- 您現在的位置：買賣IC網 > PDF目錄98045 > MSP430P325IPG (TEXAS INSTRUMENTS INC) 16-BIT, OTPROM, 3.3 MHz, RISC MICROCONTROLLER, PQFP64 PDF資料下載
參數資料
| 型號： | MSP430P325IPG |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, OTPROM, 3.3 MHz, RISC MICROCONTROLLER, PQFP64 |
| 封裝： | GREEN, PLASTIC, QFP-64 |
| 文件頁數： | 2/37頁 |
| 文件大?。?/td> | 534K |
| 代理商： | MSP430P325IPG |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
MSP430P325
MIXED SIGNAL MICROCONTROLLER
SLAS164A – FEBRUARY 1998 – REVISED MARCH 2000
10
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
oscillator and system clock (continued)
The controller system clock has to operate with different requirements according to the application and system
conditions. Requirements include:
D High frequency in order to react quickly to system hardware requests or events
D Low frequency in order to minimize current consumption, EMI, etc.
D Stable frequency for timer applications e.g. real-time clock (RTC)
D Enable start-stop operation with a minimum of delay
These requirements cannot all be met with fast frequency high-Q crystals or with RC-type low-Q oscillators. The
compromise selected for the MSP430 uses a low-crystal frequency, which is multiplied to achieve the desired
nominal operating range:
f= (N+1) × f(crystal)
The crystal frequency multiplication is achieved with a frequency locked loop (FLL) technique. The factor N is
set to 31 after a power-up clear condition. The FLL technique, in combination with a digital controlled oscillator
(DCO) provides immediate start-up capability together with long term crystal stability. The frequency variation
of the DCO with the FLL inactive is typically 330 ppm, which means that with a cycle time of 1
s the maximum
possible variation is 0.33 ns. For more precise timing, the FLL can be used forcing longer cycle times, if the
previous cycle time was shorter than the selected one. This switching of cycle times makes it possible to meet
the chosen system frequency over a long period of time.
The start-up operation of the system clock depends on the previous machine state. During a power-up clear
(PUC), the DCO is reset to its lowest possible frequency. The control logic starts operation immediately after
recognition of PUC. Connect operation of the FLL control logic requires the presence of a stable crystal
oscillator.
digital I/O
One 8-Bit I/O port (Port0) is implemented. Six control registers give maximum flexibility of digital input/output
to the application:
D All individual I/O bits are programmable independently.
D Any combination of input, output, and interrupt conditions is possible.
D Interrupt processing of external events is fully implemented for all eight bits of port P0.
D Provides read/write access to all registers with all instructions
The six registers are:
D Input register
Contains information at the pins
D Output register
Contains output information
D Direction register
Controls direction
D Interrupt flags
Indicates if interrupt(s) are pending
D Interrupt edge select
Contains input signal change necessary for interrupt
D Interrupt enable
Contains interrupt enable pins
All six registers contain eight bits except for the interrupt flag register and the interrupt enable register. The two
LSBs of the interrupt flag and interrupt enable registers are located in the special functions register (SFR). Three
interrupt vectors are implemented, one for Port0.0, one for Port0.1, and one commonly used for any interrupt
event on Port0.2 to Port0.7. The Port0.1 and Port0.2 pin function is shared with the 8-Bit Timer/Counter.
相關PDF資料 |
PDF描述 |
|---|---|
| MSP430P337AIPJM | 16-BIT, OTPROM, 3.8 MHz, RISC MICROCONTROLLER, PQFP100 |
| MSW2002-200-T | SILICON, PIN DIODE |
| MT8952BC | 1 CHANNEL(S), 2.5M bps, SERIAL COMM CONTROLLER, CDIP28 |
| MT8952BC | 1 CHANNEL(S), 2.5M bps, SERIAL COMM CONTROLLER, CDIP28 |
| MT8LLN22NCNE | PCI BUS CONTROLLER, PBGA316 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MSP430P325IPM | 功能描述:16位微控制器 - MCU 16kB OTP 512B RAM 14b ADC/84 seg LCD RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
| MSP430P325QPG | 制造商:Texas Instruments 功能描述: |
| MSP430P337AIPJM | 功能描述:16位微控制器 - MCU 32kB OTP 1KB RAM USART/120 seg LCD RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
| MSP430P337AIPJM | 制造商:Texas Instruments 功能描述:16-Bit Microcontroller Clock Speed:3.8MH |
| MSP430P337AIPJMPX | 制造商:Texas Instruments 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。