- 您現在的位置：買賣IC網 > PDF目錄98045 > MTB15N06V (ON SEMICONDUCTOR) 15 A, 60 V, 0.12 ohm, N-CHANNEL, Si, POWER, MOSFET PDF資料下載
參數資料
| 型號： | MTB15N06V |
| 廠商： | ON SEMICONDUCTOR |
| 元件分類： | JFETs |
| 英文描述： | 15 A, 60 V, 0.12 ohm, N-CHANNEL, Si, POWER, MOSFET |
| 封裝： | CASE 418B-02, D2PAK-3 |
| 文件頁數： | 8/11頁 |
| 文件大?。?/td> | 274K |
| 代理商： | MTB15N06V |
MTB15N06V
http://onsemi.com
6
VDS
,DRAINT
OSOURCE
VOL
TAGE
(VOL
TS)
V GS
,GA
TET
OSOURCE
VOL
TAGE
(VOL
TS)
DRAINTOSOURCE DIODE CHARACTERISTICS
VSD, SOURCETODRAIN VOLTAGE (VOLTS)
Figure 8. GateToSource and DrainToSource
Voltage versus Total Charge
I S
,SOURCE
CURRENT
Figure 9. Resistive Switching Time
Variation versus Gate Resistance
RG, GATE RESISTANCE (OHMS)
110
1
t,TIME
(ns)
VDD = 30 V
ID = 15 A
VGS = 10 V
TJ = 25°C
Figure 10. Diode Forward Voltage versus Current
0
QT, TOTAL CHARGE (nC)
36
9
12
15
ID = 15 A
TJ = 25°C
1000
100
10
1
10
6
2
0
12
8
4
60
50
40
30
20
10
0
QT
Q2
Q1
Q3
VGS
VDS
td(on)
td(off)
tf
tr
VGS = 0 V
TJ = 25°C
15
12
9
6
3
0
0.5
0.7
0.9
1.1
1.3
1.5
SAFE OPERATING AREA
The Forward Biased Safe Operating Area curves define
the maximum simultaneous draintosource voltage and
drain current that a transistor can handle safely when it is
forward biased. Curves are based upon maximum peak
junction temperature and a case temperature (TC) of 25°C.
Peak repetitive pulsed power limits are determined by using
the thermal response data in conjunction with the
procedures discussed in AN569, “Transient Thermal
ResistanceGeneral Data and Its Use.”
Switching between the offstate and the onstate may
traverse any load line provided neither rated peak current
(IDM) nor rated voltage (VDSS) is exceeded and the
transition time (tr,tf) do not exceed 10 μs. In addition the total
power averaged over a complete switching cycle must not
exceed (TJ(MAX) TC)/(RθJC).
A Power MOSFET designated EFET can be safely used
in switching circuits with unclamped inductive loads. For
reliable operation, the stored energy from circuit inductance
dissipated in the transistor while in avalanche must be less
than the rated limit and adjusted for operating conditions
differing from those specified. Although industry practice is
to rate in terms of energy, avalanche energy capability is not
a constant. The energy rating decreases nonlinearly with
an increase of peak current in avalanche and peak junction
temperature.
Although many EFETs can withstand the stress of
draintosource avalanche at currents up to rated pulsed
current (IDM), the energy rating is specified at rated
continuous current (ID), in accordance with industry custom.
The energy rating must be derated for temperature as
shown in the accompanying graph (Figure 12). Maximum
energy at currents below rated continuous ID can safely be
assumed to equal the values indicated.
相關PDF資料 |
PDF描述 |
|---|---|
| MTB15N06VT4 | 15 A, 60 V, 0.12 ohm, N-CHANNEL, Si, POWER, MOSFET |
| MTB16N25E | 16 A, 250 V, 0.25 ohm, N-CHANNEL, Si, POWER, MOSFET |
| MTB16N25ET4 | 16 A, 250 V, 0.25 ohm, N-CHANNEL, Si, POWER, MOSFET |
| MTB20N20E | 20 A, 200 V, 0.16 ohm, N-CHANNEL, Si, POWER, MOSFET |
| MTB20N20ET4 | 20 A, 200 V, 0.16 ohm, N-CHANNEL, Si, POWER, MOSFET |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MTB15N06VT4 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MTB1-5PAL1 | 制造商:ITT Interconnect Solutions 功能描述:MTB1-5PAL1 - Bulk |
| MTB1-5PAL57-02 | 制造商:ITT Interconnect Solutions 功能描述:095258-0073 - Bulk |
| MTB1-5PAL82 | 制造商:ITT Interconnect Solutions 功能描述:Conn Unshrouded Header PIN 5 POS 1.27mm Solder RA Thru-Hole |
| MTB1-5PH001 | 制造商:ITT Interconnect Solutions 功能描述:MTB1-5PH001 - Bulk |
發(fā)布緊急采購，3分鐘左右您將得到回復。