參數資料
型號： AD9772A
廠商： Analog Devices, Inc.
英文描述： 14-Bit, 160 MSPS TxDAC+ with 2x Interpolation Filter
中文描述： 14位，160 MSPS的TxDAC系列的2倍插值濾波器
文件頁數： 8/32頁
文件大小： 596K
代理商： AD9772A
REV. A
AD9772A
–8–
DEFINITIONS OF SPECIFICATIONS
Linearity Error (Also Called Integral Nonlinearity or INL)
Linearity error is defined as the maximum deviation of the actual
analog output from the ideal output, determined by a straight
line drawn from zero to full scale.
Differential Nonlinearity (or DNL)
DNL is the measure of the variation in analog value, normalized
to full scale, associated with a 1 LSB change in digital input code.
Monotonicity
A D/A converter is monotonic if the output either increases or
remains constant as the digital input increases.
Offset Error
The deviation of the output current from the ideal of zero is
called offset error. For I
OUTA
, 0 mA output is expected when the
inputs are all 0s. For I
OUTB
, 0 mA output is expected when all
inputs are set to 1s.
Gain Error
The difference between the actual and ideal output span. The
actual span is determined by the output when all inputs are set
to 1s, minus the output when all inputs are set to 0s.
Output Compliance Range
The range of allowable voltage at the output of a current-output
DAC. Operation beyond the maximum compliance limits may
cause either output stage saturation or breakdown, resulting in
nonlinear performance.
Temperature Drift
Temperature drift is specified as the maximum change from the
ambient (25
°
C) value to the value at either T
MIN
or T
MAX
. For
offset and gain drift, the drift is reported in ppm of full-scale
range (FSR) per
°
C. For reference drift, the drift is reported in
ppm per
°
C.
Power Supply Rejection
The maximum change in the full-scale output as the supplies
are varied from minimum to maximum specified voltages.
Settling Time
The time required for the output to reach and remain within a
specified error band about its final value, measured from the
start of the output transition.
Glitch Impulse
Asymmetrical switching times in a DAC give rise to undesired
output transients that are quantified by a glitch impulse. It is
specified as the net area of the glitch in pV-s.
Spurious-Free Dynamic Range
The difference, in dB, between the rms amplitude of the output
signal and the peak spurious signal over the specified bandwidth.
Total Harmonic Distortion
THD is the ratio of the rms sum of the first six harmonic com-
ponents to the rms value of the measured fundamental. It is
expressed as a percentage or in decibels (dB).
Signal-to-Noise Ratio (SNR)
S/N is the ratio of the rms value of the measured output signal
to the rms sum of all other spectral components below the
Nyquist frequency, excluding the first six harmonics and dc.
The value for SNR is expressed in decibels.
Passband
Frequency band in which any input applied therein passes
unattenuated to the DAC output.
Stopband Rejection
The amount of attenuation of a frequency outside the passband
applied to the DAC, relative to a full-scale signal applied at the
DAC input within the passband.
Group Delay
Number of input clocks between an impulse applied at the
device input and peak DAC output current.
Impulse Response
Response of the device to an impulse applied to the input.
Adjacent Channel Power Ratio (or ACPR)
A ratio in dBc between the measured power within a channel
relative to its adjacent channel.
PLLCLOCK
MULTIPLIER
EDGE-
TRIGGERED
LATCHES
2 FIR
INTERPOLATION
FILTER
AD9772A
3.3V
3.3V
FROM HP8644A
SIGNAL GENERATOR
3.3V
CLKVDD
CLKCOM
CLK+
1
FILTER
CONTROL
MUX
CONTROL
M
M
R
P
D
D
PLLCOM
LPF
PLLVDD
I
OUTA
I
OUTB
REFIO
FSADJ
REFLO
AVDD
ACOM
DVDD
DCOM
SLEEP
ZERO
STUFF
MUX
14-BIT DAC
100
MINI-CIRCUITS
T1
–
1T
20pF
50
50
20pF
1.91k
0.1 F
+1.2V REFERENCE
AND CONTROL AMP
AWG2021
OR
DG2020
DIGITAL
DATA
EXT.
CLOCK
HP8130
PULSE GENERATOR
CH1
CH2
EXT. INPUT
2 /4
CLK
–
1k
1k
1 /2
CLOCK DISTRIBUTION
AND MODE SELECT
TO FSEA30
SPECTRUM
ANALYZER
Figure 3. Basic AC Characterization Test Setup
相關PDF資料
PDF描述
AD9772AAST 14-Bit, 160 MSPS TxDAC+ with 2x Interpolation Filter
AD9772 14-Bit,150 MSPS T×DAC+TM with 2× Interpolation Filter(單電源,過采樣,14位D/A轉換器)
AD9773 12-Bit, 160 MSPS 2】/4】/8】 Interpolating Dual TxDAC+ D/A Converter
AD9773AST 12-Bit, 160 MSPS 2】/4】/8】 Interpolating Dual TxDAC+ D/A Converter
AD9773EB 12-Bit, 160 MSPS 2】/4】/8】 Interpolating Dual TxDAC+ D/A Converter
相關代理商/技術參數
參數描述
AD9772AAST 制造商:Analog Devices 功能描述:DAC 1-CH Segment 14-bit 48-Pin LQFP 制造商:Rochester Electronics LLC 功能描述:14BIT 160 MSPS TXDAC+ W/2X INTERPOLATION - Tape and Reel 制造商:Analog Devices 功能描述:Digital-Analog Converter IC Number of Bi
AD9772AASTRL 制造商:Analog Devices 功能描述:DAC 1-CH Segment 14-bit 48-Pin LQFP T/R
AD9772AASTZ 功能描述:IC DAC 14BIT 160MSPS 48-LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:TxDAC+® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 設置時間:4µs 位數:12 數據接口:串行 轉換器數目:2 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-uMAX 包裝:管件 輸出數目和類型:2 電壓，單極 采樣率（每秒）:* 產品目錄頁面:1398 (CN2011-ZH PDF)
AD9772AASTZRL 功能描述:IC DAC 14BIT 160MSPS 48LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:TxDAC+® 產品培訓模塊:Data Converter Fundamentals DAC Architectures 標準包裝:750 系列:- 設置時間:7µs 位數:16 數據接口:并聯 轉換器數目:1 電壓電源:雙 ± 功率耗散（最大）:100mW 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-LCC（J 形引線） 供應商設備封裝:28-PLCC（11.51x11.51） 包裝:帶卷 (TR) 輸出數目和類型:1 電壓，單極；1 電壓，雙極 采樣率（每秒）:143k
AD9772A-EB 制造商:Analog Devices 功能描述:14 BIT DAC W/2X INTERPOLATION 制造商:Analog Devices 功能描述:DEV TOOLS, EVAL BD FOR AD9772A - Bulk
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*