參數資料
型號： ISL6271ACR-T
廠商： INTERSIL CORP
元件分類： 穩壓器
英文描述： Integrated XScale Regulator
中文描述： 0.8 A SWITCHING REGULATOR, PQCC20
封裝： 4 X 4 MM, LEAD FREE, PLASTIC, MO-220-VGGD, QFN-20
文件頁數： 10/16頁
文件大?。?/td> 588K
代理商： ISL6271ACR-T
10
FN9171.1
BBAT
The BBAT pin is an input voltage to the ISL6271A that
supports the BFLT# indicator function as described above.
When the main battery is absent, or of inadequate potential,
the BBAT input voltage supplies power to support the BFLT#
indicator. The input voltage must be between 1.5V and
3.75V for proper operation and is typically supplied from the
system back-up battery. The maximum current drain from
the BBAT pin is 0.1μA.
PGOOD
PGOOD is an open-drain output that indicates the status of the
three regulators (VOUT, VSRAM, VPLL). This output is held
low until all outputs are within their specified voltage tolerance.
As soon as outputs are in regulation, the output is released and
pulled high by an external resistor tied to a compliant system
voltage. This output can be AND’d with other system power-
good indicators that also have open-drain outputs. Note that
this is not a latched output and under a soft short condition on
any of the regulators it is possible to see this pin oscillate at a
frequency proportional to the fault current level and the fault
monitoring hysteresis internal to the ISL6271A regulator.
PHASE Node Ring Damping Circuit
To enhance system reliability and minimize radiated
emission, the ISL6271A implements a PHASE node snubber
while operating in diode emulation. The active snubber
places a 50
(nominal) resistor across the output inductor
when the low side synchronous rectifier is turned off to
prevent reverse current.
Inter-IC Communications
Communication between the host processor and the
ISL6271A takes place over a two-wire I
2
C interface. The bus
consists of one bidirectional signal line, SDA (data), and a
clock pin input, SCL, generated by the bus master. Both pins
are pulled-high to a system voltage with external pull-up
resistors. A typical pull-up resistor value for a single
master/slave interface operating in normal mode is 5k
.
See the Phillips specification listed in the reference section for
specific details on the selection of the pull-up resistor. The bus
supports both standard mode and fast mode data rates as
defined by the Phillips protocol. A typical I
2
C transmission is
illustrated in Figure 17. When the bus-resident master
(processor) wants to communicate with a bus-resident slave
(ISL6271A), it will pull the SDA line low while the SCL line is
still high. This signals a “start” condition. It will then clock the
address of the desired slave device at a rate of one bit per
clock cycle. The address is embedded in the first seven bits of
the first byte transfer, with the eighth bit giving the directional
information (Read/Write) for the next byte of information.
When the slave detects an address match, it will hold the SDA
line low during the ninth clock pulse to acknowledge a match
(ACK). If the direction bit indicates a “write” (send) byte, the
slave will receive the byte clocked in by the master and will
give an “acknowledge” by again pulling the SDA line low
during the ninth clock cycle. The master then can either
terminate transmission by issuing a “stop” bit, or continue to
transfer successive bytes until complete.
Multiple successive bytes can be transferred with only an
acknowledge bit separating them until a “stop” or repeated
“start” signal is given by the master. The data embedded in
the byte is latched into its appropriate register(s) on the rising
edge of the SCL during the acknowledge pulse and is applied
to the ISL6271A DAC. The internal DAC on the ISL6271A
converts the 4 bit digital input as defined in Table 1 into the
reference voltage of the core regulator error amplifier.
If the master issues a ‘read’ command to the ISL6271A, to
verify the contents of the internal registers, the device will
place the byte on the bus to be clocked in by the master.
After the host master receives the byte, the cycle is
terminated by a “NOT acknowledge” signal, and a ‘stop’ bit.
A ‘stop’ is generated by releasing the SDA line to pull high
during a high state on the SCL line.
FIGURE 17. I
2
C DATA AND CLOCK
P
Sr
Sr
OR
P
S
OR
Sr
SDA
SCL
START OR
REPEATED START
CONDITION
STOP OR
REPEATED START
CONDITION
1
2
7
8
9
MSB
acknowledgement
signal from slave
acknowledgement
signal from receiver
9
1
2
3-8
ACK
ACK
clock line held low while
interrupts are serviced
byte complete,
interrupt within slave
ISL6271A
相關PDF資料
PDF描述
ISL6293 Dual Positive-Edge-Triggered D-Type Flip-Flops With Clear and Preset 14-SOIC -40 to 85
ISL6293-2CR Dual Positive-Edge-Triggered D-Type Flip-Flops With Clear and Preset 14-SOIC -40 to 85
ISL6293-2CR-T Dual Positive-Edge-Triggered D-Type Flip-Flops With Clear and Preset 14-PDIP -40 to 85
ISL6293-2CRZ Dual Positive-Edge-Triggered D-Type Flip-Flops With Clear and Preset 14-PDIP -40 to 85
ISL6293-2CRZ-T Dual Positive-Edge-Triggered D-Type Flip-Flops With Clear and Preset 14-SO -40 to 85
相關代理商/技術參數
參數描述
ISL6271ACRZ 功能描述:直流/直流開關調節器 LD PLL & SRAMG FOR I NTEL PROCESSORS IBM RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
ISL6271ACRZ-T 功能描述:直流/直流開關調節器 LD PLL & SRAMG FOR I NTEL PROCESSORS IBM RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
ISL6271AEVAL1 功能描述:EVALUATION BOARD FOR ISL6271A RoHS:否 類別:編程器，開發系統 >> 評估板 - DC/DC 與 AC/DC（離線）SMPS 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:True Shutdown™ 主要目的:DC/DC，步升 輸出及類型:1，非隔離 功率 - 輸出:- 輸出電壓:- 電流 - 輸出:1A 輸入電壓:2.5 V ~ 5.5 V 穩壓器拓?fù)浣Y(jié)構:升壓 頻率 - 開關:3MHz 板類型:完全填充 已供物品:板 已用 IC / 零件:MAX8969
ISL6271CR 制造商:Rochester Electronics LLC 功能描述:PLL & SRAM REGULATOR FOR INTEL PROCESSORS - Bulk 制造商:Intersil Corporation 功能描述:
ISL6271EVAL1 制造商:Intersil Corporation 功能描述:ISL6271, PLL & SRAM REGULATOR FOR INTEL PROCESSORS EVALUATIO - Bulk
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*