- 您現在的位置：買賣IC網 > PDF目錄384688 > MAX5887 (Maxim Integrated Products, Inc.) 3.3V, 14-Bit, 500Msps High Dynamic Performance DAC with Differential LVDS Inputs PDF資料下載
參數資料
| 型號： | MAX5887 |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | 3.3V, 14-Bit, 500Msps High Dynamic Performance DAC with Differential LVDS Inputs |
| 中文描述： | 3.3V、14位、500Msps、高動態性能DAC，差分LVDS輸入 |
| 文件頁數： | 17/18頁 |
| 文件大小： | 982K |
| 代理商： | MAX5887 |
M
3.3V, 14-Bit, 500Msps High Dynamic
Performance DAC with Differential LVDS Inputs
______________________________________________________________________________________
17
Gain Error
A gain error is the difference between the ideal and the
actual full-scale output voltage on the transfer curve,
after nullifying the offset error. This error alters the slope
of the transfer function and corresponds to the same
percentage error in each step.
Settling Time
The settling time is the amount of time required from the
start of a transition until the DAC output settles its new
output value to within the converter’s specified accuracy.
Glitch Energy
A glitch is generated when a DAC switches between
two codes. The largest glitch is usually generated
around the midscale transition, when the input pattern
transitions from 011...111 to 100...000. The glitch ener-
gy is found by integrating the voltage of the glitch at the
midscale transition over time. The glitch energy is usu-
ally specified in pV-s.
Dynamic Performance Parameter
Definitions
Signal-to-Noise Ratio (SNR)
For a waveform perfectly reconstructed from digital sam-
ples, the theoretical maximum SNR is the ratio of the full-
scale analog output (RMS value) to the RMS quantization
error (residual error). The ideal, theoretical minimum can
be derived from the DAC’s resolution (N bits):
SNR
dB
= 6.02
dB
N + 1.76
dB
However, noise sources such as thermal noise, refer-
ence noise, clock jitter, etc., affect the ideal reading;
therefore, SNR is computed by taking the ratio of the
RMS signal to the RMS noise, which includes all spec-
tral components minus the fundamental, the first four
harmonics, and the DC offset.
Spurious-Free Dynamic Range (SFDR)
SFDR is the ratio of RMS amplitude of the carrier fre-
quency (maximum signal components) to the RMS
value of their next-largest distortion component. SFDR
is usually measured in dBc and with respect to the car-
rier frequency amplitude or in dB FS with respect to the
DAC’s full-scale range. Depending on its test condition,
SFDR is observed within a predefined window or
to Nyquist.
Two-/Four-Tone Intermodulation
Distortion (IMD)
The two-tone IMD is the ratio expressed in dBc (or dB
FS) of either input tone to the worst 3rd-order (or high-
er) IMD products. Note that 2nd-order IMD products
usually fall at frequencies that can be easily removed
by digital filtering; therefore, they are not as critical as
3rd-order IMDs. The two-tone IMD performance of the
MAX5887 was tested with the two individual input tone
levels set to at least -6dB FS and the four-tone perfor-
mance was tested according to the GSM model at an
output frequency of 32MHz and amplitude of -12dB FS.
Adjacent Channel Leakage
Power Ratio (ACLR)
Commonly used in combination with W-CDMA, ACLR
reflects the leakage power ratio in dB between the
measured power within a channel relative to its adja-
cent channel. ACLR provides a quantifiable method of
determining out-of-band spectral energy and its influ-
ence on an adjacent channel when a bandwidth-limited
RF signal passes through a nonlinear device.
Chip Information
TRANSISTOR COUNT: 10,629
PROCESS: CMOS
相關PDF資料 |
PDF描述 |
|---|---|
| MAX5916 | Quadruple 2-Line To 1-Line Data Selectors/Multiplexers 16-CDIP -55 to 125 |
| MAX5916A | Dual PCI 2.2 Hot-Swap Controllers |
| MAX5916AEUI | Dual PCI 2.2 Hot-Swap Controllers |
| MAX5916EUI | Dual PCI 2.2 Hot-Swap Controllers |
| MAX5917BESE | +65V Simple Swapper Hot-Swap Switches |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX5887EGK | 制造商:Maxim Integrated Products 功能描述:3.3V, 14-BIT, 500MBPS HIGH DYNAMIC PERFORMAN - Rail/Tube |
| MAX5887EGK/GG8 | 制造商:Maxim Integrated Products 功能描述:3.3V, 14-BIT, 500MBPS HIGH DYNAMIC PERFORMAN - Rail/Tube |
| MAX5887EGK+D | 功能描述:數模轉換器- DAC 14-Bit 500Msps DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MAX5887EGK+TD | 功能描述:數模轉換器- DAC 14-Bit 500Msps DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MAX5887EGK-D | 功能描述:數模轉換器- DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。