- 您現在的位置：買賣IC網 > PDF目錄1998 > ICS84314AY-02LFT (IDT, Integrated Device Technology Inc)IC SYNTHESIZER 700MHZ 32-LQFP PDF資料下載
參數資料
| 型號： | ICS84314AY-02LFT |
| 廠商： | IDT, Integrated Device Technology Inc |
| 文件頁數： | 12/23頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC SYNTHESIZER 700MHZ 32-LQFP |
| 標準包裝： | 1,000 |
| 系列： | HiPerClockS™ |
| 類型： | 頻率合成器 |
| PLL： | 帶旁路 |
| 輸入： | 晶體 |
| 輸出： | LVPECL |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 1:4 |
| 差分 - 輸入:輸出： | 無/是 |
| 頻率 - 最大： | 700MHz |
| 除法器/乘法器： | 是/無 |
| 電源電壓： | 3.135 V ~ 3.465 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-LQFP |
| 供應商設備封裝： | 32-TQFP（7x7） |
| 包裝： | 帶卷 (TR) |
| 其它名稱： | 84314AY-02LFT |
ICS84314-02
700MHZ, CRYSTAL-TO-3.3V/2.5V LVPECL FREQUENCY SYNTHESIZER W/FANOUT BUFFER
IDT / ICS 3.3V/2.5V LVPECL FREQUENCY SYNTHESIZER
2
ICS84314AY-02 REV. A MARCH 24, 2009
Functional Description
NOTE: The functional description that follows describes operation
using a 16MHz crystal. Valid PLL loop divider values for different
crystal or input frequencies are defined in the Input Frequency
Characteristics, Table 6, NOTE 1.
The ICS84314-02 features a fully integrated PLL and therefore
requires no external components for setting the loop bandwidth. A
parallel-resonant, fundamental crystal is used as the input to the
on-chip oscillator. The output of the oscillator is divided by 16 prior
to the phase detector. With a 16MHz crystal, this provides a 1MHz
reference frequency. The VCO of the PLL operates over a range of
250MHz to 700MHz. The output of the M divider is also applied to
the phase detector.
The phase detector and the M divider force the VCO output
frequency to be 2M times the reference frequency by adjusting the
VCO control voltage. Note that for some values of M (either too
high or too low), the PLL will not achieve lock. The output of the
VCO is scaled by a divider prior to being sent to each of the
LVPECL output buffers. The divider provides a 50% output duty
cycle.
The programmable features of the ICS84314-02 support two input
modes to program the M divider. The two input operational modes
are parallel and serial. Figure 1 shows the timing diagram for each
mode. In parallel mode, the nP_LOAD input is initially LOW. The
data on inputs M0 through M8 is passed directly to the M divider.
On the LOW-to-HIGH transition of the nP_LOAD input, the data is
latched and the M divider remains loaded until the next LOW
transition on nP_LOAD or until a serial event occurs. As a result,
the M bits can be hardwired to set the M divider to a specific default
state that will automatically occur during power-up. In parallel
mode, the N output divider is set to 2. In serial mode, the N output
divider can be set for either
÷1, ÷2, ÷4 or ÷8. The relationship
between the VCO frequency, the crystal frequency and the M
divider is defined as follows: fVCO = fXTAL x 2M
16
The M value and the required values of M0 through M8 are shown
in Table 3B, Programmable VCO Frequency Function Table. Valid
M values for which the PLL will achieve lock for a 16MHz reference
are defined as 125
≤ M ≤ 350. The frequency out is defined as
follows: fout = fVCO x 1 = fXTAL x 2M x 1
N
16
N
Serial operation occurs when nP_LOAD is HIGH and S_LOAD is
LOW. The shift register is loaded by sampling the S_DATA bits with
the rising edge of S_CLOCK. The contents of the shift register are
loaded into the M divider and N output divider when S_LOAD
transitions from LOW-to-HIGH. The M divide and N output divide
values are latched on the HIGH-to-LOW transition of S_LOAD. If
S_LOAD is held HIGH, data at the S_DATA input is passed directly
to the M divider and N output divider on each rising edge of
S_CLOCK.
Figure 1. Parallel Load Operations
NOTE:
X = Don’t Care
N1 and N0 divider settings are only accessible through the serial configuration interface.
SERIAL LOADING
PARALLEL LOADING
t
S
t
H
t
S
t
H
t
S
Time
M
X
SSC
N1
N0
M8
M7
M6
M5
M4
M3
M2
M1
M0
X
S_CLOCK
S_DATA
S_LOAD
nP_LOAD
S_LOAD
nP_LOAD
M0:M8
相關PDF資料 |
PDF描述 |
|---|---|
| ICS843156AKILF | IC CLK GENERATOR 32VFQFP |
| ICS843156AKLF | IC CLK GENERATOR 32VFQFP |
| ICS843202AYILF | IC SYNTHESIZER 680MHZ 32-LQFP |
| ICS843204AGILF | IC SYNTHESIZER LVPECL 48-TSSOP |
| ICS84320AY-01LN | IC SYNTHESIZER GP LVPECL 32-LQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ICS84314AY-02T | 制造商:ICS 制造商全稱:ICS 功能描述:700MHZ, CRYSTAL-TO-3.3V/2.5V LVPECL FREQUENCY SYNTHESIZER W/FANOUT BUFFER |
| ICS84314AYLF | 功能描述:IC SYNTHESIZER 350MHZ 32-LQFP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:HiPerClockS™ 標準包裝:1,000 系列:- 類型:時鐘/頻率合成器，扇出分配 PLL:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 除法器/乘法器:- 電源電壓:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:56-VFQFN 裸露焊盤 供應商設備封裝:56-VFQFP-EP（8x8） 包裝:帶卷 (TR) 其它名稱:844S012AKI-01LFT |
| ICS84314AYLFT | 功能描述:IC SYNTHESIZER 350MHZ 32-LQFP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:HiPerClockS™ 標準包裝:1,000 系列:- 類型:時鐘/頻率合成器，扇出分配 PLL:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 除法器/乘法器:- 電源電壓:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:56-VFQFN 裸露焊盤 供應商設備封裝:56-VFQFP-EP（8x8） 包裝:帶卷 (TR) 其它名稱:844S012AKI-01LFT |
| ICS84314AYT | 制造商:ICS 制造商全稱:ICS 功能描述:350MHZ, CRYSTAL-TO-3.3V/2.5V LVPECL FREQUENCY SYNTHESIZER W/FANOUT BUFFER |
| ICS843156AKILF | 功能描述:IC CLK GENERATOR 32VFQFP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:HiPerClockS™ 標準包裝:1,000 系列:- 類型:時鐘/頻率合成器，扇出分配 PLL:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 除法器/乘法器:- 電源電壓:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:56-VFQFN 裸露焊盤 供應商設備封裝:56-VFQFP-EP（8x8） 包裝:帶卷 (TR) 其它名稱:844S012AKI-01LFT |
發布緊急采購，3分鐘左右您將得到回復。