參數資料
型號： M30102M3-XXXFP
元件分類： 微控制器/微處理器
英文描述： 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP48
封裝： 7 X 7 MM, 0.50 MM PITCH, PLASTIC, LQFP-48
文件頁數： 132/166頁
文件大?。?/td> 2060K
代理商： M30102M3-XXXFP
Under
development
Tentative Specifications REV.E1
Specifications in this manual are tentative and subject to change.
Mitsubishi microcomputers
M30100/M30102 Group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
Timer X
65
(2) Pulse output mode
In this mode, the timer counts an internally generated count source, and outputs from the CNTR0 pin
a pulse whose polarity is inverted each time the timer underflows. (See Table 1.14.4) Figure 1.14.7
shows Timer X mode register in pulse output mode.
Item
Specification
Count source
f1, f8, f32, fC32
Count operation
Down count
When the timer underflows, it reloads the reload register contents before continuing counting
Divide ratio
1/(n+1)/(m+1) n : Set value of Prescaler X, m: Set value of Timer X
Count start condition
Count start flag is set (=1)
Count stop condition
Count start flag is reset (=0)
Interrupt request generation timing When Timer X underflows [Timer X interruption]
Rising (R0EDG=0) or falling (R0EDG=1) of CNTR0 output [CNTR0 interruption] (Note)
CNTR0 pin function
Pulse output
TXOUT pin function
Programmable I/O port or pulse output (Inverted waveform of the pulse output from the
CNTR0 pin)
Read from timer
Count value can be read out by reading Timer X register.
Same applies to Prescaler X register.
Write to timer
When a value is written to Timer X register, it is written to both reload register and counter.
Same applies to Prescaler X register.
Select function
Pulse output function
Each time the timer underflows, the TXOUT pin’s polarity is reversed
CNTR0 polarity switching function
The polarity level at starting of pulse output can be selected to be "High" or "Low" with software.
Note: When setting the timer X mode register to pulse output mode, the CNTR0 interrupt request bit becomes "1".
Thus, when using an CNTR0 interrupt, the CNTR0 interrupt request bit must be set to "0" after setting the timer
X mode register.
Table 1.14.4. Specifications of pulse output mode
Timer X mode register
Symbol
Address
When reset
TXMR
008B16
000000002
Bit name
Function
Bit symbol
W
R
b7
b6 b5
b4
b3
b2
b1 b0
0 1 : Pulse output mode
b1 b0
TXMOD2
TXS
TXMOD1
R0EDG
TXMOD0
TXOCNT
CNTR0 polarity
switching bit
Operation mode
select bit 0, 1
Note 1: In the pulse output mode, the direction register of port P17 must be set to input.
Note 2: Output is set regardless of the setting of the direction register of port P30.
Note 3: This bit should rewrite with inhibiting the CNTR0 interrupt.
0: Output starts at "H" (Interrupt at rising edge)
1: Output starts at "L" (Interrupt at falling edge)
Timer X count
start flag
0 : Stops counting
1 : Starts counting
P30/TXOUT
select bit
0 : Port P30
1 : TXOUT output
0 : Set to "0" in pulse output mode
(Note 1)
(Note 2)
0
1
(Note 3)
Invalid in pulse output mode.
When write, set "0". When read, this contents is indeteminate.
TXEDG
TXUND
Invalid in pulse output mode.
When write, set "0". When read, this contents is indeteminate.
Figure 1.14.7. Timer X mode register in pulse output mode
相關PDF資料
PDF描述
M30100M2T-XXXFP 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP32
M30102M3T-XXXFP 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP48
M30100M2-XXXFP 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP32
M30100F3TFP 16-BIT, FLASH, 16 MHz, MICROCONTROLLER, PQFP32
M30100M3-XXXFP 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP32
相關代理商/技術參數
參數描述
M30102T-PTC 制造商:Renesas Electronics Corporation 功能描述:DEV 48PIN .5MM QFP CNVTR FOR M30100T-PRB - Bulk
M30-1050046 功能描述:集管和線殼 FML CRIMP CONTACT 1.25MM,AWG 26-30, RL RoHS:否 產品種類:1.0MM Rectangular Connectors 產品類型:Headers - Pin Strip 系列:DF50 觸點類型:Pin (Male) 節距:1 mm 位置/觸點數量:16 排數:1 安裝風格:SMD/SMT 安裝角:Right 端接類型:Solder 外殼材料:Liquid Crystal Polymer (LCP) 觸點材料:Brass 觸點電鍍:Gold 制造商:Hirose Connector
M30-1060046 功能描述:集管和線殼 FML CRIMP CONTACT 1.25MM,AWG 26-30,LSE RoHS:否 產品種類:1.0MM Rectangular Connectors 產品類型:Headers - Pin Strip 系列:DF50 觸點類型:Pin (Male) 節距:1 mm 位置/觸點數量:16 排數:1 安裝風格:SMD/SMT 安裝角:Right 端接類型:Solder 外殼材料:Liquid Crystal Polymer (LCP) 觸點材料:Brass 觸點電鍍:Gold 制造商:Hirose Connector
M3010A 制造商:Honeywell Sensing and Control 功能描述:GENERAL MARKET VRS
M3010A25 制造商:Honeywell Sensing and Control 功能描述:GENERAL MARKET VRS
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*