參數資料
型號: ISP1181ABS
廠商: NXP SEMICONDUCTORS
元件分類: 總線控制器
英文描述: INDUCTOR 1.0NH +-.3NH FIXED SMD
中文描述: UNIVERSAL SERIAL BUS CONTROLLER, PQCC48
封裝: 7 X 7 MM, 0.85 MM HEIGHT, PLASTIC, MO-220, SOT-619-2, HVQFN-48
文件頁數: 43/70頁
文件大?。?/td> 341K
代理商: ISP1181ABS
Philips Semiconductors
ISP1181A
Full-speed USB peripheral controller
Product data
Rev. 05 — 08 December 2004
43 of 70
9397 750 13959
Koninklijke Philips Electronics N.V. 2004. All rights reserved.
14. Power supply
The ISP1181A is powered from a single supply voltage, ranging from 4.0 V to 5.5 V.
An integrated voltage regulator provides a 3.3 V supply voltage for the internal logic
and the USB transceiver. This voltage is available at pin V
reg(3.3)
for connecting an
external pull-up resistor on USB connection D
+
. See
Figure 9
.
The ISP1181A can also be operated from a 3.0 V to 3.6 V supply, as shown in
Figure 10
. In this case, the internal voltage regulator is disabled and pin V
reg(3.3)
must
be connected to V
CC
.
15. Crystal oscillator and LazyClock
The ISP1181A has a crystal oscillator designed for a 6 MHz parallel-resonant crystal
(fundamental). A typical circuit is shown in
Figure 11
. Alternatively, an external clock
signal of 6 MHz can be applied to input XTAL1, while leaving output XTAL2 open.
The 6 MHz oscillator frequency is multiplied to 48 MHz by an internal PLL. This
frequency is used to generate a programmable clock output signal at pin CLKOUT,
ranging from 3 MHz to 48 MHz.
In ‘suspend’ state the normal CLKOUT signal is not available, because the crystal
oscillator and the PLL are switched off to save power. Instead, the CLKOUT signal
can be switched to the LazyClock frequency of 100 kHz
±
50 %.
The oscillator operation and the CLKOUT frequency are controlled via the Hardware
Configuration Register, as shown in
Figure 12
. The following bits are involved:
CLKRUN switches the oscillator on and off
CLKDIV[3:0] is the division factor determining the normal CLKOUT frequency
NOLAZY controls the LazyClock signal output during ‘suspend’ state.
Fig 9.
ISP1181A with a 4.0 V to 5.5 V supply.
Fig 10. ISP1181A with a 3.0 V to 3.6 V supply.
VCC
VCC(3.3)
Vreg(3.3)
ISP1181A
004aaa026
4.0 V to 5.5 V
Vref
3.0 V to 3.6 V
004aaa027
VCC
VCC(3.3)
Vreg(3.3)
ISP1181A
Vref
Fig 11. Typical oscillator circuit.
CLKOUT
6 MHz
18 pF
18 pF
XTAL2
XTAL1
004aaa028
ISP1181A
相關PDF資料
PDF描述
ISP1181A Full-speed Universal Serial Bus peripheral controller
ISP1181ADGG Full-speed Universal Serial Bus peripheral controller
ISP1181B Full-speed Universal Serial Bus peripheral controller
ISP1181BBS Full-speed Universal Serial Bus peripheral controller
ISP1181BDGG Full-speed Universal Serial Bus peripheral controller
相關代理商/技術參數
參數描述
ISP1181ABS,518 功能描述:USB 接口集成電路 USB 1.1 ADV DEVICE RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
ISP1181ABS,551 功能描述:USB 接口集成電路 USB 1.1 ADVANCED DEVICE RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
ISP1181ABS,557 功能描述:USB 接口集成電路 DO NOT USE ORDER -S OR -T PART RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
ISP1181ABSGE 功能描述:IC USB CNTRLR FULL-SPD 48-HVQFN RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN(6x6) 包裝:* 其它名稱:Q6396337A
ISP1181ABS-S 功能描述:IC USB HOST CTRL FULL-SPD 48HVQF RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN(6x6) 包裝:* 其它名稱:Q6396337A