- 您現在的位置：買賣IC網 > PDF目錄45027 > M34554MC-XXXFP 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PQFP64 PDF資料下載
參數資料
| 型號： | M34554MC-XXXFP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PQFP64 |
| 封裝： | 14 X 14 MM, 0.80 MM PITCH, PLASTIC, QFP-64 |
| 文件頁數： | 90/138頁 |
| 文件大?。?/td> | 1082K |
| 代理商： | M34554MC-XXXFP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁當前第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁
Rev.3.00
Aug 06, 2004
page 55 of 136
REJ03B0043-0300Z
4554 Group
Table 15 Functions and states retained at power down
Function
Program counter (PC), registers A, B,
carry flag (CY), stack pointer (SP) (Note 2)
Contents of RAM
Interrupt control registers V1, V2
Interrupt control registers I1, I2
Selected oscillation circuit
Clock control register MR
Timer 1 to timer 4 functions
Timer 5 function
Timer LC function
Watchdog timer function
Timer control registers PA, W4
Timer control registers W1 to W3, W5, W6
LCD display function
LCD control registers L1 to L3
Voltage drop detection circuit
Port level
Pull-up control registers PU0, PU1
Key-on wakeup control registers K0 to K2
Port output format control registers
FR0 to FR2
External interrupt request flags
(EXF0, EXF1)
Timer interrupt request flags (T1F to T4F)
Timer interrupt request flag (T5F)
Interrupt enable flag (INTE)
Watchdog timer flags (WDF1, WDF2)
Watchdog timer enable flag (WEF)
O
O
(Note 3)
O
(Note 3)
(Note 4)
O
(Note 5)
O
(Note 6)
(Note 7)
O
(Note 3)
O
(Note 4)
Notes 1:“O” represents that the function can be retained, and “” repre-
sents that the function is initialized.
Registers and flags other than the above are undefined at RAM
back-up, and set an initial value after returning.
2: The stack pointer (SP) points the level of the stack register and is
initialized to “7” at RAM back-up.
3: The state of the timer is undefined.
4: Initialize the watchdog timer with the WRST instruction, and then
go into the power down state.
5: LCD is turned off.
6: When the SVDE instruction is executed while the VDCE pin is in
the “H“ state, this function is valid at power down.
7: In the power down mode, C/CNTR1 pin outputs “L” level.
However, when the CNTR input is selected (W11, W10=“11”), C/
CNTR1 pin is in an input enabled state (output=high-impedance).
Other ports retain their respective output levels.
Power down mode
O
O
(Note 3)
O
(Note 4)
O
(Note 6)
(Note 7)
O
(Note 3)
O
(Note 4)
POWER DOWN FUNCTION
The 4554 Group has 2-type power down functions.
System enters into each power down state by executing the follow-
ing instructions.
Clock operating mode ...................... EPOF and POF instructions
RAM back-up mode ....................... EPOF and POF2 instructions
When the EPOF instruction is not executed before the POF or
POF2 instruction is executed, these instructions are equivalent to
the NOP instruction.
(1) Clock operating mode
The following functions and states are retained.
RAM
Reset circuit
XCIN–XCOUT oscillation
LCD display
Timer 5
(2) RAM back-up mode
The following functions and states are retained.
RAM
Reset circuit
(3) Warm start condition
The system returns from the power down state when;
External wakeup signal is input
Timer 5 underflow occurs
in the power down mode.
In either case, the CPU starts executing the software from address
0 in page 0. In this case, the P flag is “1.”
(4) Cold start condition
The CPU starts executing the software from address 0 in page 0
when;
reset pulse is input to RESET pin,
reset by watchdog timer is performed, or
reset by the voltage drop detection circuit is performed.
In this case, the P flag is “0.”
(5) Identification of the start condition
Warm start or cold start can be identified by examining the state of
the power down flag (P) with the SNZP instruction. The warm start
condition from the clock operating mode can be identified by exam-
ining the state of T5F flag.
Clock
operating
RAM
back-up
相關PDF資料 |
PDF描述 |
|---|---|
| M34554EDFP | 4-BIT, OTPROM, 6 MHz, MICROCONTROLLER, PQFP64 |
| M3455AG8-XXXFP | 4-BIT, OTPROM, 6 MHz, MICROCONTROLLER, PQFP52 |
| M3455AGCFP | 4-BIT, OTPROM, 6 MHz, MICROCONTROLLER, PQFP52 |
| M3455AGC-XXXFP | 4-BIT, OTPROM, 6 MHz, MICROCONTROLLER, PQFP52 |
| M3455AG8FP | 4-BIT, OTPROM, 6 MHz, MICROCONTROLLER, PQFP52 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M34556G8FP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
| M34556G8HFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
| M34556M4H-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
| M34556M4-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
| M34556M8H-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER |
發布緊急采購，3分鐘左右您將得到回復。