- 您現在的位置：買賣IC網 > PDF目錄45031 > M37281MAH-XXXSP 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDIP52 PDF資料下載
參數資料
| 型號： | M37281MAH-XXXSP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDIP52 |
| 封裝： | 0.600 INCH, 1.78 MM PITCH, PLASTIC, SDIP-52 |
| 文件頁數： | 140/172頁 |
| 文件大?。?/td> | 1319K |
| 代理商： | M37281MAH-XXXSP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁當前第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁
Rev.1.01
2003.07.16
page 7 of 170
M37281MAH–XXXSP,M37281MFH–XXXSP,M37281MKH–XXXSP, M37281EKSP
VCC,
(AVCC,)
VSS
CNVSS
RESET
XIN
XOUT
P00/
PWM4–
P02/PWM6,
P03/PWM7,
P04/
PWM0–
P07/PWM3
P10/OUT2,
P11/SCL1,
P12/SCL2,
P13/SDA1,
P14/SDA2,
P15/G0,
P16/INT3/
B0,
P17/SIN/R0
P20–P23
P24/AD3–
P26/AD1,
P27/AD5
P30/AD7,
P31/AD8
P40/AD4,
P41/INT2,
P42/TIM2,
P43/TIM3,
P44/INT1,
P45/SOUT,
P46/SCLK
Input
Output
I/O
Output
I/O
Output
I/O
Input
I/O
Input
I/O
Input
Output
I/O
Apply voltage of 5 V ± 10 % (typical) to VCC (AVCC ) , and 0 V to VSS.
(
) ...M37281EKSP
Connected to VSS.
To enter the reset state, the reset input pin must be kept at a LOW for 2
s or more
(under normal VCC conditions).
If more time is needed for the quartz-crystal oscillator to stabilize, this LOW condition
should be maintained for the required time.
This chip has an internal clock generating circuit. To control generating frequency, an
external ceramic resonator or a quartz-crystal oscillator is connected between pins XIN
and XOUT. If an external clock is used, the clock source should be connected to the XIN
pin and the XOUT pin should be left open.
Port P0 is an 8-bit I/O port with direction register allowing each I/O bit to be individually
programmed as input or output. At reset, this port is set to input mode. The output structure
of P03 is CMOS output, that of P00–P02 and P04–P07 are N-channel open-drain output
(See note.)
Pins P00–P03 and P04–P07 are also used as 8-bit PWM output pins PWM4–PWM7 and
PWM0–PWM3 respectively. The output structure of PWM0–PWM6 is N-channel open-drain
output. And the output structure of PWM7 is CMOS output.
Port P1 is an 8-bit I/O port and has basically the same functions as port P0. The output
structure of P10 and P15–P17 is CMOS output, that of P11–P14 is N-channel open-drain
output (See note.)
Pin P10, P15–P17 are also used as OSD output pins OUT2, G0, B0, R0, respectively. The
output structure is CMOS output.
Pin P11–P14 are used as SCL1, SCL2, SDA1 and SDA2 respectively, when multi-master
I2C-BUS interface is used. The output structure is N-channel open-drain output.
Pin P16 is also used as INT extemal interrupt input pin INT3.
Pin P17 is also used as serial I/O data input pin SIN.
Port P2 is an 8-bit I/O port and has basically the same functions as port P0. The output
structure is CMOS output (See note.)
Pins P24–P26, P27 are also used as analog input pins AD3–AD1, AD5 respectively.
Ports P30 and P31 are 2-bit I/O ports and have basically the same functions as port P0. The
output structure is CMOS output (See note.)
Pins P30, P31 are also used as analog input pins AD7, AD8 respectively.
Ports P40–P46 are a 7-bit input port.
Pin P40 is also used as analog input pin AD4.
Pins P41, P44 are also used as INT external interrupt input pins INT2, INT1.
Pins P42 and P43 are also used as INT external clock input pins TIM2, TIM3 for timer
respectively.
Pin P45 is used as serial I/O data output pin SOUT. The output structure is N-channel open-
drain output.
Pin P46 is used as serial I/O synchronous clock input/output pin SCLK. The output structure
is N-channel open-drain output.
Pin
Name
Functions
Input/
Output
Power source
CNVSS
Reset input
Clock input
Clock output
I/O port P0
8-bit PWM output
I/O port P1
OSD output
Multi-master
I2C-BUS interface
External interrupt
input
Serial I/O data
input
I/O port P2
Analog input
I/O port P3
Analog input
Input port P4
Analog input
External interrupt
input
External clock input
for timer
Serial I/O data
output
Serial I/O
synchronous clock
input/output
7. PIN DESCRIPTION
Table 7.1 Pin Description
相關PDF資料 |
PDF描述 |
|---|---|
| M37281EKSP | 8-BIT, OTPROM, 8.1 MHz, MICROCONTROLLER, PDIP52 |
| M37281MFH-XXXSP | 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDIP52 |
| M37281MAH-XXXSP | 8-BIT, MROM, 8.1 MHz, MICROCONTROLLER, PDIP52 |
| M37281MKH-XXXSP | 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PDIP52 |
| M37281MAH-XXXSP | 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PDIP52 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M37281MFH-XXXSP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER |
| M37281MKH-XXXSP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER |
| M372899234 | 制造商:ITW Switches 功能描述:IN-RUSH |
| M372F3200DJ3-C | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:32M x 72 DRAM DIMM with ECC Using 16Mx4, 4K & 8K Refresh, 3.3V |
| M372F3280DJ3-C | 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:32M x 72 DRAM DIMM with ECC Using 16Mx4, 4K & 8K Refresh, 3.3V |
發布緊急采購，3分鐘左右您將得到回復。