參數資料
型號： ADS1259EVM
廠商： Texas Instruments
文件頁數： 26/48頁
文件大?。?/td> 0K
描述： EVAL MODULE FOR ADS1259
標準包裝： 1
ADC 的數量： 1
位數： 24
采樣率（每秒）： 14k
數據接口： 串行，SPI?
工作溫度： -40°C ~ 125°C
已用 IC / 零件： ADS1259
已供物品： 板
其它名稱： 296-29312
ADS1259EVM-ND
SBAS424D
– JUNE 2009 – REVISED AUGUST 2011
COMMAND DEFINITIONS
The commands summarized in Table 19 control and configure the operation of the ADS1259. The commands
are stand-alone, except for the register read and register write operations which require a second command byte
plus data. CS can be taken high or held low between opcode commands but must stay low for the entire
command operation. Note that the Read Data Continuous mode must be cancelled by the Stop Read Data
Continuous mode opcode (SDATAC) before sending further commands.
Table 19. Command Definitions(1)
COMMAND
TYPE
DESCRIPTION
FIRST OPCODE BYTE
SECOND OPCODE BYTE
WAKEUP
Control
Wake up from SLEEP mode
0000 001x (02h or 03h)(2)
SLEEP
Control
Begin SLEEP mode
0000 010x (04h or 05h)(2)
RESET
Control
Reset to power-up values
0000 011x (06h or 07h)(2)
START
Control
START conversion
0000 100x (08h or 09h)(2)
STOP
Control
STOP conversion
0000 101x (0Ah or 0Bh)(2)
RDATAC
Control
Set Read Data Continuous mode
0001 0000 (10h)
SDATAC
Control
Stop Read Data Continuous mode
0001 0001 (11h)
RDATA
Data
Read data by opcode
0001 001x (12h or 13h)(2)
RREG
Register
Read nnnn register at address rrrr
0010 rrrr (20h + 0000 rrrr)
0000 nnnn (00h + nnnn)
WREG
Register
Write nnnn register at address rrrr
0100 rrrr (40h + 0000 rrrr)
0000 nnnn (00h + nnnn)
OFSCAL
Calibration
Offset calibration
0001 1000 (18h)
GANCAL
Calibration
Gain calibration
0001 1001 (19h)
(1)
nnnn = number of registers to be read/written
– 1. For example, to read/write 3 registers, set nnnn = 2 (0010).
rrrr = starting register address for read/write opcodes.
(2)
These commands are decoded on the seventh bit of the opcode. The eighth bit is a don
't care bit. All other commands are decoded on
the eighth bit.
WAKEUP: Exit SLEEP Mode
Description: This command exits the low-power SLEEP mode; see the SLEEP Mode section.
SLEEP: Enter SLEEP Mode
Description: This command enters the low-power SLEEP mode. See the SLEEP Mode section.
RESET: Reset Registers to Default Values
Description: This command resets the digital filter cycle and returns all register settings to the default values.
START: Start Conversions
Description: This command starts data conversions. If PULSE bit = 1, then a single conversion is performed. If
PULSE bit = 0, then conversions continue until the STOP command is sent. Tie the START pin low to control
conversions by command.
STOP: Stop Conversions
Description: This command stops conversions. When the STOP command is sent, the conversion in progress
completes and further conversions are stopped. If conversions are already stopped, this command has no effect.
See the Conversion Control section. Tie the START pin low to control conversions by command.
RDATAC: Read Data Continuous
Description: This command enables the Read Data Continuous mode (default). See the Read Data Continuous
Mode section for details. Disable this mode with the SDATAC command before sending other commands.
SDATAC: Stop Read Data Continuous
Description: This command cancels the Read Data Continuous mode.
32
Copyright
2009–2011, Texas Instruments Incorporated
相關PDF資料
PDF描述
0210490281 CABLE JUMPER 1.25MM .076M 22POS
EBC19DREN-S93 CONN EDGECARD 38POS .100 EYELET
EEC19DRYN-S93 CONN EDGECARD 38POS DIP .100 SLD
EBC19DREH-S93 CONN EDGECARD 38POS .100 EYELET
MLK1005S2N4S INDUCTOR MULTILAYER 2.4NH 0402
相關代理商/技術參數
參數描述
ADS1259EVM 制造商:Texas Instruments 功能描述:DEVELOPMENT TOOL
ADS1259EVM-PDK 功能描述:數據轉換 IC 開發工具 ADS1259 Perf Demo Kit RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V
ADS1259EVM-PDK 制造商:Texas Instruments 功能描述:DEVELOPMENT TOOL
ADS1259IPW 功能描述:模數轉換器 - ADC Low-Noise 14kSPS 24B ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
ADS1259IPW 制造商:Texas Instruments 功能描述:A/D CONVERTER (A-D) IC
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*