- 您現在的位置：買賣IC網 > PDF目錄385505 > LTC1705 (Linear Technology Corporation) Dual 550kHz Synchronous Switching Regulator Controller with 5-Bit VID and 150mA LDO PDF資料下載
參數資料
| 型號： | LTC1705 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | Dual 550kHz Synchronous Switching Regulator Controller with 5-Bit VID and 150mA LDO |
| 中文描述： | 雙550kHz的同步開關，5位VID和150mA LDO穩壓器控制器 |
| 文件頁數： | 13/28頁 |
| 文件大?。?/td> | 326K |
| 代理商： | LTC1705 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LTC1705
13
output, the duty cycle will be set at 1.5/5 100% or 30%
by the feedback loop. This will give roughly a 540ns on-
time for QT and a 1.26
μ
s on-time for QB.
This constant frequency operation brings with it a couple
of benefits. Inductor and capacitor values can be chosen
with a precise operating frequency in mind and the feed-
back loop components can be similarly tightly specified.
Noise generated by the circuit will always be in a known
frequency band with the 550kHz frequency designed to
leave the 455kHz IF band free of interference. Subharmonic
oscillation and slope compensation, common headaches
with constant frequency current mode switchers, are
absent in voltage mode designs like the LTC1705.
During the time that QT is on, its source (the SW pin) is at
V
IN
. V
IN
is also the power supply for the LTC1705. How-
ever, QT requires V
IN
+V
GS(ON)
at its gate to achieve mini-
mum R
ON
. This presents a problem for the LTC1705—it
needs to generate a gate drive signal at TG higher than its
highest supply voltage. To accomplish this, the TG driver
runs from floating supplies, with its negative supply
attached to SW and its power supply at BOOST. This
allows it to slew up and down with the source of QT. In
combination with a simple external charge pump (Figure
2), this allows the LTC1705 to completely enhance the
gate of QT without requiring an additional, higher supply
voltage.
The two channels of the LTC1705 run from a common
clock, with the phasing chosen to be 180
°
from the core
side to the I/O side. This has the effect of doubling the
frequency of the switching pulses seen by the input
bypass capacitor, lowering the RMS current seen by the
capacitor and reducing the value required.
Feedback Amplifier
Each side of the LTC1705 senses the output voltage at
V
OUT
with an internal feedback op amp (see Block Dia-
gram). This is a real op amp with a low impedance output,
85dB open-loop gain and 20MHz gain bandwidth product.
The positive input is connected internally to an 800mV
reference, while the negative input is connected to the FB
pin. The output is connected to COMP, which is in turn
connected to the soft-start circuitry and from there to the
PWM generator.
Unlike many regulators that use a resistor divider con-
nected to a high impedance feedback input, the LTC1705
is designed to use an inverting summing amplifier topol-
ogy with the FB pin configured as a virtual ground. This
allows flexibility in choosing pole and zero locations not
available with simple gm configurations. In particular, it
allows the use of “Type 3” compensation, which provides
a phase boost at the LC pole frequency and significantly
improves loop phase margin (see Figure 3). Note that the
core side of the LTC1705 includes R1 and R
B
internally as
part of the VID DAC circuitry.
APPLICATIU
W
U
U
TG
SW
BG
PGND
LTC1705
QT
C
IN
QB
L
+
C
OUT
1705 F01
V
OUT
V
IN
+
TG
C
CP
D
CP
BOOST
SW
BG
PGND
PV
CC
LTC1705
QT
C
IN
QB
L
+
C
OUT
1705 F02
V
OUT
V
IN
+
–
+
FB
0.8V
R1
FB
V
OUT
LTC1705
COMP
1705 F03
R3
C3
C2
R
B
R2
C1
Figure 2. Floating TG Driver Supply
Figure 1. Synchronous Buck Architecture
Figure 3. "Type 3" Feedback Loop (I/O Channel)
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1705EGN | Dual 550kHz Synchronous Switching Regulator Controller with 5-Bit VID and 150mA LDO |
| LTC1710 | Synchronous 8-Bit Up/Down Binary Counters 24-PDIP 0 to 70 |
| LTC1710C | Synchronous 8-Bit Up/Down Binary Counters 24-PDIP 0 to 70 |
| LTC1710CMS8 | Dual 16-By-4 Register Files 24-SOIC 0 to 70 |
| LTC1710CS8 | SMBus Dual Monolithic High Side Switch |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1705EGN | 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
| LTC1705EGN#PBF | 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
| LTC1705EGN#TR | 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
| LTC1705EGN#TRPBF | 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
| LTC1706CS8-19 | 功能描述:IC VID VOLTAGE PROGRAMMER 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。