參數資料
型號： ADSP-2196MBST-140X
廠商： ANALOG DEVICES INC
元件分類： 數字信號處理
英文描述： DSP Microcomputer
中文描述： 16-BIT, 160 MHz, OTHER DSP, PQFP144
封裝： METRIC, PLASTIC, LQFP-144
文件頁數： 10/68頁
文件大?。?/td> 897K
代理商： ADSP-2196MBST-140X
For current information contact Analog Devices at 800/262-5643
ADSP-2196
PC stack can generate a stack-level interrupt if the PC stack
falls below three locations full or rises above 28
locations full.
The following instructions globally enable or disable
interrupt servicing, regardless of the state of IMASK.
September 2001
This information applies to a product under development. Its characteristics and specifications are subject to change with-
out notice. Analog Devices assumes no obligation regarding future manufacturing unless otherwise agreed to in writing.
10
REV. PrA
ENA INT;
DIS INT;
At reset, interrupt servicing is disabled.
For quick servicing of interrupts, a secondary set of DAG
and computational registers exist. Switching between the
primary and secondary registers lets programs quickly
service interrupts, while preserving the DSP’s state.
DMA Controller
The ADSP-2196 has a DMA controller that supports
automated data transfers with minimal overhead for the
DSP core. Cycle stealing DMA transfers can occur between
the ADSP-2196’s internal memory and any of its
DMA-capable peripherals. Additionally, DMA transfers
can be accomplished between any of the DMA-capable
peripherals and external devices connected to the external
memory interface. DMA-capable peripherals include the
Host port, SPORTs, SPI ports, and UART. Each individual
DMA-capable peripheral has a dedicated DMA channel. To
describe each DMA sequence, the DMA controller uses a
set of parameters—called a DMA descriptor. When succes-
sive DMA sequences are needed, these DMA descriptors
can be linked or chained together, so the completion of one
DMA sequence auto-initiates and starts the next sequence.
DMA sequences do not contend for bus access with the DSP
core, instead DMAs “steal” cycles to access memory.
All DMA transfers use the DMA bus shown in the func-
tional block diagram
on page 1
. Because all of the
peripherals use the same bus, arbitration for DMA bus
access is needed. The arbitration for DMA bus access
appears in
Table 4
.
Host Port
The ADSP-2196’s Host port functions as a slave on the
external bus of an external Host. The Host port interface
lets a Host read from or write to the DSP’s memory space,
boot space, or internal I/O space. Examples of Hosts include
external microcontrollers, microprocessors, or ASICs.
The Host port is a multiplexed address and data bus that
provides both an 8-bit and a 16-bit data path and operates
using an asynchronous transmission protocol. Through this
port, an off-chip Host can directly access the DSP’s entire
memory space map, boot memory space, and internal I/O
space. To access the DSP’s internal memory space, a Host
steals one cycle per access from the DSP. A Host access to
the DSP’s external memory uses the external port interface
and does not stall (or steal cycles from) the DSP’s core.
Because a Host can access internal I/O memory space, a
Host can control any of the DSP’s I/O mapped peripherals.
The Host port is most efficient when using the DSP as a
slave and uses DMA to automate the incrementing of
addresses for these accesses. In this case, an address does
not have to be transferred from the Host for every
data transfer.
Host Port Acknowledge (HACK) Modes
The Host port supports a number of modes (or protocols)
for generating a HACK output for the host. The host selects
ACK or Ready Modes using the HACK_P and HACK pins.
The Host port also supports two modes for address control:
Address Latch Enable (ALE) and Address Cycle Control
(ACC) modes. The DSP auto-detects ALE versus ACC
Mode from the HALE and HWR inputs.
The host port HACK signal polarity is selected (only at
reset) as active high or active low, depending on the value
driven on the HACK_P pin.The HACK polarity is stored
into the host port configuration register as a read only bit.
The DSP uses HACK to indicate to the Host when to
complete an access. For a read transaction, a Host can
proceed and complete an access when valid data is present
in the read buffer and the host port is not busy doing a write.
For a write transactions, a Host can complete an access
when the write buffer is not full and the host port is not busy
doing a write.
Table 4. I/O Bus Arbitration Priority
DMA Bus Master
Arbitration Priority
SPORT0 Receive DMA
0—Highest
SPORT1 Receive DMA
1
SPORT2 Receive DMA
2
SPORT0 Transmit DMA
3
SPORT1 Transmit DMA
4
SPORT2 Transmit DMA
5
SPI0 Receive/Transmit DMA
6
SPI1 Receive/Transmit DMA
7
UART Receive DMA
8
UART Transmit DMA
9
Host Port DMA
10
Memory DMA
11—Lowest
Table 4. I/O Bus Arbitration Priority (Continued)
DMA Bus Master
Arbitration Priority
相關PDF資料
PDF描述
ADSP-2196MKCA-160X DSP Microcomputer
ADSP-2196MKST-160X DSP Microcomputer
ADSP-21990 16-bit fixed point DSP with Flash
ADSP-21990BBC 16-bit fixed point DSP with Flash
ADSP-21990BST 16-bit fixed point DSP with Flash
相關代理商/技術參數
參數描述
ADSP-2196MBST-140Z 制造商:Analog Devices 功能描述:DSP Fixed-Point 16-Bit 140MHz 140MIPS 144-Pin LQFP
ADSP-2196MKST-160 制造商:Analog Devices 功能描述:DSP Fixed-Point 16-Bit 160MHz 160MIPS 144-Pin LQFP 制造商:Analog Devices 功能描述:16-Bit DSP 160 MIPs 2.5V 40 Kbytes
ADSP-2196MKSTZ-160 功能描述:IC DSP CONTROLLER 16BIT 144-LQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - DSP（數字式信號處理器） 系列:ADSP-21xx 標準包裝:40 系列:TMS320DM64x, DaVinci™ 類型:定點 接口:I²C，McASP，McBSP 時鐘速率:400MHz 非易失內存:外部 芯片上RAM:160kB 電壓 - 輸入/輸出:3.30V 電壓 - 核心:1.20V 工作溫度:0°C ~ 90°C 安裝類型:表面貼裝 封裝/外殼:548-BBGA，F(xiàn)CBGA 供應商設備封裝:548-FCBGA（27x27） 包裝:托盤 配用:TMDSDMK642-0E-ND - DEVELPER KIT W/NTSC CAMERA296-23038-ND - DSP STARTER KIT FOR TMS320C6416296-23059-ND - FLASHBURN PORTING KIT296-23058-ND - EVAL MODULE FOR DM642TMDSDMK642-ND - DEVELOPER KIT W/NTSC CAMERA
ADSP-21990BBC 制造商:Analog Devices 功能描述:DSP Fixed-Point 16-Bit 150MHz 150MIPS 196-Pin Mini-BGA 制造商:Rochester Electronics LLC 功能描述:160 MIPS, MIXED SIGNAL DSPWITH 14-BIT - Bulk
ADSP-21990BST 制造商:Rochester Electronics LLC 功能描述:160 MIPS,MIXED SIGNAL DSP WITH 14BIT - Tape and Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*