- 您現在的位置：買賣IC網 > PDF目錄200645 > UPD75P116CW 4-BIT, OTPROM, MICROCONTROLLER, PDIP64 PDF資料下載
參數資料
| 型號： | UPD75P116CW |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 4-BIT, OTPROM, MICROCONTROLLER, PDIP64 |
| 封裝： | 0.750 INCH, SHRINK, PLASTIC, DIP-64 |
| 文件頁數： | 8/32頁 |
| 文件大?。?/td> | 286K |
| 代理商： | UPD75P116CW |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
16
PD75P116
TYP.
4.19
MAX.
5.0
4
5.0
10
5.0
250
UNIT
MHz
ms
MHz
ms
MHz
ns
RECOMMENDED
CIRCUIT
PARAMETER
Oscillator
frequency (fXX) *1
Oscillation
stabilization time *2
Oscillator
frequency (fXX) *1
Oscillation
stabilization time *2
X1 input
frequency (fX)
*1
X1 input
high/low level width
(tXH , tXL)
TEST CONDITIONS
VDD =
After VDD reaches 4.5 V.
MIN.
2.0
100
RESONATOR
Ceramic
resonator
Crystal
resonator
External
clock
*3
*
1.
Indicates only oscillation circuit characteristics. Refer to “AC Characteristics” for instruction execu-
tion time.
2.
Time required to stabilize oscillation after VDD reaches oscillation voltage range MIN. or STOP mode
release.
3.
When the oscillator frequency is 4.19 MHz < fXX <
– 5.0MHz, PCC = 0011 should not be selected as
instruction execution time. If PCC = 0011 is selected, 1 machine cycle becomes less than 0.95
s, with
the result that the specified MIN value of 0.95
s cannot be observed.
Note
When the system clock oscillator is used, the following points should be noted concerning wiring in the
section enclosed by dots, in order to prevent the effects of wiring capacitance, etc.
Keep the wiring as short as possible.
Do not cross any other signal lines.
Keep away from lines in which a high fluctuating current flows.
Ensure that oscillator capacitor connection points are always at the same potential as VSS. Do not
ground in a ground pattern in which a high current flows.
Do not take a signal from the oscillator.
OSCILLATION CIRCUIT CHARACTERISTICS (Ta = –40 to +85
°C, VDD = 5 V ± 10 %)
X1
X2
C2
C1
X1
X2
C2
C1
PD74HCU04
X1
X2
*3
5
相關PDF資料 |
PDF描述 |
|---|---|
| UPD780021AYCW-XXX | 8-BIT, MROM, 8.38 MHz, MICROCONTROLLER, PDIP64 |
| UPD780021AYGC-XXX-8BS | 8-BIT, MROM, 8.38 MHz, MICROCONTROLLER, PQFP64 |
| UPD780023AYCW(A)-XXX | 8-BIT, MROM, 12 MHz, MICROCONTROLLER, PDIP64 |
| UPD780032AGC-XXX-8BS-A | 8-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP64 |
| UPD78F0034BGB-8EU-A | 8-BIT, FLASH, 12 MHz, MICROCONTROLLER, PQFP64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| UPD75P3018AGC-8BT-A | 制造商:Renesas Electronics Corporation 功能描述:MCU 4BIT 75XL CISC 32KB EPROM 2.5V/3.3V/5V 80PQFP - Trays 制造商:Renesas Electronics 功能描述:75XL 6MHz Cut Tape 制造商:Renesas 功能描述:MCU 4-bit 75XL CISC 32KB EPROM 2.5V/3.3V/5V 80-Pin PQFP |
| UPD75P3018AGK-BE9 | 制造商:Renesas Electronics Corporation 功能描述: |
| UPD75P3036GC-3B9-A | 制造商:Renesas Electronics Corporation 功能描述: |
| UPD75P308GF-3B9 | 制造商:Renesas Electronics Corporation 功能描述:MCU 4-Bit 75XL CISC 8064Byte PROM 5V 80-Pin PQFP |
| UPD75P308GF-3BA | 制造商:Renesas Electronics Corporation 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。