參數資料
型號： SC68C752B
廠商： NXP Semiconductors N.V.
英文描述： 5 V, 3.3 V and 2.5 V dual UART, 5 Mbit/s (max.), with 64-byte FIFOs and Motorola mP interface
中文描述： 5伏，3.3伏和2.5伏兆5雙UART /秒（最大），64字節的FIFO和摩托羅拉手機接口
文件頁數： 9/46頁
文件大?。?/td> 219K
代理商： SC68C752B
9397 750 14963
Koninklijke Philips Electronics N.V. 2005. All rights reserved.
Product data sheet
Rev. 02 — 28 April 2005
9 of 46
Philips Semiconductors
SC68C752B
5 V, 3.3 V and 2.5 V dual UART, 5 Mbit/s (max.), with 64-byte FIFOs
6.2.2
Auto-CTS
The transmitter circuitry checks CTS before sending the next data byte. When CTS is
active, the transmitter sends the next byte. To stop the transmitter from sending the
following byte, CTS must be de-asserted before the middle of the last stop bit that is
currently being sent. The Auto-CTS function reduces interrupts to the host system. When
flow control is enabled, CTS level changes do not trigger host interrupts because the
device automatically controls its own transmitter. Without Auto-CTS, the transmitter sends
any data present in the transmit FIFO and a receiver overrun error may result.
6.3 Software flow control
Software flow control is enabled through the enhanced feature register and the modem
control register. Different combinations of software flow control can be enabled by setting
different combinations of EFR[3:0].
Table 4
shows software flow control options.
(1) When CTS is LOW, the transmitter keeps sending serial data out.
(2) When CTS goes HIGH before the middle of the last stop bit of the current byte, the transmitter finishes sending the current
byte, but is does not send the next byte.
(3) When CTS goes from HIGH to LOW, the transmitter begins sending data again.
Fig 5.
CTS functional timing
Start
byte 0 to 7
Stop
TX
CTS
002aaa227
Start
byte 0 to 7
Stop
Table 4:
EFR[3]
0
1
0
1
X
X
X
1
Software flow control options (EFR[0:3])
EFR[2]
EFR[1]
0
X
0
X
1
X
1
X
X
0
X
1
X
0
0
1
EFR[0]
X
X
X
X
0
0
1
1
TX, RX software flow controls
no transmit flow control
transmit Xon1, Xoff1
transmit Xon2, Xoff2
transmit Xon1, Xon2, Xoff1, Xoff2
no receive flow control
receiver compared Xon1, Xoff1
receiver compares Xon2, Xoff2
transmit Xon1, Xoff1
receiver compares Xon1 and Xon2, Xoff1 and Xoff2
transmit Xon2, Xoff2
receiver compares Xon1 and Xon2, Xoff1 and Xoff2
transmit Xon1, Xon2, Xoff1, Xoff2
receiver compares Xon1 and Xon2, Xoff1 and Xoff2
0
1
1
1
1
1
1
1
相關PDF資料
PDF描述
SCAN182245AMTD Non-Inverting Transceiver with 25ohm Series Resistor Outputs
SCAN18245TSSC Non-Inverting Transceiver with 3-STATE Outputs
SCAN18374T D-Type Flip-Flop with 3-STATE Outputs
SCAN18374TSSC D-Type Flip-Flop with 3-STATE Outputs
SCAN18540TSSC Inverting Line Driver with 3-STATE Outputs
相關代理商/技術參數
參數描述
SC68C752BIB48 功能描述:UART 接口集成電路 2.5V-5V 2CH UART 64B FIFO MOT RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC68C752BIB48,128 功能描述:UART 接口集成電路 2.5V-5V 2CH UART 64B RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC68C752BIB48,151 功能描述:UART 接口集成電路 UART DUAL W/FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC68C752BIB48,157 功能描述:UART 接口集成電路 2.5V-5V 2CH UART 64B RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC68C752BIB48-F 功能描述:UART 接口集成電路 2.5V-5V 2CH UART 64B FIFO MOT RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*