- 您現在的位置：買賣IC網 > PDF目錄375240 > AD7870AJN (ANALOG DEVICES INC) LC2MOS Complete, 12-Bit, 100 kHz , Sampling ADC PDF資料下載
參數資料
| 型號： | AD7870AJN |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | ADC |
| 英文描述： | LC2MOS Complete, 12-Bit, 100 kHz , Sampling ADC |
| 中文描述： | 1-CH 12-BIT SUCCESSIVE APPROXIMATION ADC, SERIAL/PARALLEL ACCESS, PDIP24 |
| 封裝： | 0.300 INCH, PLASTIC, DIP-24 |
| 文件頁數： | 10/12頁 |
| 文件大小： | 250K |
| 代理商： | AD7870AJN |
AD7870A
–10–
REV. 0
Effective Number of Bits
The formula given in (1) relates the SNR to the number of bits.
Rewriting the formula, as in (2), it is possible to obtain a mea-
sure of performance expressed in effective number of bits (N).
N
=
SNR
–1.76
6.02
(2)
The effective number of bits for a device can be calculated di-
rectly from its measured SNR.
Figure 12 shows a typical plot of effective number of bits versus
frequency for an AD7870AJN, with a sampling frequency of
100 kHz. The effective number of bits typically falls between
11.7 and 11.85 corresponding to SNR figures of 72.2 dB and
73.1 dB.
Figure 12. Effective Number of Bits vs. Frequency
Harmonic Distortion
Harmonic distortion is the ratio of the rms sum of harmonics to
the fundamental. For the AD7870A, total harmonic distortion
(THD) is defined as
THD
=
20log
V
2
2
+
V
3
2
+
V
4
V
1
2
+
V
5
2
+
V
6
2
where
V
1
is the rms amplitude of the fundamental and
V
2
,
V
3
,
V
4
,
V
5
and
V
6
are the rms amplitudes of the second through the
sixth harmonic. The THD is also derived from the FFT plot of
the ADC output spectrum.
Intermodulation Distortion
With inputs consisting of sine waves at two frequencies, fa and
fb, any active device with nonlinearities will create distortion
products at sum and difference frequencies of mfa + nfb where
m, n = 0, 1, 2, 3, etc. Intermodulation terms are those for
which neither m nor n are equal to zero. For example, the sec-
ond order terms include (fa + fb) and (fa – fb), while the third
order terms include (2fa + fb), (2fa – fb), (fa + 2fb) and (fa –
2fb). Using the CCIF standard, where two input frequencies
near the top end of the input bandwidth are used, the second
and third order terms are of different significance. The second
order terms are usually distanced in frequency from the original
sine waves while the third order terms are usually at a frequency
close to the input frequencies. As a result, the second and third
order terms are specified separately. The calculation of the in-
termodulation distortion is as per the THD specification where
it is the ratio of the rms sum of the individual distortion prod-
ucts to the rms amplitude of the fundamental expressed in dBs.
In this case, the input consists of two, equal amplitude, low dis-
tortion sine waves. Figure 13 shows a typical IMD plot for the
AD7870A.
Figure 13. IMD Plot
Peak Harmonic or Spurious Noise
Peak harmonic or spurious noise is defined as the ratio of the
rms value of the next largest component in the ADC output
spectrum (up to FS/2 and excluding dc) to the rms value of the
fundamental. Normally, the value of this specification will be
determined by the largest harmonic in the spectrum, but for
parts where the harmonics are buried in the noise floor the peak
will be a noise peak.
AC Linearity Plot
When a sine wave of specified frequency is applied to the V
IN
input of the AD7870A, and several million samples are taken, a
histogram showing the frequency of occurrence of each of the
4096 ADC codes can be generated. From this histogram data it
is possible to generate an ac integral linearity plot as shown in
Figure 14. This shows very good integral linearity performance
from the AD7870A at an input frequency of 25 kHz. The ab-
sence of large spikes in the plot shows good differential linearity.
Simplified versions of the formulae used are outlined below.
INL
(
i
)
=
V
(
i
)–
V
(
o
)
V
(
fs
)–
V
(
o
)
×
4096
–
i
where
INL
(
i
) is the integral linearity at code i.
V
(
fs
) and
V
(
o
)
are the estimated full-scale and offset transitions and
V
(
i
) is the
estimated transition for the i
th
code.
相關PDF資料 |
PDF描述 |
|---|---|
| AD7874AN | LC2MOS 4-Channel, 12-Bit Simultaneous Sampling Data Acquisition System |
| AD7874AQ | LC2MOS 4-Channel, 12-Bit Simultaneous Sampling Data Acquisition System |
| AD7874AR | LC2MOS 4-Channel, 12-Bit Simultaneous Sampling Data Acquisition System |
| AD7874BN | 10-Bit, 60 MSPS ADC SE/Diff, Int/Ext Ref., program. input range w/Pwrdn and comp. to ADS822/3/5/8 28-SSOP -40 to 85 |
| AD7874BQ | 10-Bit, 60 MSPS ADC SE/Diff, Int/Ext Ref., program. input range w/Pwrdn and comp. to ADS822/3/5/8 28-SSOP -40 to 85 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7870AJNZ | 功能描述:IC ADC 12BIT SAMPLING 3V 24-DIP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| AD7870AQ | 功能描述:IC ADC 12BIT SAMPLING 3V 24-CDIP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
| AD7870BQ | 功能描述:IC ADC 12BIT SAMPLING 3V 24-CDIP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| AD7870CQ | 功能描述:IC ADC 12BIT SAMPLING 3V 24-CDIP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:250 系列:- 位數:12 采樣率（每秒）:1.8M 數據接口:并聯 轉換器數目:1 功率耗散（最大）:1.82W 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-LQFP 供應商設備封裝:48-LQFP（7x7） 包裝:管件 輸入數目和類型:2 個單端，單極 |
| AD7870JN | 功能描述:IC ADC 12BIT LC2MOS 100KHZ 24DIP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
發布緊急采購，3分鐘左右您將得到回復。