NOTE: MCR bits 2 and 3 (OP1 and OP2 outpu" />
參數資料
型號： XR17C152CM-F
廠商： Exar Corporation
文件頁數： 28/62頁
文件大?。?/td> 0K
描述： IC UART PCI BUS DUAL 100TQFP
標準包裝： 90
特點： *
通道數： 2，DUART
FIFO's： 64 字節
規程： RS485
電源電壓： 5V
帶自動流量控制功能： 是
帶IrDA 編碼器/解碼器： 是
帶故障啟動位檢測功能： 是
帶調制解調器控制功能： 是
安裝類型： 表面貼裝
封裝/外殼： 100-TQFP
供應商設備封裝： 100-TQFP（14x14）
包裝： 托盤
XR17C152
á
5V PCI BUS DUAL UART
REV. 1.2.0
34
NOTE: MCR bits 2 and 3 (OP1 and OP2 outputs) are not available in the XR17C152. They are present for 16C550
compatibility during Internal loopback, see Figure 16.
4.8
Registers
4.8.1
Receive Holding Register (RHR) - Read-Only
4.8.2
Transmit Holding Register (THR) - Write-Only
4.8.3
Baud Rate Generator Divisors (DLL and DLM) - Read/Write
The Baud Rate Generator (BRG) is a 16-bit counter that generates the data rate for the transmitter and
receiver. The baud rate is programmed through registers DLL and DLM which are only accessible when LCR
bit-7 is set to logic 1. See “Section 4.1, Programmable Baud Rate Generator” on page 24 for more detail.
4.8.4
Interrupt Enable Register (IER) - Read/Write
The Interrupt Enable Register (IER) masks the interrupts from receive data ready, transmit empty, line status
and modem status registers. These interrupts are reported in the Interrupt Status Register (ISR) register and
also encoded in INT (INT0-INT3) register in the Device Configuration Registers.
IER VERSUS RECEIVE FIFO INTERRUPT MODE OPERATION
When the receive FIFO (FCR bit-0 = a logic 1) and receive interrupts (IER BIT-0 = logic 1) are enabled, the
RHR interrupts (see ISR bits 3 and 4) status will reflect the following:
A. The receive data available interrupts are issued to the host when the FIFO has reached the programmed
trigger level. It will be cleared when the FIFO drops below the programmed trigger level.
B. FIFO level will be reflected in the ISR register when the FIFO trigger level is reached. Both the ISR register
status bit and the interrupt will be cleared when the FIFO drops below the trigger level.
C. The receive data ready bit (LSR BIT-0) is set as soon as a character is transferred from the shift register to
the receive FIFO. It is reset when the FIFO is empty.
IER VERSUS RECEIVE/TRANSMIT FIFO POLLED MODE OPERATION
When FCR BIT-0 equals a logic 1 for FIFO enable, resetting IER bits 0-3 enables the 158 in the FIFO polled
mode of operation. Since the receiver and transmitter have separate bits in the LSR either or both can be used
in the polled mode by selecting respective transmit or receive control bit(s).
A. LSR BIT-0 indicates there is data in RHR or RX FIFO.
B. LSR BIT-1 indicates an overrun error has occurred and that data in the FIFO may not be valid.
C. LSR BITS 2-4 provides the type of receive data errors encountered for the data byte in RHR, if any.
D. LSR BIT-5 indicates THR is empty.
E. LSR BIT-6 indicates when both the transmit FIFO and TSR are empty.
F.
LSR BIT-7 indicates a data error in at least one character in the RX FIFO.
1 1 0 0
XCHAR
R
Xon Det.
Indicator
Xoff Det.
Indicator
Self-clear
after read
1 1 0 0
XOFF1
W
Bit-7
Bit-6
Bit-5
Bit-4
Bit-3
Bit-2
Bit-1
Bit-0
1 1 0 1
XOFF2
W
Bit-7
Bit-6
Bit-5
Bit-4
Bit-3
Bit-2
Bit-1
Bit-0
1 1 1 0
XON1
W
Bit-7
Bit-6
Bit-5
Bit-4
Bit-3
Bit-2
Bit-1
Bit-0
1 1 1 1
XON2
W
Bit-7
Bit-6
Bit-5
Bit-4
Bit-3
Bit-2
Bit-1
Bit-0
TABLE 12: UART CHANNEL CONFIGURATION REGISTERS DESCRIPTION. SHADED BITS ARE ENABLED BY EFR BIT-4.
ADDRESS
A3-A0
REG
NAME
READ/
WRITE
BIT-7
BIT-6
BIT-5
BIT-4
BIT-3
BIT-2
BIT-1
BIT-0
COMMENT
相關PDF資料
PDF描述
VE-B73-IW-F4 CONVERTER MOD DC/DC 24V 100W
XR16L784CVTR-F IC UART FIFO 64B QUAD 64LQFP
VE-B73-IW-F2 CONVERTER MOD DC/DC 24V 100W
XR16V654IQ-F IC UART FIFO 64B QUAD 100QFP
ATMEGA644A-AUR IC MCU AVR 64K FLASH 44TQFP
相關代理商/技術參數
參數描述
XR17C152IM 制造商:EXAR 制造商全稱:EXAR 功能描述:5V PCI BUS DUAL UART
XR17C152IM-F 功能描述:UART 接口集成電路 UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
XR17C154 制造商:EXAR 制造商全稱:EXAR 功能描述:5V PCI BUS QUAD UART
XR17C154_05 制造商:EXAR 制造商全稱:EXAR 功能描述:5V PCI BUS QUAD UART
XR17C154CV 功能描述:UART 接口集成電路 UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*