- 您現在的位置：買賣IC網 > PDF目錄45204 > MC16V1CPU20B1 (MOTOROLA INC) 16-BIT, MROM, 20.97 MHz, MICROCONTROLLER, PQFP100 PDF資料下載
參數資料
| 型號： | MC16V1CPU20B1 |
| 廠商： | MOTOROLA INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, MROM, 20.97 MHz, MICROCONTROLLER, PQFP100 |
| 封裝： | TQFP-100 |
| 文件頁數： | 40/128頁 |
| 文件大?。?/td> | 571K |
| 代理商： | MC16V1CPU20B1 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁當前第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁
MC68HC16V1
MOTOROLA
MC68HC16V1TS/D
19
PCON2 — 2X/1X System Clock
This bit controls the W and X bit reset states when the SLIM is reset in fast reference mode.
0 = System clock frequency is the same as the reference frequency.
1 = System clock frequency is twice the reference frequency.
This bit can be overridden by driving IRQX to the desired state if DRCD is low during reset.
PCON1 — Port E4 Default Configuration
This bit contains the default reset value for the CLKOUT/PE4 pin assignment bit in the port E pin as-
signment register (PEPAR). This allows the pin to come out of reset as CLKOUT or digital I/O.
PCON0 — Clock Select
This bit, along with VDDSYN = VDD, selects the clock source as either fast or slow reference.
0 = Clock source is fast reference
1 = Clock source is slow reference
If VDDSYN = VSS, the clock source is external, regardless of the state of this bit. This bit can be overrid-
den by driving FREEZE to the desired state if DRCD is low during reset.
BOOT ROM — Reset and Interrupt Vector Configuration
$000000 – $0001FF
The boot ROM submodule in the SLIM provides the system with a small amount of mask programmable
memory used for initialization. The boot ROM submodule occupies 512 bytes (256 by 16 bits) of the
system memory and is accessible by byte or word. The ROMEN and ROMSU bits in SLIMCR control
access to the boot ROM. The contents of the boot ROM are user specified. The boot ROM on generic
devices will be filled with all $FF or all $00. Consult the factory for information on ordering devices with
a customer specified boot ROM.
3.3 System Clock
The system clock in the SLIM provides timing signals for the IMB modules and for the external bus in-
terface. Because the MCU is a fully static design, register and memory contents are not affected when
the clock rate changes. System hardware and software support changes in clock rate during operation.
3.3.1 System Clock Sources
The system clock signal can be generated from one of three sources. An internal phase-locked loop
(PLL) can synthesize the clock from a slow or fast reference, or the clock signal can be input from an
external frequency source. The slow reference typically is a 32.768 kHz crystal; the fast reference is
typically a 4.194 MHz crystal. The slow and fast references may be generated by sources other than a
crystal. Keep these clock sources in mind while reading the rest of this section.
The source of the system clock is determined at reset by the state of two shadow bits in the port/clock
sources.
The parameter “fref” refers to the frequency of the clock source connected to the EXTAL pin. Refer to
3.3.2 Clock Modes for more information.
The parameter “fsys” refers to the operating frequency of the MCU and has a defined relationship to fref
that depends on the clock operating mode selected during reset.
相關PDF資料 |
PDF描述 |
|---|---|
| MC2670L | DOT MAT LCD DRVR AND DSPL CTLR, CDIP28 |
| MC2670P | DOT MAT LCD DRVR AND DSPL CTLR, PDIP28 |
| MC2671AS | 1 CHANNEL(S), SERIAL COMM CONTROLLER, CDIP40 |
| MC2671AL | 1 CHANNEL(S), SERIAL COMM CONTROLLER, CDIP40 |
| MC2675B5S | SPECIALTY MICROPROCESSOR CIRCUIT, CDIP40 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC16XSD200FK | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Dual 16 mOhm High Side Switch |
| MC16Z1CFC25B1 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MC16Z1CPV20B1 | 制造商:Rochester Electronics LLC 功能描述:16 BIT MCU, 1K RAM - Bulk |
| MC16Z3BCAG16 | 功能描述:16位微控制器 - MCU 16BIT MCU 4KRAM 8KROM RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
| MC-17 | 功能描述:TERM BARRIER 17CIRC DUAL ROW RoHS:是 類別:連接器，互連式 >> 接線座 - 隔板塊 系列:M 標準包裝:10 系列:Beau™ 38780 端接塊類型:阻隔塊 電路數:15 導線入口數目:30 間距:0.438"（11.12mm） 行數:2 電流:15A 電壓:300V 線規:14-22 AWG 頂部端子:螺釘 底部端子:焊片 阻擋層類型:雙壁（雙） 特點:法蘭 顏色:黑 包裝:散裝 安裝類型:通孔 工作溫度:- 材料 - 絕緣體:聚對苯二甲酸丁二酯（PBT），玻璃纖維增強型 材料可燃性額定值:UL94 V-0 其它名稱:038780-111538780-1115387801115 |
發布緊急采購，3分鐘左右您將得到回復。