參數資料
型號: STM32F103VEH6
廠商: STMICROELECTRONICS
元件分類: 微控制器/微處理器
英文描述: 32-BIT, FLASH, 72 MHz, RISC MICROCONTROLLER, PBGA100
封裝: 10 X 10 MM, 0.50 MM PITCH, ROHS COMPLIANT, LFBGA-100
文件頁數: 23/115頁
文件大小: 1225K
代理商: STM32F103VEH6
STM32F103xC, STM32F103xD, STM32F103xE
Description
2.3.10
Boot modes
At startup, boot pins are used to select one of three boot options:
Boot from User Flash
Boot from System Memory
Boot from embedded SRAM
The boot loader is located in System Memory. It is used to reprogram the Flash memory by
using USART1.
2.3.11
Power supply schemes
VDD = 2.0 to 3.6 V: external power supply for I/Os and the internal regulator.
Provided externally through VDD pins.
VSSA, VDDA = 2.0 to 3.6 V: external analog power supplies for ADC, Reset blocks, RCs
and PLL (minimum voltage to be applied to VDDA is 2.4 V when the ADC is used). VDDA
and VSSA must be connected to VDD and VSS, respectively.
VBAT = 1.8 to 3.6 V: power supply for RTC, external clock 32 kHz oscillator and backup
registers (through power switch) when VDD is not present.
For more details on how to connect power pins, refer to Figure 11: Power supply scheme.
2.3.12
Power supply supervisor
The device has an integrated power-on reset (POR)/power-down reset (PDR) circuitry. It is
always active, and ensures proper operation starting from/down to 2 V. The device remains
in reset mode when VDD is below a specified threshold, VPOR/PDR, without the need for an
external reset circuit.
The device features an embedded programmable voltage detector (PVD) that monitors the
VDD/VDDA power supply and compares it to the VPVD threshold. An interrupt can be
generated when VDD/VDDA drops below the VPVD threshold and/or when VDD/VDDA is higher
than the VPVD threshold. The interrupt service routine can then generate a warning
message and/or put the MCU into a safe state. The PVD is enabled by software. Refer to
VPOR/PDR and VPVD.
2.3.13
Voltage regulator
The regulator has three operation modes: main (MR), low power (LPR) and power down.
MR is used in the nominal regulation mode (Run)
LPR is used in the Stop modes.
Power down is used in Standby mode: the regulator output is in high impedance: the
kernel circuitry is powered down, inducing zero consumption (but the contents of the
registers and SRAM are lost)
This regulator is always enabled after reset. It is disabled in Standby mode.
相關PDF資料
PDF描述
STM32F103RDH7TR 32-BIT, FLASH, 72 MHz, RISC MICROCONTROLLER, PBGA64
STM32F103RCH6TR 32-BIT, FLASH, 72 MHz, RISC MICROCONTROLLER, PBGA64
STM32F103RCT7 32-BIT, FLASH, 72 MHz, RISC MICROCONTROLLER, PQFP64
STM32F103T6U6AXX 32-BIT, FLASH, 72 MHz, RISC MICROCONTROLLER, PQCC36
STM32W108CBU62 SPECIALTY MICROPROCESSOR CIRCUIT, QCC48
相關代理商/技術參數
參數描述
STM32F103VEH6TR 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:High-density performance line ARM-based 32-bit MCU with 256 to 512KB Flash, USB, CAN, 11 timers, 3 ADCs, 13 communication interfaces
STM32F103VEH6XXX 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:High-density performance line ARM-based 32-bit MCU with 256 to 512KB Flash, USB, CAN, 11 timers, 3 ADCs, 13 communication interfaces
STM32F103VEH7 功能描述:ARM微控制器 - MCU 32BIT Cortex M3 H/D Perf Line USB CAN RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
STM32F103VEH7TR 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:High-density performance line ARM-based 32-bit MCU with 256 to 512KB Flash, USB, CAN, 11 timers, 3 ADCs, 13 communication interfaces
STM32F103VEH7XXX 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:High-density performance line ARM-based 32-bit MCU with 256 to 512KB Flash, USB, CAN, 11 timers, 3 ADCs, 13 communication interfaces