- 您現在的位置：買賣IC網 > PDF目錄370499 > HDMP-1014 Bipolar Transistor; Collector Emitter Voltage, Vceo:400V; Transistor Polarity:N Channel; Power Dissipation:250W; C-E Breakdown Voltage:400V; DC Current Gain Min (hfe):10; Collector Current:50A; Package/Case:TO-3 PDF資料下載
參數資料
| 型號： | HDMP-1014 |
| 英文描述： | Bipolar Transistor; Collector Emitter Voltage, Vceo:400V; Transistor Polarity:N Channel; Power Dissipation:250W; C-E Breakdown Voltage:400V; DC Current Gain Min (hfe):10; Collector Current:50A; Package/Case:TO-3 |
| 中文描述： | 4Low成本千兆速率發送/接收芯片組 |
| 文件頁數： | 32/42頁 |
| 文件大?。?/td> | 321K |
| 代理商： | HDMP-1014 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁當前第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁
604
SEND FF0
DISABLE DATA TRANSMISSION
DISABLE DATA RECEPTION
FREQUENCY DETECTOR ON
0
DATA
ERROR
RESET
SEND FF1
DISABLE DATA TRANSMISSION
ENABLE DATA RECEPTION
FREQUENCY DETECTOR OFF
1
FF0
SEND FF0
ENABLE DATA TRANSMISSION
ENABLE DATA RECEPTION
FREQUENCY DETECTOR OFF
2
DATA
FF1
FF1
FF0
ERROR
RESET
DATA
FF1
FF0
ERROR
RESET
Figure 15. HDMP-1014 (Rx) State Machine State Diagram.
phase detection mode. Parallel
data can be sent by the local Tx,
and at the same time, received by
the local Rx.
The Rx chip has the state machine
logic built in. The SMC has two
status outputs, STAT0 and STAT1,
that control the various features
of the two chips depending on the
current state. The TX inputs that
need to be controlled are FF and
ED. The RX inputs that need to be
controlled are FDIS and ACTIVE.
To control the chips as shown in
the state diagram of Figure 15,
the following interchip
connections must be made
(Figure 16):
When the local port is in State 0,
it is in the reset state, where both
local Tx and Rx parallel interfaces
are disabled. The local Tx
transmits FF0 continuously, and
the local Rx PLL is in the
frequency detection mode. When
the local Rx is phase-locked to the
remote Tx, it transitions to State
1. The local Tx transmits FF1 to
acknowledge the phase-locked
condition (its parallel input is still
disabled). The local Rx PLL is in
the phase detection mode and its
parallel output is enabled. When
in State 2, the two-way
synchronization between the local
port and the remote port is
established. Both local Tx and Rx
parallel interfaces are enabled,
and the local Rx PLL is in the
Tx FF is driven by STAT1
Tx ED is driven by STAT0
Rx FDIS is driven by STAT1
Rx ACTIVE is driven by STAT1
TX RST and RX SMCRST0 are
driven by a power-on, or user,
reset circuit.
相關PDF資料 |
PDF描述 |
|---|---|
| HDMP-1022 | Audio Power Amplifier; Speaker Channels:Mono; Headphone Channels:Mono; Output Power, Po:2W; Load Impedance Min:8ohm; Supply Voltage Max:24V; Supply Voltage Min:6V |
| HDMP-1024 | Low Cost Gigabit Rate Receive Chip Set with TTL I/Os(帶TTL輸入/輸出的低價格千兆位速率接收芯片) |
| HDMP-1032 | 1.4 GBd Transmitter Chip Set with CIMT Encoder/Decoder and Variable Data Rate(帶CIMT編碼器/譯碼器和變量數據速率的1.4 GBd 傳送器) |
| HDMP-1034 | 1.4 GBd Receiver Chip Set with CIMT Encoder/Decoder and Variable Data Rate(帶CIMT編碼器/譯碼器和變量數據速率的1.4 GBd 接收器) |
| HDMP-1512 | Fibre Channel Transmitter Chipset(光纖通道傳送芯片) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HDMP-1022 | 制造商:AGILENT 制造商全稱:AGILENT 功能描述:Low Cost Gigabit Rate Transmit/Receive Chip Set with TTL I/Os |
| HDMP-1024 | 制造商:AGILENT 制造商全稱:AGILENT 功能描述:Low Cost Gigabit Rate Transmit/Receive Chip Set with TTL I/Os |
| HDMP-1032 | 制造商:AGILENT 制造商全稱:AGILENT 功能描述:1.4 GBd Transmitter/Receiver Chip Set with CIMT Encoder/Decoder and Variable Data Rate |
| HDMP-1032A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:1.4 GBd Transmitter Chip with CIMT Encoder/Decoder and Variable Data Rate |
| HDMP-1034 | 制造商:AGILENT 制造商全稱:AGILENT 功能描述:1.4 GBd Transmitter/Receiver Chip Set with CIMT Encoder/Decoder and Variable Data Rate |
發布緊急采購，3分鐘左右您將得到回復。