參數資料
型號： LT3652EDD#TRPBF
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： 3 A BATTERY CHARGE CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO12
封裝： 3 X 3 MM, LEAD FREE, PLASTIC, DFN-12
文件頁數： 11/26頁
文件大小： 253K
代理商： LT3652EDD#TRPBF
LT3652
19
3652fc
Status Pins
The LT3652 reports charger status through two open
collector outputs, the CHRG and FAULT pins. These pins
can accept voltages as high as VIN, and can sink up to
10mA when enabled.
The CHRG pin indicates that the charger is delivering
current at greater that a C/10 rate, or 1/10th of the pro-
grammed maximum charge current. The FAULT pin signals
bad battery and NTC faults. These pins are binary coded,
and signal following the table below, where ON indicates
pin pulled low, and OFF indicates pin high-impedance:
STATUS PINS STATE
CHARGER STATUS
CHRG
FAULT
OFF
Not Charging — Standby or Shutdown Mode
OFF
ON
Bad Battery Fault (Precondition Timeout / EOC
Failure)
ON
OFF
Normal Charging at C/10 or Greater
ON
NTC Fault (Pause)
If the battery is removed from an LT3652 charger that is
configured for C/10 termination, a sawtooth waveform
of approximately 100mV appears at the charger output,
due to cycling between termination and recharge events,
This cycling results in pulsing at the CHRG output. An
LED connected to this pin will exhibit a blinking pattern,
indicating to the user that a battery is not present. The
frequency of this blinking pattern is dependent on the
output capacitance.
C/10 Termination
The LT3652 supports a low-current based termination
scheme, where a battery charge cycle terminates when the
current output from the charger falls to below one-tenth
of the maximum current, as programmed with RSENSE.
The C/10 threshold current corresponds to 10mV across
RSENSE. This termination mode is engaged by shorting
the TIMER pin to ground.
APPLICATIONS INFORMATION
When C/10 termination is used, a LT3652 charger will
source battery charge current as long as the average
current level remains above the C/10 threshold. As the
full-charge float voltage is achieved, the charge current
falls until the C/10 threshold is reached, at which time the
charger terminates and the LT3652 enters standby mode.
The CHRG status pin follows the charger cycle, and is high
impedance when the charger is not actively charging.
When VBAT drops below 97.5% of the full-charged float
voltage, whether by battery loading or replacement of the
battery, the charger automatically re-engages and starts
charging.
There is no provision for bad battery detection if C/10
termination is used.
Timer Termination
The LT3652 supports a timer based termination scheme, in
which a battery charge cycle is terminated after a specific
amount of time elapses. Timer termination is engaged
when a capacitor (CTIMER) is connected from the TIMER
pin to ground. The timer cycle EOC (TEOC) occurs based
on CTIMER following the relation:
CTIMER = TEOC 2.27 x 10–7
(Hours)
Timer EOC is typically set to 3 hours, which requires a
0.68μF capacitor.
The CHRG status pin continues to signal charging at a C/10
rate, regardless of what termination scheme is used. When
timer termination is used, the CHRG status pin is pulled
low during a charging cycle until the charger output cur-
rent falls below the C/10 threshold. The charger continues
to top-off the battery until timer EOC, when the LT3652
terminates the charging cycle and enters standby mode.
Termination at the end of the timer cycle only occurs if
the charging cycle was successful. A successful charge
cycle is when the battery is charged to within 2.5% of the
相關PDF資料
PDF描述
LT3652HVEDD#PBF BATTERY CHARGE CONTROLLER, PDSO12
LT3652HVEMSE#TRPBF BATTERY CHARGE CONTROLLER, PDSO12
LT3652HVEDD#TRPBF BATTERY CHARGE CONTROLLER, PDSO12
LT3663EMS8E-3.3#PBF 2.5 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PDSO8
LT3663IMS8E-3.3#PBF 2.5 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PDSO8
相關代理商/技術參數
參數描述
LT3652EMSE 制造商:LINER 制造商全稱:Linear Technology 功能描述:Power Tracking 2A Battery Charger for Solar Power
LT3652EMSE#PBF 功能描述:IC BATTERY CHARGER SOLAR 12MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR)
LT3652EMSE#PBF 制造商:Linear Technology 功能描述:BATTERY CHARGER FOR SOLAR POWER 制造商:Linear Technology 功能描述:IC, BATTERY CHARGER, 2A, MSOP-12
LT3652EMSE#TRPBF 功能描述:IC BATT CHARGER SOLAR 2A 12MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 標準包裝:61 系列:- 功能:電源管理 電池化學:鋰離子（Li-Ion）、鋰聚合物（Li-Pol） 電源電壓:4.35 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:22-WFDFN 裸露焊盤 供應商設備封裝:22-DFN（6x3）裸露焊盤 包裝:管件
LT3652EMSEPBF 制造商:Linear Technology 功能描述:Battery Charger Li-Ion 2A 4.2V MSOP12EP
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*