參數資料
型號: SAB-C161JC-32RF
廠商: INFINEON TECHNOLOGIES AG
英文描述: 16-Bit Single-Chip Microcontroller
中文描述: 16位單片機
文件頁數: 38/89頁
文件大?。?/td> 876K
代理商: SAB-C161JC-32RF
C161CS/JC/JI-32R
C161CS/JC/JI-L
Data Sheet
34
V3.0, 2001-01
Parallel Ports
The C161CS/JC/JI provides up to 93 I/O lines which are organized into eight input/output
ports and one input port. All port lines are bit-addressable, and all input/output lines are
individually (bit-wise) programmable as inputs or outputs via direction registers. The I/O
ports are true bidirectional ports which are switched to high impedance state when
configured as inputs. The output drivers of five I/O ports can be configured (pin by pin)
for push/pull operation or open-drain operation via control registers, Port 9 provides
open-drain-only drivers. During the internal reset, all port pins are configured as inputs.
The input threshold of Port 2, Port 3, Port 4, Port 6, and Port 7 is selectable (TTL or
CMOS like), where the special CMOS like input threshold reduces noise sensitivity due
to the input hysteresis. The input threshold may be selected individually for each byte of
the respective ports.
All port lines have programmable alternate input or output functions associated with
them. All port lines that are not used for these alternate functions may be used as
general purpose IO lines.
PORT0 and PORT1 may be used as address and data lines when accessing external
memory, while Port 4 outputs the additional segment address bits A23/19/17 … A16 in
systems where segmentation is enabled to access more than 64 KBytes of memory.
Port 2, Port 7, and parts of PORT1 are associated with the capture inputs or compare
outputs of the CAPCOM units.
Port 6 provides optional bus arbitration signals (BREQ, HLDA, HOLD) and chip select
signals.
Port 3 includes alternate functions of timers, serial interfaces, the optional bus control
signal BHE, and the system clock output CLKOUT (or the programmable frequency
output FOUT).
Port 5 is used for the analog input channels to the A/D converter or timer control signals.
The edge characteristics (transition time) and driver characteristics (output current) of
the C161CS/JC/JI’s port drivers can be selected via the Port Output Control registers
(POCONx).
相關PDF資料
PDF描述
SAB-C161JC-LF 16-Bit Single-Chip Microcontroller
SAB-C161JI-32RF 16-Bit Single-Chip Microcontroller
SAB-C161JI-LF 16-Bit Single-Chip Microcontroller
SAK-C161CS-32RF 16-Bit Single-Chip Microcontroller
SAK-C161CS-LF 16-Bit Single-Chip Microcontroller
相關代理商/技術參數
參數描述
SAB-C161JC-LF 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16-Bit Single-Chip Microcontroller
SAB-C161JC-LF CA 功能描述:16位微控制器 - MCU 16BIT ROM/ROMLESS RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
SAB-C161JC-LFCA 制造商:Infineon Technologies AG 功能描述:
SAB-C161JI-32RF 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16-Bit Single-Chip Microcontroller
SAB-C161JI-LF 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16-Bit Single-Chip Microcontroller