- 您現在的位置：買賣IC網 > PDF目錄45178 > MAXQ618J-0000+ (MAXIM INTEGRATED PRODUCTS INC) 16-BIT, FLASH, 12 MHz, RISC MICROCONTROLLER, QCC44 PDF資料下載
參數資料
| 型號： | MAXQ618J-0000+ |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, FLASH, 12 MHz, RISC MICROCONTROLLER, QCC44 |
| 封裝： | 7 X 7 MM, ROHS COMPLIANT, TQFN-44 |
| 文件頁數： | 24/26頁 |
| 文件大?。?/td> | 1970K |
| 代理商： | MAXQ618J-0000+ |
Maxim Integrated Products 7
MAXQ618
16-Bit Microcontroller with Infrared Module
Note 1: Specifications to 0NC are guaranteed by design and are not production tested. Typical = +25NC, VDD = +3.3V, unless oth-
erwise noted.
Note 2: VPFW can be programmed to the following nominal voltage trip points: 1.8V, 1.9V, 2.55V, and 2.75V ±3%. The values
listed in the Recommended Operating Conditions table are for the default configuration of 1.8V typical.
Note 3: The power-fail reset and POR detectors are designed to operate in tandem to ensure that one or both of these signals
is active at all times when VDD < VRST, ensuring the device maintains the reset state until minimum operating voltage is
achieved.
Note 4: Guaranteed by design and not production tested.
Note 5: Measured on the VDD pin and the device not in reset. All inputs are connected to GND or VDD. Outputs do not source/
sink any current. The device is executing code from flash memory.
Note 6: The power-check interval (PCI) can be set to always on, or to 1024, 2048, or 4096 nanopower ring clock cycles.
Note 7: Current consumption during POR when powering up while VDD is less than the POR release voltage.
Note 8: The minimum amount of time that VDD must be below VPFW before a power-fail event is detected; refer to the MAXQ610
User’s Guide for details.
Note 9: The maximum total current, IOH(MAX) and IOL(MAX), for all listed outputs combined should not exceed 32mA to satisfy the
maximum specified voltage drop. This does not include the IRTX output.
Note 10: Programming time does not include overhead associated with utility ROM interface.
Note 11: AC electrical specifications are guaranteed by design and are not production tested.
SPI ELECTRICAL CHARACTERISTICS* (continued)
(VDD = VRST to 3.6V, TA = 0NC to +70NC, unless otherwise noted.) (Note 11)
PARAMETER
SYMBOL
CONDITIONS
MIN
TYP
MAX
UNITS
SCLK Inactive to SSEL Rising
tSD
tSPI_RF
ns
MISO Output Disabled After SSEL
Edge Rise
tSLH
2tCK +
2tSPI_RF
ns
*The parametric values (min, typ, max limits) shown in the Electrical Characteristics table supersede values quoted elsewhere in this data sheet.
相關PDF資料 |
PDF描述 |
|---|---|
| MAZD02400L | 2.4 V, 0.12 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE |
| MAZD03000L | 3 V, 0.12 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE |
| MAZD22000L | 22 V, 0.12 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE |
| MAZD12000L | 12 V, 0.12 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE |
| MAZD10000L | 10 V, 0.12 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAXQ618J-0000+ | 功能描述:16位微控制器 - MCU 16-Bit MCU w/Infrared Module RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
| MAXQ618X-0000+ | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:16-Bit Microcontroller with Infrared Module |
| MAXQ61C | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:16-Bit Microcontroller with Infrared Module |
| MAXQ61CA | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:16-Bit Microcontroller with Infrared Module |
| MAXQ61CE | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:16-Bit Microcontroller with Infrared Module |
發布緊急采購，3分鐘左右您將得到回復。