- 您現在的位置：買賣IC網 > PDF目錄98148 > STMPE2401TBR (STMICROELECTRONICS) 24 I/O, PIA-GENERAL PURPOSE, PBGA36 PDF資料下載
參數資料
| 型號： | STMPE2401TBR |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 24 I/O, PIA-GENERAL PURPOSE, PBGA36 |
| 封裝： | LEAD FREE, TFBGA-36 |
| 文件頁數： | 14/55頁 |
| 文件大?。?/td> | 959K |
| 代理商： | STMPE2401TBR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁
STMPE2401
Clocking system
21/55
8
Clocking system
Figure 6.
Clocking system
The decision on clocks is based on the bits written into SYSCON registers. Bits 0 to 4 of the
SYSCON register control the gating of clocks to the Rotator, Keypad Controller, PWM and
GPIO respectively in the operational mode. When in sleep mode, the operating clock is cut
off from every functional blocks (including the I2C) except Keypad Controller and GPIO.
8.1
Programming sequence
To put the device in sleep mode, the following needs to be done by the host:
1.
Write a ‘1’ to bit 4 of the SYSCON register.
2.
To wakeup the device, the following needs to be done by the host:
3.
Assert a wakeup routine on the I2C bus by sending the Start Bit, followed by the device
address and the R/W bit.
4.
If there’s a NOACK, keep sending the wakeup routine till there is an ACK from the
slave.
5.
To do a soft reset to the device, the host needs to do the following:
6.
Write a ‘1’ to bit 7 of the SYSCON register.
7.
This bit is automatically cleared upon reset.
8.
To go into Hibernate mode, the following needs to be done by the host:
9.
Set the Disable_32K bit to ‘1’
10. To come out of the Hibernate mode, the following needs to be done by the host:
11. Assert a system reset or
12. Put a wakeup on the I2C
相關PDF資料 |
PDF描述 |
|---|---|
| STMPE801MTR | 8 I/O, PIA-GENERAL PURPOSE, PDSO16 |
| STMPS2262MTR | 4 I/O, PIA-GENERAL PURPOSE, PDSO8 |
| STN8810B2S12HPI | 32-BIT, 264 MHz, RISC PROCESSOR, PBGA26 |
| STN8810BES12HPBE | 32-BIT, 264 MHz, RISC PROCESSOR, PBGA26 |
| STP1012PGA-110 | 32-BIT, 110 MHz, RISC PROCESSOR, CPGA321 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| STMPE2403 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:24-bit Enhanced port expander with Keypad and PWM controller Xpander logic |
| STMPE2403TBR | 功能描述:接口 - 專用 24-bit Enhanced RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59 |
| STMPE24M31QTR | 功能描述:電容觸摸傳感器 S-Touch 24 Cap Sens 15fF 512 Steps 30pF RoHS:否 制造商:Microchip Technology 電源電壓: 通道數量: 封裝 / 箱體: 尺寸: 溫度范圍: |
| STMPE321 | 制造商:STMicroelectronics 功能描述:3-channel touchkey controller |
| STMPE321QTR | 功能描述:觸摸屏轉換器和控制器 3-channel CAP Touch Key Controller RoHS:否 制造商:Microchip Technology 類型:Resistive Touch Controllers 輸入類型:3 Key 數據速率:140 SPS 分辨率:10 bit 接口類型:4-Wire, 5-Wire, 8-Wire, I2C, SPI 電源電壓:2.5 V to 5.25 V 電源電流:17 mA 工作溫度:- 40 C to + 85 C 封裝 / 箱體:SSOP-20 |
發布緊急采購，3分鐘左右您將得到回復。