![](http://datasheet.mmic.net.cn/30000/M30260M3A-XXXGP-U5_datasheet_2358673/M30260M3A-XXXGP-U5_324.png)
page 310
19. Usage Precaution
8
2
3
f
o
5
0
2
,
5
1
.
r
a
M
0
.
1
.
v
e
R
0
1
0
-
2
0
2
0
B
9
0
J
E
R
)
T
6
2
/
C
6
1
M
,
A
6
2
/
C
6
1
M
(
p
u
o
r
G
A
6
2
/
C
6
1
M
19.7.2.3 Timer B (Pulse Period/pulse Width Measurement Mode)
1. The timer remains idle after reset. Set the mode, count source, etc. using the TBiMR (i = 0 to 2)
register before setting the TBiS bit in the TABSR register to “1” (count starts).
Always make sure the TBiMR register is modified while the TBiS bit remains “0” (count stops)
regardless whether after reset or not. To clear the MR3 bit to “0” by writing to the TBiMR register
while the TBiS bit is set to “1” (count starts), be sure to set the TM0D0, TM0D1, MR0, MR1, TCK0
and TCK1 bits to the same value as previously written and the MR2 bit to "0".
2. The IR bit in the TBiIC register (i=0 to 2) goes to “1” (interrupt request), when an effective edge of
a measurement pulse is input or timer Bi is overflowed. The factor of interrupt request can be
determined by use of the MR3 bit in the TBiMR register within the interrupt routine.
3. If the source of interrupt cannot be identified by the MR3 bit such as when the measurement pulse
input and a timer overflow occur at the same time, use another timer to count the number of times
timer B has overflowed.
4. To set the MR3 bit to “0” (no overflow), set TBiMR register with setting the TBiS bit to “1” and
counting the next count source after setting the MR3 bit to “1” (overflow).
5. Use the IR bit in the TBiIC register to detect only overflows. Use the MR3 bit only to determine the
interrupt factor within the interrupt routine.
6. When the count is started and the first effective edge is input, an indeterminate value is transferred
to the reload register. At this time, timer Bi interrupt request is not generated.
7. The value of the counter is indeterminate at the beginning of a count. MR3 may be set to “1” and
timer Bi interrupt request may be generated between the count start and an effective edge input.
8. For pulse width measurement, pulse widths are successively measured. Use program to check
whether the measurement result is an “H” level width or an “L” level width.