參數資料
型號： ADV7391BCPZ
廠商： Analog Devices Inc
文件頁數： 69/108頁
文件大?。?/td> 0K
描述： IC ENCODER VIDEO W/DAC 32LFCSP
產品變化通告： ADV734x, ADV739x Feature Improvement
標準包裝： 1
類型： 視頻編碼器
應用： 機頂盒，視頻播放器，顯示器
電壓 - 電源，模擬： 2.6 V ~ 3.46 V
電壓 - 電源，數字： 1.71 V ~ 1.89 V
安裝類型： 表面貼裝
封裝/外殼： 32-VFQFN 裸露焊盤，CSP
供應商設備封裝： 32-LFCSP-VQ（5x5）
包裝： 托盤
配用： EVAL-ADV7391EBZ-ND - BOARD EVAL FOR ADV7391 ENCODER
Data Sheet
ADV7390/ADV7391/ADV7392/ADV7393
Rev. G | Page 63 of 108
Coring Gain Border—Subaddress 0xA3, Bits[3:0]
These four bits are assigned to the gain factor applied to border
areas. In DNR mode, the range of gain values is 0 to 1 in
increments of 1/8. This factor is applied to the DNR filter
output that lies below the set threshold range. The result is then
subtracted from the original signal.
In DNR sharpness mode, the range of gain values is 0 to 0.5 in
increments of 1/16. This factor is applied to the DNR filter
output that lies above the threshold range. The result is added to
the original signal.
Coring Gain Data—Subaddress 0xA3, Bits[7:4]
These four bits are assigned to the gain factor applied to the luma
data inside the MPEG pixel block. In DNR mode, the range of
gain values is 0 to 1 in increments of 1/8. This factor is applied
to the DNR filter output that lies below the set threshold range.
The result is then subtracted from the original signal.
In DNR sharpness mode, the range of gain values is 0 to 0.5 in
increments of 1/16. This factor is applied to the DNR filter
output that lies above the threshold range. The result is added to
the original signal.
Figure 79. SD DNR Offset Control
DNR Threshold—Subaddress 0xA4, Bits[5:0]
These six bits are used to define the threshold value in the range
of 0 to 63. The range is an absolute value.
Border Area—Subaddress 0xA4, Bit 6
When this bit is set to Logic 1, the block transition area can be
defined to consist of four pixels. If this bit is set to Logic 0, the
border transition area consists of two pixels, where one pixel
refers to two clock cycles at 27 MHz.
Figure 80. SD DNR Border Area
Block Size—Subaddress 0xA4, Bit 7
This bit is used to select the size of the data blocks to be
processed. Setting the block size control function to Logic 1
defines a 16 pixel × 16 pixel data block, and Logic 0 defines an
8 pixel × 8 pixel data block, where one pixel refers to two clock
cycles at 27 MHz.
DNR Input Select—Subaddress 0xA5, Bits[2:0]
These three bits are assigned to select the filter that is applied to
the incoming Y data. The signal that lies in the pass band of the
selected filter is the signal processed by DNR. Figure 81 shows
the filter responses selectable with this control.
Figure 81. SD DNR Input Select
DNR Mode—Subaddress 0xA5, Bit 3
This bit controls the DNR mode selected. Logic 0 selects DNR
mode; Logic 1 selects DNR sharpness mode.
DNR works on the principle of defining low amplitude, high
frequency signals as probable noise and subtracting this noise
from the original signal.
In DNR mode, it is possible to subtract a fraction of the signal
that lies below the set threshold, assumed to be noise, from the
original signal. The threshold is set in DNR Register 1.
When DNR sharpness mode is enabled, it is possible to add a
fraction of the signal that lies above the set threshold to the
original signal because this data is assumed to be valid data and
not noise. The overall effect is that the signal is boosted (similar
to using the extended SSAF filter).
Block Offset Control—Subaddress 0xA5, Bits[7:4]
Four bits are assigned to this control, which allows a shift in the
data block of 15 pixels maximum. The coring gain positions are
fixed. The block offset shifts the data in steps of one pixel such
that the border coring gain factors can be applied at the same
position regardless of variations in input timing of the data.
O XXXXXXO O XXXXXXO
DNR27 TO DNR24 = 0x01
OFFSET CAUSED
BY VARIATIONS IN
INPUT TIMING
APPLY BORDER
CORING GAIN
APPLY DATA
CORING GAIN
06234-
080
720 × 485 PIXELS
(NTSC)
8 × 8 PIXEL BLOCK
TWO-PIXEL
BORDER
DATA
8 × 8 PIXEL BLOCK
06234-
081
FILTER C
FILTER B
FILTER A
FILTER D
FREQUENCY (MHz)
0
0.2
0.4
0.6
M
AG
NI
T
UDE
0.8
1.0
0
1
2
3
4
5
6
06234-
082
相關PDF資料
PDF描述
ADV7511KSTZ IC XMITTER HDMI 12BIT 100LQFP
ADV7511WBSWZ IC XMITTER HDMI AUTO 64LQFP
ADV7622BSTZ-RL IC TXRX HDMI 4:1 144LQFP
ADV7623BSTZ IC TXRX HDMI 4:1 144LQFP
ADW54010Z-0REEL IC SWITCH DUAL SPDT 10MSOP
相關代理商/技術參數
參數描述
ADV7391BCPZ-REEL 功能描述:IC VIDEO ENCODER SD/HD 32-LFCSP RoHS:是 類別:集成電路 (IC) >> 接口 - 編碼器，解碼器，轉換器 系列:- 產品變化通告:Development Systems Discontinuation 26/Apr/2011 標準包裝:1 系列:- 類型:編碼器 應用:DVB-S.2 系統 電壓 - 電源，模擬:- 電壓 - 電源，數字:- 安裝類型:- 封裝/外殼:模塊 供應商設備封裝:模塊 包裝:散裝 其它名稱:Q4645799
ADV7391EBZ 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Power, Chip Scale 10-Bit SD/HD Video Encoder
ADV7391WBCPZ 制造商:Analog Devices 功能描述:
ADV7391WBCPZ-RL 制造商:Analog Devices 功能描述:
ADV7392 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Power, Chip Scale 10-Bit SD/HD Video Encoder
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*