參數(shù)資料
型號: M34282M2-XXXGP
元件分類: 微控制器/微處理器
英文描述: 4-BIT, MROM, 1 MHz, MICROCONTROLLER, PDSO20
封裝: 0.225 INCH, 0.65 MM PITCH, PLASTIC, SSOP-20
文件頁數(shù): 6/71頁
文件大小: 547K
代理商: M34282M2-XXXGP
Rev.1.33
Mar 18, 2004
page 12 of 67
4282 Group
Table 4 Control registers related to timer
V12
V11
V10
Timer control register V1
Auto-control output by timer 1 is invalid
Auto-control output by timer 1 is valid
Carrier wave output (CARRY)
Bit 5 of watchdog timer (WDT)
Stop (Timer 1 state retained)
Operating
0
1
0
1
0
1
Carrier wave output auto-control bit
Timer 1 count source selection bit
Timer 1 control bit
at reset : 0002
W
at RAM back-up : 0002
V23
V22
V21
V20
Timer control register V2
To expand “H” interval is invalid
To expand “H” interval is valid (when V22=1 selected)
Carrier wave generation function invalid
Carrier wave generation function valid
f(XIN)
f(XIN)/2
Stop (Timer 2 state retained)
Operating
0
1
0
1
0
1
0
1
Carrier wave “H” interval expansion bit
Carrier wave generation function control bit
Timer 2 count source selection bit
Timer 2 control bit
at reset : 00002
W
at RAM back-up : 00002
Note: “W” represents write enabled.
(1) Control registers related to timer
Timer control register V1
Register V1 controls the timer 1 count source and auto-
control function of carrier wave output from port CARR by
timer 1. Set the contents of this register through register A
with the TV1A instruction.
Timer control register V2
Register V2 controls the timer 2 count source and the carrier
wave generation function by timer. Set the contents of this
register through register A with the TV2A instruction.
(2) Precautions
Note the following for the use of timers.
Count source
Stop timer 1 or timer 2 counting to change its count source.
Watchdog timer
Be sure that the timing to execute the WRST instruction in
order to operate WDT efficiently.
Writing to reload register R1
When writing data to reload register R1 while timer 1 is
operating, avoid a timing when timer 1 underflows.
Timer 1 count operation
When the bit 5 of the watchdog timer (WDT) is selected as
the timer 1 count source, the error of maximum ± 256
s
(at the minimum instruction execution time : 8
s) is
generated from timer 1 start until timer 1 underflow. When
programming, be careful about this error.
Stop of timer 2
Avoid a timing when timer 2 underflows to stop timer 2.
Writing to reload register R2H
When writing data to reload register R2H while timer 2 is
operating, avoid a timing when timer underflows.
Timer 2 carrier wave output function
When to expand “H” interval of carrier wave is valid, set “1”
or more to reload register R2H.
相關PDF資料
PDF描述
M34283G2-XXXGP 4-BIT, MROM, 4 MHz, MICROCONTROLLER, PDSO20
M34506M4-XXXFP 4-BIT, MROM, 4.4 MHz, MICROCONTROLLER, PDSO20
M34507M4-XXXFP 4-BIT, MROM, 4.4 MHz, MICROCONTROLLER, PDSO24
M34524MC-XXXFP 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PQFP64
M34524MC-XXXFP 4-BIT, MROM, 6 MHz, MICROCONTROLLER, PQFP64
相關代理商/技術參數(shù)
參數(shù)描述
M34282T5-OPT 制造商:Renesas Electronics Corporation 功能描述:DEV OPTION BOARD FOR 4282 GROUP/PC4400 - Boxed Product (Development Kits)
M34283 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
M34283G2GP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
M34283G2GP#U1 制造商:Renesas Electronics Corporation 功能描述:MICROCONTROLLER
M34283G2-XXXGP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER