WDT 輸入/輸出數:76 程序存儲器容量:- 程序存儲器類型:ROMless EEPROM 大小:- RAM 容量:32K x 8 電壓 - 電源 (Vcc/Vdd):1.7 V ~ 3.6 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:144-LQFP 包裝:托盤
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*