- 您現在的位置：買賣IC網 > PDF目錄45178 > MAXQ618J-0000+ (MAXIM INTEGRATED PRODUCTS INC) 16-BIT, FLASH, 12 MHz, RISC MICROCONTROLLER, QCC44 PDF資料下載
參數資料
| 型號： | MAXQ618J-0000+ |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, FLASH, 12 MHz, RISC MICROCONTROLLER, QCC44 |
| 封裝： | 7 X 7 MM, ROHS COMPLIANT, TQFN-44 |
| 文件頁數： | 17/26頁 |
| 文件大小： | 1970K |
| 代理商： | MAXQ618J-0000+ |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
Maxim Integrated Products 24
MAXQ618
16-Bit Microcontroller with Infrared Module
Applications Information
The low-power, high-performance RISC architecture of
this device makes it an excellent fit for many portable or
battery-powered applications. It is ideally suited for appli-
cations such as universal remote controls that require the
cost-effective integration of IR transmit/receive capability.
Grounds and Bypassing
Careful PCB layout significantly minimizes system-level
digital noise that could interact with the microcontroller
or peripheral components. The use of multilayer boards
is essential to allow the use of dedicated power planes.
The area under any digital components should be a con-
tinuous ground plane if possible. Keep bypass capacitor
leads short for best noise rejection and place the capaci-
tors as close to the leads of the devices as possible.
CMOS design guidelines for any semiconductor require
that no pin be taken above VDD or below GND. Violation
of this guideline can result in a hard failure (damage to
the silicon inside the device) or a soft failure (uninten-
tional modification of memory contents). Voltage spikes
above or below the device’s absolute maximum ratings
can potentially cause a devastating IC latchup.
Microcontrollers commonly experience negative volt-
age spikes through either their power pins or general-
purpose I/O pins. Negative voltage spikes on power pins
are especially problematic as they directly couple to the
internal power buses. Devices such as keypads can con-
duct electrostatic discharges directly into the microcon-
troller and seriously damage the device. System design-
ers must protect components against these transients
that can corrupt system memory.
Additional Documentation
Designers must have the following documents to fully
use all the features of this device. This data sheet
contains pin descriptions, feature overviews, and elec-
trical specifications. Errata sheets contain deviations
from published specifications. The user’s guides offer
detailed information about device features and opera-
tion. The following documents can be downloaded from
ThisMAXQ618datasheet,whichcontainselectrical/
timing specifications, pin descriptions, and package
information.
The MAXQ618 revision-specific errata sheet
(www.maxim-ic.com/errata).
TheMAXQ610 User’s Guide, which contains detailed infor-
mation on features and operation, including programming.
Table 5. Stop Mode Power-Fail Detection States with Power-Fail Monitor Disabled
(continued)
STATE
POWER-FAIL
INTERNAL
REGULATOR
CRYSTAL
OSCILLATOR
SRAM
RETENTION
COMMENTS
D
Off
Yes
Application enters stop mode.
VDD > VRST.
CPU in stop mode.
E
On
(Periodically)
Off
Yes
VPOR < VDD < VRST.
An interrupt occurs that causes the CPU to
exit stop mode.
Power-fail monitor is turned on, detects a
power-fail, and puts CPU in reset.
Power-fail monitor is turned on periodically.
F
Off
—
VDD < VPOR.
Device held in reset. No operation allowed.
相關PDF資料 |
PDF描述 |
|---|---|
| MAZD02400L | 2.4 V, 0.12 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE |
| MAZD03000L | 3 V, 0.12 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE |
| MAZD22000L | 22 V, 0.12 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE |
| MAZD12000L | 12 V, 0.12 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE |
| MAZD10000L | 10 V, 0.12 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAXQ618J-0000+ | 功能描述:16位微控制器 - MCU 16-Bit MCU w/Infrared Module RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
| MAXQ618X-0000+ | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:16-Bit Microcontroller with Infrared Module |
| MAXQ61C | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:16-Bit Microcontroller with Infrared Module |
| MAXQ61CA | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:16-Bit Microcontroller with Infrared Module |
| MAXQ61CE | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:16-Bit Microcontroller with Infrared Module |
發布緊急采購，3分鐘左右您將得到回復。