- 您現在的位置：買賣IC網 > PDF目錄45383 > MR80C52CXXX-25SB (TEMIC SEMICONDUCTORS) 8-BIT, MROM, 25 MHz, MICROCONTROLLER, CQCC44 PDF資料下載
參數資料
| 型號： | MR80C52CXXX-25SB |
| 廠商： | TEMIC SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, MROM, 25 MHz, MICROCONTROLLER, CQCC44 |
| 文件頁數： | 5/60頁 |
| 文件大?。?/td> | 5137K |
| 代理商： | MR80C52CXXX-25SB |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁
13
8266D-MCU Wireless-06/12
ATmega128RFA1
Figure 7-2. The X-, Y-, Z-registers
In the different addressing modes these address registers have functions as fixed
displacement, automatic increment, and automatic decrement (see the instruction set
reference for details).
7.6 Stack Pointer
The Stack is mainly used for storing temporary data, for storing local variables and for
storing return addresses after interrupts and subroutine calls. The Stack Pointer
Register always points to the top of the Stack. Note that the Stack is implemented as
growing from higher memory locations to lower memory locations. This implies that a
Stack PUSH command decreases the Stack Pointer.
The Stack Pointer points to the data SRAM Stack area where the Subroutine and
Interrupt Stacks are located. This Stack space in the data SRAM must be defined by
the program before any subroutine calls are executed or interrupts are enabled. The
Stack Pointer must be set to point above 0x0200. The initial value of the stack pointer is
the last address of the internal SRAM.
The Stack Pointer is decremented by one when data is pushed onto the Stack with the
PUSH instruction, and it is decremented by two when the return address is pushed onto
the Stack with subroutine call or interrupt. The Stack Pointer is incremented by one
when data is popped from the Stack with the POP instruction, and it is incremented by
two when data is popped from the Stack with return from subroutine RET or return from
interrupt RETI.
When the FLASH memory exceeds 128Kbyte one additional cycle is required. In this
case the Stack Pointer is decremented by three when the return address is pushed onto
the Stack with subroutine call or interrupt and is incremented by three when data is
popped from the Stack with return from subroutine RET or return from interrupt RETI.
7.6.1 SPH – Stack Pointer High
Bit
7
6
5
4
3
2
1
0
$3E ($5E)
SP15
SP14
SP13
SP12
SP11
SP10
SP9
SP8
SPH
Read/Write
RW
Initial Value
0
1
0
1
The AVR Stack Pointer is implemented as two 8-bit registers SPL and SPH in the I/O
space. The number of bits actually used is implementation dependent. Note that the
data space in some implementations of the AVR architecture is so small that only SPL
is needed. In this case, the SPH Register will not be present.
Bit 7:0 – SP15:8 - Stack Pointer High Byte
相關PDF資料 |
PDF描述 |
|---|---|
| MR80C52UXXX-25 | 8-BIT, MROM, 25 MHz, MICROCONTROLLER, CQCC44 |
| IS80C32U-S | 8-BIT, 20 MHz, MICROCONTROLLER, PQCC44 |
| IV80C52UXXX-S | 8-BIT, MROM, 20 MHz, MICROCONTROLLER, PQFP44 |
| IS80C52UFXXX-S:R | 8-BIT, MROM, 20 MHz, MICROCONTROLLER, PQCC44 |
| IS80C52UXXX-25:R | 8-BIT, MROM, 25 MHz, MICROCONTROLLER, PQCC44 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MR80C86 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:CMOS 16-Bit Microprocessor |
| MR80C86/B | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Harris Corporation 功能描述:Microprocessor, 16 Bit, 44 Pin, Ceramic, LCC |
| MR80C86-2 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:CMOS 16-Bit Microprocessor |
| MR80C86-2/883 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MR80C86-2/B | 制造商:Intersil Corporation 功能描述:MPU 80C86 16BIT CMOS 8MHZ 44PLCC - Rail/Tube |
發布緊急采購，3分鐘左右您將得到回復。