參數資料
型號: SAK-C167SR-LM
廠商: SIEMENS A G
元件分類: 微控制器/微處理器
英文描述: 16-Bit CMOS Single-Chip Microcontroller
中文描述: MICROCONTROLLER, MQFP144
文件頁數: 37/80頁
文件大小: 1151K
代理商: SAK-C167SR-LM
C167CS-4R
C167CS-L
Data Sheet
33
V2.0, 2000-06
Parallel Ports
The C167CS provides up to 111 I/O lines which are organized into eight input/output
ports and one input port. All port lines are bit-addressable, and all input/output lines are
individually (bit-wise) programmable as inputs or outputs via direction registers. The I/O
ports are true bidirectional ports which are switched to high impedance state when
configured as inputs. The output drivers of five I/O ports can be configured (pin by pin)
for push/pull operation or open-drain operation via control registers. During the internal
reset, all port pins are configured as inputs.
The input threshold of Port 2, Port 3, Port 7, and Port 8 is selectable (TTL or CMOS like),
where the special CMOS like input threshold reduces noise sensitivity due to the input
hysteresis. The input threshold may be selected individually for each byte of the
respective ports.
All port lines have programmable alternate input or output functions associated with
them. All port lines that are not used for these alternate functions may be used as general
purpose IO lines.
PORT0 and PORT1 may be used as address and data lines when accessing external
memory, while Port 4 outputs the additional segment address bits A23/19/17
… A16 in
systems where segmentation is enabled to access more than 64 KBytes of memory.
Port 2, Port 8 and Port 7 (and parts of PORT1) are associated with the capture inputs or
compare outputs of the CAPCOM units and/or with the outputs of the PWM module.
Port 6 provides optional bus arbitration signals (BREQ, HLDA, HOLD) and chip select
signals.
Port 3 includes alternate functions of timers, serial interfaces, the optional bus control
signal BHE, and the system clock output CLKOUT (or the programmable frequency
output FOUT).
Port 5 (and parts of PORT1) is used for the analog input channels to the A/D converter
or timer control signals.
The edge characteristics (transition time) and driver characteristics (output current) of
the C167CS’s port drivers can be selected via the Port Output Control registers
(POCONx).
相關PDF資料
PDF描述
SAB-C167CR-LM 16-Bit CMOS Single-Chip Microcontroller
SAB-C167SR-LM 16-Bit CMOS Single-Chip Microcontroller
SAK-C505L 8-bit CMOS Microcontroller
SAF-C505L-4EM 8-bit CMOS Microcontroller
SAB-C505 8-bit CMOS Microcontroller
相關代理商/技術參數
參數描述
SAK-C167SR-LM HA+ 功能描述:16位微控制器 - MCU MICROCONTROLLER 16-BIT RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
SAK-C167SR-LM HA+ TR 制造商:Infineon Technologies AG 功能描述:
SAK-C167SR-LMHA+ 制造商:Infineon Technologies AG 功能描述: 制造商:Rochester Electronics LLC 功能描述:
SAKC167SRLMHA+X 制造商:Infineon Technologies AG 功能描述:MCU 16-Bit C166 CISC/RISC ROMLess 5V 144-Pin MQFP
SAKC167SRLMHA+XT 制造商:Infineon Technologies AG 功能描述:MCU 16-Bit C166 CISC/RISC ROMLess 5V 144-Pin MQFP