- 您現在的位置：買賣IC網 > PDF目錄1956 > NCP1094MNRG (ON Semiconductor)IC INTERFACE CTLR POE-PD 10-DFN PDF資料下載
參數資料
| 型號： | NCP1094MNRG |
| 廠商： | ON Semiconductor |
| 文件頁數： | 11/12頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC INTERFACE CTLR POE-PD 10-DFN |
| 標準包裝： | 1 |
| 系列： | HIPO™ |
| 控制器類型： | PoE-PD 接口 |
| 接口： | IEEE 802.3af |
| 電流 - 電源： | 500mA |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-VFDFN 裸露焊盤 |
| 供應商設備封裝： | 10-DFN-EP（3x3） |
| 包裝： | 標準包裝 |
| 其它名稱： | NCP1094MNRGOSDKR |
NCP1093, NCP1094
http://onsemi.com
8
Example for a Targeted Uvlo_on of 35 V:
Let’s start with a Rdet of 30.1 k
Ω. This gives a Ruvlo of
144 k
Ω made with a Ruvlo2 of 4.99 kΩ and a Ruvlo1 of
140 k
Ω (closest values from E96 series). Note that there is
a pull down current of 2.5
mA typ on the UVLO. Assuming
the previous example, this pull down current will create a
(non critical) systematic offset of 350 mV on the Uvlon_on
level of 35 V.
The external UVLO hysteresis on the NCP1093 is about
15 percent typical.
Inrush and Operational Current Limitations
Both inrush and operational current limit are defined by
an external Rinrush resistor connected between INRUSH
and VPORTN. The low inrush current limit allows smooth
charge of large dcdc converter input capacitor by limiting
the power dissipation over the internal pass switch. In power
mode, the operational current limit protects the pass switch
and the PD application against excessive transient current
and failure on the dcdc converter output.
Once the input supply reached the Vulvo_on level, the
charge of Cpd capacitor starts with a current limitation set to
to the INRUSH level. When this capacitor is fully charged,
the current limit switches without any spikes from the inrush
current to the operational current level and the power good
indicator on PGOOD pin is turned on. The capacitor is
considered to be fully charged once the following conditions
are satisfied:
1. The drainsource voltage of the Pass Switch has
decreased below the Vds_pgood_on level (typical
1V)
2. The gatesource voltage of the Pass Switch is
sufficiently high (above 2 V typical) which means
the current in the pass switch has decreased below
the current limit.
This mechanism is depicted in the following Figure 7.
Operational current limit
VPORTNx
Pass Switch
Inrush current limit
RTN
0
1
VDDA1
1 V / 10 V
2 V
Delay
&
detector
PGOOD
Pgood_on
VDDA1
RTN
Pgood_on
Sense Resistor
Vds_pgood comparator
Vgs_pgood comparator
Figure 7. Inrush and Operational Current Limitation Selection Mechanism
100 mS
The operational current limit and the power good
indicator stays active as long as RTN voltage stays below the
vds_pgood_off threshold (10 V typical) and the input supply
stay above the Vulvo_off level. Therefore, fast and large
voltage step lower than 10 V are tolerated on the input
without interruption of the converter controller. Higher
input transient will not affect the behavior if RTN does not
exceed 10 V for more than 100
mS. Such input voltage steps
may be introduced by a PSE which is switched to a higher
power supply. In case RTN is still above 10 V after this delay,
the power good is turned off and the pass switch current limit
falls back to the inrush level.
PGOOD Indicator
The NCP1093/94 integrate a Power Good indicator
circuitry indicating the end of the dcdc converter input
capacitor charge, and the enabling of the operational current
limit. This indicator is implemented on the PGOOD pin
which goes in open drain state when active and which is
pulled to ground during turn off.
A possible usage of this PGOOD pin is illustrated in
Figure 8. During the inrush phase, the converter controller
is forced in standby mode due to the PGOOD pin forcing low
the under voltage lock out pin of the controller. Once the Cpd
capacitor is fully charged, PGOOD goes in open drain state,
allowing the start up sequence of the converter controller.
相關PDF資料 |
PDF描述 |
|---|---|
| NCS36000DG | IC PIR DETECTOR CTLR 14SOIC |
| NCS6415DWR2G | IC VIDEO SWITCH 8X6 20SOIC |
| NCS6416DWR2G | IC VIDEO SWITCH 8X6 20SOIC |
| NCS6433DTBR2G | IC VIDEO SW QUAD 2:1 16-TSSOP |
| NCV1124DG | IC SENSOR DUAL VAR-RELUCT 8-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NCP1117 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:1.0 A Low-Dropout Positive Fixed and Adjustable Voltage Regulators |
| NCP1117/D | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:1.0A Low-Dropout Positive Fixed & Adjustable Voltage Regulators |
| NCP1117_07 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:1.0 A Low−Dropout Positive Fixed and Adjustable Voltage Regulators |
| NCP1117DT12 | 功能描述:低壓差穩壓器 - LDO 12V 1A Positive RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| NCP1117DT12G | 功能描述:低壓差穩壓器 - LDO 12V 1A Positive RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
發布緊急采購，3分鐘左右您將得到回復。