參數資料
型號: TPS62410DRCTG4
廠商: TEXAS INSTRUMENTS INC
元件分類: 穩壓器
英文描述: 1.6 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10
封裝: 3 X 3 MM, GREEN, PLASTIC, MLF-10
文件頁數: 7/31頁
文件大小: 1240K
代理商: TPS62410DRCTG4
www.ti.com
Dynamic Voltage Positioning
V
OUT_NOM
+1%
PWMMode
medium/heavyload
PFMMode
lightload
Smooth
increasedload
PWMMode
medium/heavyload
PFMMode
lightload
Fastloadtransient
PWMMode
medium/heavyload
COMP_LOWthreshold –1%
Soft Start
95%
5%
t
RAMP
t
Startup
EN
V
OUT
SLVS737 – FEBRUARY 2007
DETAILED DESCRIPTION (continued)
Hereupon the device starts switching again. The Power Save Mode is exited and PWM Mode entered in case
the output current exceeds the current IOUT_PFM_leave, or if the output voltage falls below a second
comparator threshold, called skip comparator low (Skip Comp Low) threshold. This skip comparator low
threshold is set to –2% below nominal Vout, and enables a fast transition from Power Save Mode to PWM Mode
during a load step. In Power Save Mode the quiescent current is reduced typically to 19
A for one converter and
32
A for both converters active. This single skip comparator threshold method in Power Save Mode results in a
very low output voltage ripple. The ripple depends on the comparator delay and the size of the output capacitor.
Increasing output capacitor values minimizes the output ripple. The Power Save Mode can be disabled through
the MODE/DATA pin set to high. Both converters then operate in fixed PWM mode. Power Save Mode
Enable/Disable applies to both converters.
This feature reduces the voltage under/overshoots at load steps from light to heavy load and vice versa. It is
activated in Power Save Mode operation. It provides more headroom for both the voltage drop at a load step,
and the voltage increase at a load throw-off. This improves load transient behavior.
At light loads, in which the converter operate in PFM Mode, the output voltage is regulated typically 1% higher
than the nominal value. In case of a load transient from light load to heavy load, the output voltage drops until it
reaches the skip comparator low threshold set to –2% below the nominal value and enters PWM mode. During a
load throw off from heavy load to light load, the voltage overshoot is also minimized due to active regulation
turning on the N-channel switch.
Figure 25. Dynamic Voltage Positioning
The two converters have an internal soft start circuit that limits the inrush current during start-up. During soft
start, the output voltage ramp up is controlled as shown in Figure 26.
Figure 26. Soft Start
15
相關PDF資料
PDF描述
TPS62420DRCT 1.61 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10
TPS62420DRC 1.61 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10
TPS62421DRCR 1.61 A DUAL SWITCHING CONTROLLER, 2500 kHz SWITCHING FREQ-MAX, PDSO10
TPS62510DRCRG4 1.5 A SWITCHING REGULATOR, 1700 kHz SWITCHING FREQ-MAX, PDSO10
TPS62510DRCT 1.5 A SWITCHING REGULATOR, 1700 kHz SWITCHING FREQ-MAX, PDSO10
相關代理商/技術參數
參數描述
TPS62410Q1-EVM 功能描述:EVALUATION MODULE 制造商:texas instruments 系列:* 零件狀態:在售 標準包裝:1
TPS62410QDRCRQ1 功能描述:直流/直流開關轉換器 2.25MHZ 2x800mA Dual Step-Down Converter RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT
TPS62420DRCR 功能描述:直流/直流開關調節器 Dual Adj 600mA & 1000mA 2.25MHz RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS62420DRCRG4 功能描述:直流/直流開關調節器 Dual Adj 600mA & 1000mA 2.25MHz RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS62420DRCT 功能描述:直流/直流開關調節器 Dual Adj 600mA & 1000mA 2.25MHz RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5