參數資料
型號: AT90USB82-16MUR
廠商: Atmel
文件頁數: 24/38頁
文件大小: 0K
描述: MCU AVR USB 8K FLASH 32-QFN
產品培訓模塊: MCU Product Line Introduction
megaAVR Introduction
標準包裝: 5,000
系列: AVR® 90USB
核心處理器: AVR
芯體尺寸: 8-位
速度: 16MHz
連通性: EBI/EMI,PS/2,SPI,UART/USART,USB
外圍設備: 欠壓檢測/復位,POR,PWM,WDT
輸入/輸出數: 22
程序存儲器容量: 8KB(8K x 8)
程序存儲器類型: 閃存
EEPROM 大小: 512 x 8
RAM 容量: 512 x 8
電壓 - 電源 (Vcc/Vdd): 2.7 V ~ 5.5 V
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 32-VFQFN 裸露焊盤
包裝: 帶卷 (TR)
配用: ATSTK600-ND - DEV KIT FOR AVR/AVR32
ATSTK526-ND - KIT STARTER FOR AT90USB82/162
ATAVRDRAGON-ND - KIT DRAGON FLASH MEM AVR
ATSTK525-ND - KIT STARTER FOR AT90USB
AT90USBKEY2-ND - KIT DEMO FOR AT90USB
30
7707F–AVR–11/10
AT90USB82/162
Main purpose of the delay is to keep the AVR in reset until it is supplied with minimum Vcc. The
delay will not monitor the actual voltage and it will be required to select a delay longer than the
Vcc rise time. If this is not possible, an internal or external Brown-Out Detection circuit should be
used. A BOD circuit will ensure sufficient Vcc before it releases the reset, and the time-out delay
can be disabled. Disabling the time-out delay without utilizing a Brown-Out Detection circuit is
not recommended.
The oscillator is required to oscillate for a minimum number of cycles before the clock is consid-
ered stable. An internal ripple counter monitors the oscillator output clock, and keeps the internal
reset active for a given number of clock cycles. The reset is then released and the device will
start to execute. The recommended oscillator start-up time is dependent on the clock type, and
varies from 6 cycles for an externally applied clock to 32K cycles for a low frequency crystal.
The start-up sequence for the clock includes both the time-out delay and the start-up time when
the device starts up from reset. When starting up from Power-save or Power-down mode, Vcc is
assumed to be at a sufficient level and only the start-up time is included.
6.4
Low Power Crystal Oscillator
Pins XTAL1 and XTAL2 are input and output, respectively, of an inverting amplifier which can be
configured for use as an On-chip Oscillator, as shown in Figure 6-4. Either a quartz crystal or a
ceramic resonator may be used.
This Crystal Oscillator is a low power oscillator, with reduced voltage swing on the XTAL2 out-
put. It gives the lowest power consumption, but is not capable of driving other clock inputs, and
may be more susceptible to noise in noisy environments.
C1 and C2 should always be equal for both crystals and resonators. The optimal value of the
capacitors depends on the crystal or resonator in use, the amount of stray capacitance, and the
electromagnetic noise of the environment. Some initial guidelines for choosing capacitors for
use with crystals are given in Table 6-3. For ceramic resonators, the capacitor values given by
the manufacturer should be used.
Table 6-2.
Number of Watchdog Oscillator Cycles
Typ Time-out (V
CC = 5.0V)
Typ Time-out (V
CC = 3.0V)
Number of Cycles
0 ms
0
4.1 ms
4.3 ms
512
65 ms
69 ms
8K (8,192)
相關PDF資料
PDF描述
ADG201HSKR-REEL IC SWITCH QUAD SPST 16SOIC
ADG1406BRUZ-REEL7 IC MULTIPLEXER 8X1 28TSSOP
ADG201HSJPZ IC SWITCH QUAD SPST 20PLCC
ADG333ABR IC SWITCH QUAD SPDT 20SOIC
ADG333ABRS IC SWITCH QUAD SPDT 20SSOP
相關代理商/技術參數
參數描述
AT90USBKEY 功能描述:開發板和工具包 - AVR Demo board f/AVR MCU & AT90USB RoHS:否 制造商:Arduino 產品:Evaluation Boards 工具用于評估:ATMega32U4 核心:AVR 接口類型:I2C, UART, USB 工作電源電壓:6 V to 20 V
AT90USBKEY2 功能描述:開發板和工具包 - AVR AVR USB Eval Kit RoHS:否 制造商:Arduino 產品:Evaluation Boards 工具用于評估:ATMega32U4 核心:AVR 接口類型:I2C, UART, USB 工作電源電壓:6 V to 20 V
AT-910 制造商:HRS 制造商全稱:HRS 功能描述:Stripline Mounting Fixed Attenuators (DC to 8 GHz)
AT-910(40) 功能描述:衰減器 -IC RoHS:否 制造商:Skyworks Solutions, Inc. 最大衰減:18 dB 容差: 阻抗: 功率額定值:30 dBm 安裝風格:SMD/SMT 工作溫度范圍:- 40 C to + 85 C
AT-913(40) 功能描述:衰減器 -IC RoHS:否 制造商:Skyworks Solutions, Inc. 最大衰減:18 dB 容差: 阻抗: 功率額定值:30 dBm 安裝風格:SMD/SMT 工作溫度范圍:- 40 C to + 85 C