- 您現在的位置：買賣IC網 > PDF目錄384027 > TPS61170DRV (Texas Instruments, Inc.) 1.2A High Voltage Boost Converter in 2x2mm2 QFN Package PDF資料下載
參數資料
| 型號： | TPS61170DRV |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | 1.2A High Voltage Boost Converter in 2x2mm2 QFN Package |
| 中文描述： | 1.2A的高電壓升壓轉換器2x2mm2 QFN封裝 |
| 文件頁數： | 12/22頁 |
| 文件大小： | 405K |
| 代理商： | TPS61170DRV |
www.ti.com
Low Bit
(Logic 0)
High Bit
(Logic 1)
t
Low
t
High
t
LOW
t
High
Easy Scale Timing, without acknowledge RFA = 0
DA7
0
t
Start
Static High
Static High
DATA IN
t
Start
T
EOS
T
EOS
DA0
0
RFA
0
D0
1
Address Byte
DATA Byte
Easy Scale Timing, with acknowledge RFA = 1
Static High
t
ACKN
Acknowledge
true
, Data Line
pulled down by
device
DATA IN
DATA OUT
Acknowledge
false
, no pull
down
Controller needs to
Pullup Data Line via a
resistor to detect ACKN
ACKN
DA7
0
Static High
T
EOS
t
valACK
DA0
0
RFA
1
D0
1
t
Start
t
Start
Address Byte
DATA Byte
TPS61170
SLVS789–NOVEMBER 2007
Table 2. EasyScale Bit Description (continued)
BIT
TRANSMISSION
DIRECTION
BYTE
NAME
DESCRIPTION
NUMBER
Acknowledge condition active 0, this condition will only be applied in case RFA bit is
set. Open drain output, Line needs to be pulled high by the host with a pullup
resistor. This feature can only be used if the master has an open drain output stage.
In case of a push pull output stage Acknowledge condition may not be requested!
ACK
OUT
Figure 16. EasyScale — Bit Coding
All bits are transmitted MSB first and LSB last.
Figure 16
shows the protocol without acknowledge request (Bit
RFA = 0),
Figure 16
with acknowledge (Bit RFA = 1) request. Prior to both bytes, device address byte and data
byte, a start condition must be applied. For this, the CTRL pin must be pulled high for at least t
start
(2
μ
s) before
the bit transmission starts with the falling edge. If the CTRL pin is already at high level, no start condition is
needed prior to the device address byte. The transmission of each byte is closed with an End of Stream
condition for at least t
EOS
(2
μ
s).
12
Submit Documentation Feedback
Copyright 2007, Texas Instruments Incorporated
Product Folder Link(s):
TPS61170
相關PDF資料 |
PDF描述 |
|---|---|
| TPS62046EVM | 1.2-A High-Efficiency Step-Down Converters Evaluation Module(1.2A高效率降壓轉換器TPS62046評估模塊) |
| TPS62040EVM | 1.2-A High-Efficiency Step-Down Converters Evaluation Module(1.2A高效率降壓轉換器TPS62040評估模塊) |
| TPS62205DBV | HIGH-EFFICIENCY, SOT23 STEP-DOWN, DC-DC CONVERTER |
| TPS62207DBV | HIGH-EFFICIENCY, SOT23 STEP-DOWN, DC-DC CONVERTER |
| TPS62208DBV | HIGH-EFFICIENCY, SOT23 STEP-DOWN, DC-DC CONVERTER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS61170DRVR | 功能描述:直流/直流開關調節器 1.2A Sw Hi Vltg Boost Conv RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS61170DRVRG4 | 功能描述:直流/直流開關調節器 1.2A Sw Hi Vltg Boost Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS61170DRVT | 功能描述:直流/直流開關調節器 1.2A Sw Hi Vltg Boost Conv RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS61170DRVT | 制造商:Texas Instruments 功能描述:Voltage Regulators |
| TPS61170DRVTG4 | 功能描述:直流/直流開關調節器 1.2A Sw Hi Vltg Boost Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
發布緊急采購，3分鐘左右您將得到回復。