- 您現在的位置：買賣IC網 > PDF目錄359234 > MT90401AB (ZARLINK SEMICONDUCTOR INC) 150MA LOW-DROPOUT VOLTAGE REGULATOR SO-8 PKG PDF資料下載
參數資料
| 型號： | MT90401AB |
| 廠商： | ZARLINK SEMICONDUCTOR INC |
| 元件分類： | 數字傳輸電路 |
| 英文描述： | 150MA LOW-DROPOUT VOLTAGE REGULATOR SO-8 PKG |
| 中文描述： | ATM/SONET/SDH SUPPORT CIRCUIT, PQFP80 |
| 封裝： | 14 X 14 MM, 1.40 MM HEIGHT, MS-026BEC, LQFP-80 |
| 文件頁數： | 12/38頁 |
| 文件大?。?/td> | 650K |
| 代理商： | MT90401AB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁
MT90401
Data Sheet
12
Zarlink Semiconductor Inc.
1.4 Digital Phase Lock Loop (DPLL)
As shown in Figure 4, the DPLL of the MT90401 consists of a Phase Detector, Phase Slope Limiter, Loop Filter,
Digitally Controlled Oscillator, and a Control Circuit.
Figure 4 - DPLL Block Diagram
Phase Detector
- the Phase Detector compares the virtual reference signal from the TIE Corrector circuit with the
feedback signal from the Frequency Select MUX circuit, and provides an error signal corresponding to the phase
difference between the two. This error signal is passed to the Phase Slope Limiter circuit. The Frequency Select
MUX allows the proper feedback signal to be externally selected (e.g., 8 kHz, 1.544 MHz, 2.048 MHz or
19.44 MHz).
Phase Slope Limiter
- the Phase Slope Limiter receives the error signal from the Phase Detector and ensures that
the DPLL responds to all input transient conditions with a limited output phase slope. In SONET Mode the
maximum output phase slope is limited to 885 ns/s as per Telcordia GR-253-CORE. In SDH Mode the maximum
output phase slope is 53 ns per 1.326 ms.
Loop Filter
- the Loop Filter is a low pass filter, that defines the network jitter and wander transfer requirements for
all input reference frequencies (8 kHz, 1.544 MHz, 2.048 MHz, or 19.44 MHz). In SONET mode the loop filter has a
cut-off frequency of 70 mHz to comply with Telcordia GR-253-CORE and GR-1244-CORE. In SDH mode the loop
filter has a cut-off frequency of 1.1Hz to comply with ITU-T G.813 Option 1 and GR-1244-CORE.
Control Circuit
- the Control Circuit uses status and control information from the State Machine and the Input
Impairment Circuit to set the mode of the DPLL. The three possible modes are Normal, Holdover and Freerun.
Digitally Controlled Oscillator (DCO)
- the DCO receives the limited and filtered signal from the Loop Filter, and
based on its value, generates a corresponding digital output signal. The synchronization method of the DCO is
dependent on the state of the MT90401.
In Normal Mode, the DCO provides an output signal which is frequency and phase locked to the selected input
reference signal.
In Holdover Mode, the DCO is free running at a frequency equal to the last locked frequency the DCO was
generating while in Normal Mode. In order to improve accuracy of the Holdover Mode the actual frequency sample
is taken 30 to 60 ms before switching into holdover.
In Freerun Mode, the DCO is free running with an accuracy equal to the accuracy of the C20i 20 MHz source.
Telcordia GR-253-CORE requires that, during recovery from holdover, SONET clocks not change their output
frequency at a rate faster than 2.9 ppm per second. In SONET Mode the MT90401 limits the rate of change of its
output frequency (frequency slope) to less than 1.9ppm per second; this limit remains in place when the PLL is in
Fast Lock Mode.
Control
Circuit
State Select
from
Input Impairment Monitor
State Select
from
State Machine
Feedback Signal
from
Frequency Select MUX
DPLL Reference
to
Output Interface Circuit
Virtual Reference
from
TIE Corrector
Phase Slope
Limiter
Loop Filter
Digitally
Controlled
Oscillator
Phase
Detector
相關PDF資料 |
PDF描述 |
|---|---|
| MT90401AB1 | SONET/SDH System Synchronizer |
| MT9040 | T1/E1 Synchronizer |
| MT9040AN | T1/E1 Synchronizer |
| MT9043 | T1/E1 System Synchronizer |
| MT9043AN | T1/E1 System Synchronizer |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MT90401AB1 | 制造商:Microsemi Corporation 功能描述:FRAMER SDH/SONET 3.3V 80LQFP EP - Trays 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC SYNCHRONIZER SONET/SDH 80LQFP 制造商:Microsemi Corporation 功能描述:IC SYNCHRONIZER SONET/SDH 80LQFP |
| MT9040AN | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:T1/E1 Synchronizer |
| MT9040AN1 | 制造商:Microsemi Corporation 功能描述:FRAMER E1 /T1 3.3V 48SSOP - Rail/Tube |
| MT9040ANR1 | 制造商:Microsemi Corporation 功能描述:FRAMER E1 /T1 3.3V 48SSOP - Tape and Reel |
| MT9041 | 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:Multiple Output Trunk PLL |
發布緊急采購，3分鐘左右您將得到回復。