- 您現在的位置：買賣IC網 > PDF目錄17061 > EVAL-AD7734EBZ (Analog Devices Inc)BOARD EVALUATION FOR AD7734 PDF資料下載
參數資料
| 型號： | EVAL-AD7734EBZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 22/32頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD EVALUATION FOR AD7734 |
| 標準包裝： | 1 |
| ADC 的數量： | 1 |
| 位數： | 24 |
| 采樣率（每秒）： | 15.4k |
| 數據接口： | 串行 |
| 輸入范圍： | ±10 V |
| 在以下條件下的電源（標準）： | 85mW @ 5V |
| 工作溫度： | -40°C ~ 105°C |
| 已用 IC / 零件： | AD7734 |
| 已供物品： | 板，纜線，CD |
| 產品目錄頁面： | 779 (CN2011-ZH PDF) |
| 相關產品： | AD7734BRUZ-REEL7TR-ND - IC ADC 24BIT 4CH SIG-DEL 28TSSOP AD7734BRUZ-REEL-ND - IC ADC 24BIT 4CH SIG-DEL 28TSSOP AD7734BRUZ-ND - IC ADC 24BIT 4-CH 28-TSSOP AD7734BRU-ND - IC ADC 24BIT 4-CH 28-TSSOP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
Data Sheet
AD7734
Rev. A | Page 29 of 32
FREQUENCY RESPONSE
The sigma-delta modulator runs at the MCLK frequency,
which is effectively the sampling frequency. Therefore, the
Nyquist frequency is the MCLK frequency. The digital filter,
in association with the modulator, features the frequency
response of a first order low-pass filter. The –3 dB point is close
to the frequency of 1/channel conversion time. The roll-off is
–20 dB/dec up to the Nyquist frequency. If chopping is enabled,
the input signal is resampled by chopping. Therefore, the overall
frequency response features notches close to the frequency of
1/channel conversion time. The top envelope is again the ADC
response of –20 dB/dec.
The typical frequency response plots are given in Figure 27
and Figure 28. The plots are normalized to 1/channel
conversion time.
NORMALIZED INPUT FREQUENCY
(INPUT FREQUENCY
× CONVERSION TIME)
GAIN
–
dB
–60
–50
–40
–30
–20
–10
0
0.1
1.0
10.0
CHOP = 1
Figure 27. Typical ADC Frequency Response, Chopping Enabled
NORMALIZED INPUT FREQUENCY
(INPUT FREQUENCY
× CONVERSION TIME)
GAIN
–
dB
–60
–50
–40
–30
–20
–10
0
0.1
1.0
10.0
CHOP = 1
Figure 28. Typical ADC Frequency Response, Chopping Disabled
VOLTAGE REFERENCE INPUTS
The AD7734 has a differential reference input, REF IN(+) and
REF IN(–). The common-mode range for these inputs is from
AGND to AVDD. The nominal differential reference voltage
for specified operation is 2.5 V. Both reference inputs feature
dynamic load. Therefore, the reference inputs should be con-
nected to a low impedance reference voltage source. External
resistance/capacitance combinations may result in gain errors
on the part.
The output noise performance outlined in Table 4 through
Table 9 is for an analog input of 0 V and is unaffected by noise
on the reference. To obtain the same noise performance as
shown in the noise tables over the full input range requires a
low noise reference source for the AD7734. If the reference
noise in the bandwidth of interest is excessive, it will degrade
the performance of the AD7734.
Recommended reference voltage sources for the AD7734
include the AD780, ADR421, REF43, and REF192. Note that in
a typical connection, the voltage reference must be capable of
sinking current flowing out of the BIAS pins through the
internal resistors if a positive voltage is applied to the analog
input. The AD780 meets this requirement. If the voltage
reference used in an application is not capable of sinking
current, an external resistor (5 k) should be connected in
parallel to the REFIN pins.
REFERENCE DETECT
The AD7734 includes on-chip circuitry to detect if the part has
a valid reference for conversions. If the voltage between the
REFIN(+) and REFIN(–) pins goes below the NOREF trigger
voltage (0.5 V typ.) and the AD7734 is performing a conversion,
the NOREF bit in the channel status register is set.
相關PDF資料 |
PDF描述 |
|---|---|
| SK471M100ST | CAP ALUM 470UF 100V 20% RADIAL |
| 0982660774 | CBL 9POS 0.5MM JMPR TYPE D 5" |
| EVAL-AD7794EBZ | BOARD EVALUATION FOR AD7794 |
| VE-B2L-EY | CONVERTER MOD DC/DC 28V 50W |
| DC979A | BOARD DELTA SIGMA ADC LTC2442 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EVAL-AD7738EB | 制造商:Analog Devices 功能描述:Evaluation Board For AD7738 ADC 制造商:Analog Devices 功能描述:EVALUATION BOARD I.C. - Bulk |
| EVAL-AD7738EBZ | 功能描述:BOARD EVAL FOR AD7738 RoHS:是 類別:編程器，開發系統 >> 評估板 - 模數轉換器 (ADC) 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- ADC 的數量:1 位數:12 采樣率（每秒）:94.4k 數據接口:USB 輸入范圍:±VREF/2 在以下條件下的電源（標準）:- 工作溫度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，軟件 |
| EVAL-AD7739EB | 制造商:Analog Devices 功能描述:EVALUATION BOARD I.C. - Bulk |
| EVAL-AD7739EBZ | 功能描述:BOARD EVAL FOR AD7739 RoHS:是 類別:編程器，開發系統 >> 評估板 - 模數轉換器 (ADC) 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- ADC 的數量:1 位數:12 采樣率（每秒）:94.4k 數據接口:USB 輸入范圍:±VREF/2 在以下條件下的電源（標準）:- 工作溫度:-40°C ~ 85°C 已用 IC / 零件:MAX11645 已供物品:板，軟件 |
| EVAL-AD7741/42EB | 制造商:Analog Devices 功能描述:Evaluation Board For Single And Multi-Channel Synchronous Voltage-To-Frequency Converters 制造商:Analog Devices 功能描述:EVALUATION BOARD IC - Bulk |
發布緊急采購，3分鐘左右您將得到回復。