- 您現在的位置：買賣IC網 > PDF目錄359243 > MVTX2803 (Zarlink Semiconductor Inc.) Unmanaged 8-Port 1000 Mbps Ethernet Switch PDF資料下載
參數資料
| 型號： | MVTX2803 |
| 廠商： | Zarlink Semiconductor Inc. |
| 英文描述： | Unmanaged 8-Port 1000 Mbps Ethernet Switch |
| 中文描述： | 非托管8端口1000 Mbps以太網交換機 |
| 文件頁數： | 13/127頁 |
| 文件大小： | 1706K |
| 代理商： | MVTX2803 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁
MVTX2803
Data Sheet
13
Zarlink Semiconductor Inc.
2.0 System Configuration
The MVTX2803AG can be configured by EEPROM (24C02 or compatible) via an I
2
C interface at boot time, or
via a synchronous serial interface during operation.
2.1 I
2
C Interface
The I
2
C interface uses two bus lines, a serial data line (SDA) and a serial clock line (SCL). The SCL carries the
control signals that facilitate the transfer of information from the EEPROM to the switch. Data transfer is a
bidirectional 8-bit serial at a rate of 50 Kbps. Data transfer is performed between master and slave IC using a
request / acknowledgment style of protocol. The master IC generates the timing signals and terminates data
transfer. The figure below shows the data transfer format.
Figure 2 - Data Transfer Format for I
2
C Interface
2.1.1 Start Condition
Generated by the master, the MVTX2803AG. The bus is considered to be busy after the Start condition is
generated. The Start condition occurs if, while the SCL line is High, there is a High-to-Low transition of the SDA.
Other than in the Start condition (and Stop condition), the data on the SDA line must be stable during the High
period of SCL. The High or Low state of SDA can only change when SCL is Low. In addition, when the I
2
C bus
is free, both lines are High.
2.1.2 Address
The first byte after the Start condition determines which slave the master will select. The slave in our case is the
EEPROM. The first seven bits of the first data byte make up the slave address.
2.1.3 Data Direction
The eighth bit in the first byte after the Start condition determines the direction (R/W) of the message. A master
transmitter sets this bit to W; a master receiver sets this bit to R.
2.1.4 Acknowledgment
Like all clock pulses, the master generates the acknowledgment-related clock pulse. However, the transmitter
releases the SDA (High) during the acknowledgment clock pulse. Furthermore, the receiver must pull down the
SDA during the acknowledge pulse so that it remains stable Low during the High period of this clock pulse. An
acknowledgment pulse follows every byte transfer.
If a slave receiver does not acknowledge after any byte, then the master generates a Stop condition and aborts
the transfer.
If a master receiver does not acknowledge after any byte, then the slave transmitter must release the SDA line
to let the master generate the Stop condition.
2.1.5 Data
After the first byte containing the address, all bytes that follow are data bytes. Each byte must be followed by an
acknowledge bit. Data is transferred MSB-first.
START
SLAVE
ADDRESS
R/W
ACK
DATA 1
(8 bits)
ACK
DATA 2
(8 bits)
ACK
DATA M
(8 bits)
ACK
STOP
相關PDF資料 |
PDF描述 |
|---|---|
| MVTX2803AG | Unmanaged 8-Port 1000 Mbps Ethernet Switch |
| MVTX2804 | 8-Port 1000 Mbps Ethernet Distributed Switch |
| MVTX2804AG | 8-Port 1000 Mbps Ethernet Distributed Switch |
| MVV200 | Analog IC |
| MW005A | DC-to-DC Voltage Converter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MVTX2803A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Unmanaged 8 port Gigabit Ethernet switch |
| MVTX2803AG | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:Unmanaged 8-Port 1000 Mbps Ethernet Switch |
| MVTX2803AG2 | 制造商:Microsemi Corporation 功能描述: |
| MVTX2804 | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:8-Port 1000 Mbps Ethernet Distributed Switch |
| MVTX2804AG | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:8-Port 1000 Mbps Ethernet Distributed Switch |
發布緊急采購，3分鐘左右您將得到回復。