參數資料
型號: PCM9211PT
廠商: TEXAS INSTRUMENTS INC
元件分類: 網絡接口
英文描述: DATACOM, TOKEN RING TRANSCEIVER, PQFP48
封裝: GREEN, PLASTIC, LQFP-48
文件頁數: 43/121頁
文件大?。?/td> 1219K
代理商: PCM9211PT
C2
C1
R1
FILT
AGND
DGND
Charge
Pump
VCO
PCM9211
PLLSection
SBAS495 – JUNE 2010
www.ti.com
DIR and PLL Loop Filter Details
The PCM9211 incorporates a PLL for generating clocks synchronized with the input biphase signal (S/PDIF).
The onboard PLL requires an external loop filter. The components and configuration shown in Figure 20 and
Table 6 are recommended for optimal performance, with these considerations:
The resistor and capacitors that configure the filter should be located and routed as close as possible to the
PCM9211. The external loop filter must be placed on the FILT pins.
The GND node of the external loop filter must be directly connected with AGND pin of the PCM9211; it must
be not combined with other signals.
Figure 20 shows the configuration of the external loop filter and the connection with the PCM9211.
Figure 20. Loop Filter Connection
The recommended value of loop filter components is shown in Table 6.
Table 6. Recommended Value of Loop Filter Components
REF. NO.
RECOMMENDED VALUE
TYPE
TOLERANCE
R1
680
Ω
Metal film or carbon
≤ 5%
C1
0.068 F
Film or ceramic (CH or C0G)
≤ 5%
C2
0.0047 F
Film or ceramic (CH or C0G)
≤ 5%
External (XTI) Clocks, Oscillators, and Supporting Circuitry
An external clock source (CMOS or crystal/resonator) is known as the XTI source. The XTI source can be either
a CMOS logic source, or a crystal resonator (internal circuitry in the PCM9211 can start the crystal resonating).
Whichever clock source is used, it must be 24.576 MHz.
The PCM9211 uses the XTI source as a reference clock in order to calculate the sampling frequency of the
incoming S/PDIF stream. It is also used as the clock source in XTI clock source mode.
When using a resonator as an XTI source, the following points should be considered:
The 24.576-MHz resonator should be connected between the XTI and XTO pins
The resonator should be a fundamental mode type
A crystal or ceramic resonator can be used as the XTI source
The values of the load capacitors CL1 and CL2 and the current limiting resistor Rd all depend on the
characteristics of the resonator
No external feedback resistor between the XTI and XTO pins is required, because the resistor is integrated
into the device
No loads other than the resonator should be used on the XTO pin
When using an external oscillation circuit with a CMOS output, the following points should be considered:
Always supply a 24.576-MHz clock on the XTI pin
Only 3.3 V is supported on the XTI pin; 5 V is not supported
XTO should be left floating
28
Copyright 2010, Texas Instruments Incorporated
Product Folder Link(s): PCM9211
相關PDF資料
PDF描述
PCN11MF STRIP TERMINAL BLOCK, 1 DECK
PCN12E-32S-2.54DSA 32 CONTACT(S), FEMALE, STRAIGHT TWO PART EURO CONNECTOR, SOLDER, SOCKET
PCN12E-44S-2.54DSA 44 CONTACT(S), FEMALE, STRAIGHT TWO PART EURO CONNECTOR, SOLDER, SOCKET
PCN12E-50S-2.54DSA 50 CONTACT(S), FEMALE, STRAIGHT TWO PART EURO CONNECTOR, SOLDER, SOCKET
PCR-E68LMD 68 CONTACT(S), MALE, RIGHT ANGLE TELECOM AND DATACOM CONNECTOR, SOLDER
相關代理商/技術參數
參數描述
PCM9211PTR 功能描述:音頻發送器、接收器、收發器 216kHz Dig Aud Inter face Transceiver RoHS:否 制造商:Cirrus Logic 工作電源電壓:3.3 V, 5 V 電源電流:11.8 mA 通道數量:1 最大工作溫度:+ 70 C 接口類型:I2C, SPI 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-28 封裝:
PCM-93 功能描述:電線鑒定 Pre-Printed WM Card, Vinyl Cloth, .22" W RoHS:否 制造商:TE Connectivity / Q-Cees 產品:Labels and Signs 類型: 材料:Vinyl 顏色:Blue 寬度:0.625 in 長度:1 in
PCM-9342 制造商:ADVANTECH 制造商全稱:Advantech Co., Ltd. 功能描述:X86 SoC 3.5" SBC with VGA, LCD, LAN, USB, SATA, CF, PC/104
PCM-9342F-64A1E 制造商:ADVANTECH 制造商全稱:Advantech Co., Ltd. 功能描述:X86 SoC 3.5" SBC with VGA, LCD, LAN, USB, SATA, CF, PC/104
PCM-9342FZ2-64A1E 制造商:ADVANTECH 制造商全稱:Advantech Co., Ltd. 功能描述:X86 SoC 3.5" SBC with VGA, LCD, LAN, USB, SATA, CF, PC/104