- 您現在的位置：買賣IC網 > PDF目錄384010 > TLV5580PW (Texas Instruments, Inc.) 8-BIT, 80 MSPS LOW-POWER A/D CONVERTER PDF資料下載
參數資料
| 型號： | TLV5580PW |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | 8-BIT, 80 MSPS LOW-POWER A/D CONVERTER |
| 中文描述： | 8位，80 MSPS的低功耗A / D轉換器 |
| 文件頁數： | 17/34頁 |
| 文件大小： | 531K |
| 代理商： | TLV5580PW |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
TLV5580
8-BIT, 80 MSPS LOW-POWER A/D CONVERTER
SLAS205A – DECEMBER 1998 – REVISED JANUARY 1999
17
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
PRINCIPLE OF OPERATION
digital outputs
The output of TLV5580 is a standard binary code. Capacitive loading on the output should be kept as low as
possible (a maximum loading of 10 pF is recommended) to provide best performance. Higher output loading
causes higher dynamic output currents and can increase noise coupling into the device’s analog front end. To
drive higher loads, use an output buffer is recommended.
When clocking output data from TLV5580, it is important to observe its timing relation to CLK. Pipeline ADC
delay is 4.5 clock cycles to which the maximum output propagation delay is added. See Note 6 in the
specification section for more details.
layout, decoupling and grounding rules
It is necessary for any PCB using the TLV5580 to have proper grounding and layout to achieve the stated
performance. Separate analog and digital ground planes that are spliced underneath the device are advisable.
TLV5580 has digital and analog terminals on opposite sides of the package to make proper grounding easier.
Since there is no internal connection between analog and digital grounds, they have to be joined on the PCB.
Joining the digital and analog grounds at a point in close proximity to the TLV5580 is advised.
As for power supplies, separate analog and digital supply terminals are provided on the device (AV
DD
/DV
DD
).
The supply to the digital output drivers is kept separate also (DRV
DD
). Lowering the voltage on this supply from
the nominal 3.3 V to 3 V improves performance because of the lower switching noise caused by the output
buffers.
Due to the high sampling rate and switched-capacitor architecture, TLV5580 generates transients on the supply
and reference lines. Proper decoupling of these lines is essential. Decoupling as shown in the schematic of the
TLV5580 EVM is recommended.
相關PDF資料 |
PDF描述 |
|---|---|
| TLV5592 | 2-BIT ANALOG-TO-DIGITAL CONVERTER FOR FLEX PAGER CHIPSET |
| TLV5592D | 2-BIT ANALOG-TO-DIGITAL CONVERTER FOR FLEX PAGER CHIPSET |
| TLV5604D | 2.7-V TO 5.5-V 10-BIT 3-mS QUADRUPLE DIGITAL-TO-ANALOG CONVERTERS WITH POWER DOWN |
| TLV5604PW | 2.7-V TO 5.5-V 10-BIT 3-mS QUADRUPLE DIGITAL-TO-ANALOG CONVERTERS WITH POWER DOWN |
| TLV5606D | 2.7 V TO 5.5 V LOW POWER 10-BIT DIGITAL-TO-ANALOG CONVERTERS WITH POWER DOWN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLV5590 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:2-BIT ANALOG-TO-DIGITAL CONVERTER FOR FLEX |
| TLV5590ED | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| TLV5590EDR | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| TLV5590EPWR | 制造商:Texas Instruments 功能描述: |
| TLV5591 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:SEMICONDUCTOR SIGNAL PROCESSOR |
發布緊急采購，3分鐘左右您將得到回復。