參數資料
型號： EVAL-AD5680EBZ
廠商： Analog Devices Inc
文件頁數： 5/20頁
文件大小： 0K
描述： BOARD EVAL FOR AD5680
產品培訓模塊： DAC Architectures
標準包裝： 1
系列： nanoDAC™
DAC 的數量： 1
位數： 18
采樣率（每秒）： 12.5k
數據接口： 串行
設置時間： 80µs
DAC 型： 電壓
工作溫度： -40°C ~ 105°C
已供物品： 板
已用 IC / 零件： AD5680
相關產品： AD5680BRJZ-1500RL7DKR-ND - IC DAC 18BIT 5V SOT23-8
AD5680BRJZ-1500RL7CT-ND - IC DAC 18BIT 5V SOT23-8
AD5680BRJZ-2REEL7DKR-ND - IC DAC 18BIT 5V SOT23-8
AD5680BRJZ-2REEL7CT-ND - IC DAC 18BIT 5V SOT23-8
AD5680BRJZ-2REEL7TR-ND - IC DAC 18BIT 5V SOT23-8
AD5680BRJZ-2500RL7TR-ND - IC DAC 18BIT 5V SOT23-8
AD5680BRJZ-1500RL7TR-ND - IC DAC 18BIT 5V SOT23-8
Data Sheet
AD5680
MICROPROCESSOR INTERFACING
AD5680 to Blackfin ADSP-BF53x Interface
Figure 28 shows a serial interface between the AD5680 and
the Blackfin ADSP-BF53x microprocessor. The ADSP-BF53x
processor family incorporates two dual-channel synchronous
serial ports, SPORT1 and SPORT0, for serial and multiprocessor
communications. Using SPORT0 to connect to the AD5680, the
setup for the interface is as follows. DT0PRI drives the DIN pin
of the AD5680, while TSCLK0 drives the SCLK of the part. The
SYNC is driven from TFS0.
AD5680*
*ADDITIONAL PINS OMITTED FOR CLARITY.
TFS0
DTOPRI
TSCLK0
SYNC
DIN
SCLK
05854-
035
ADSP-BF53x*
Figure 28. AD5680 to Blackfin ADSP-BF53x Interface
AD5680 to 68HC11/68L11 Interface
Figure 29 shows a serial interface between the AD5680 and the
68HC11/68L11 microcontroller. SCK of the 68HC11/68L11
drives the SCLK of the AD5680, while the MOSI output drives
the serial data line of the DAC.
The SYNC signal is derived from a port line (PC7). The setup
conditions for correct operation of this interface are as follows:
The 68HC11/68L11 is configured with its CPOL bit as 0 and its
CPHA bit as 1. When data is being transmitted to the DAC, the
SYNC line is taken low (PC7). When the 68HC11/68L11 is
configured this way, data appearing on the MOSI output is valid
on the falling edge of SCK. Serial data from the 68HC11/68L11
is transmitted in 8-bit bytes with only eight falling clock edges
occurring in the transmit cycle. Data is transmitted MSB first. To
load data to the AD5680, PC7 is left low after the first eight bits
are transferred, and a second serial write operation is performed
to the DAC; PC7 is taken high at the end of this procedure.
AD5680*
*ADDITIONAL PINS OMITTED FOR CLARITY.
PC7
SCK
MOSI
SYNC
SCLK
DIN
05854-
036
68HC11/68L11*
Figure 29. AD5680 to 68HC11/68L11 Interface
AD5680 to 80C51/80L51 Interface
Figure 30 shows a serial interface between the AD5680 and the
80C51/80L51 microcontroller. The setup for the interface is as
follows. TxD of the 80C51/80L51 drives SCLK of the AD5680,
while RxD drives the serial data line of the part. The SYNC
signal is again derived from a bit-programmable pin on the port.
In this case, port line P3.3 is used. When data is to be transmitted
to the AD5680, P3.3 is taken low. The 80C51/80L51 transmits
data in 8-bit bytes only; thus, only eight falling clock edges occur
in the transmit cycle. To load data to the DAC, P3.3 is left low
after the first eight bits are transmitted, and a second write cycle
is initiated to transmit the second byte of data. P3.3 is taken
high following the completion of this cycle. The 80C51/80L51
outputs the serial data in a format that has the LSB first. The
AD5680 must receive data with the MSB first. The 80C51/80L51
transmit routine should take this into account.
80C51/80L51*
AD5680*
*ADDITIONAL PINS OMITTED FOR CLARITY.
P3.3
TxD
RxD
SYNC
SCLK
DIN
05854-
037
Figure 30. AD5680 to 80C51/80L51 Interface
AD5680 to MICROWIRE Interface
Figure 31 shows an interface between the AD5680 and any
MICROWIRE-compatible device. Serial data is shifted out on
the falling edge of the serial clock and is clocked into the AD5680
on the rising edge of the SK.
MICROWIRE*
AD5680*
*ADDITIONAL PINS OMITTED FOR CLARITY.
CS
SK
SO
SYNC
SCLK
DIN
05854-
038
Figure 31. AD5680 to MICROWIRE Interface
Rev. B | Page 13 of 20
相關PDF資料
PDF描述
NRS6010T1R5MMGF INDUCTOR POWER 1.5UH 1.9A SMD
0210490965 CABLE JUMPER 1.25MM .030M 27POS
NR6045T680M INDUCTOR 68UH 900MA 20% SMD
SRN6045-470M INDUCTOR POWER SHIELD 47UH SMD
MIC2026-2YM TR IC SW DISTRIBUTION 2CHAN 8SOIC
相關代理商/技術參數
參數描述
EVAL-AD5684RSDZ 功能描述:BOARD EVAL FOR AD5684R RoHS:是 類別:編程器，開發系統 >> 評估板 - 數模轉換器 (DAC) 系列:nanoDAC™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- DAC 的數量:4 位數:12 采樣率（每秒）:- 數據接口:串行，SPI? 設置時間:3µs DAC 型:電流/電壓 工作溫度:-40°C ~ 85°C 已供物品:板 已用 IC / 零件:MAX5581
EVAL-AD5686RSDZ 功能描述:BOARD EVAL FOR AD5686R RoHS:是 類別:編程器，開發系統 >> 評估板 - 數模轉換器 (DAC) 系列:nanoDAC™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- DAC 的數量:4 位數:12 采樣率（每秒）:- 數據接口:串行，SPI? 設置時間:3µs DAC 型:電流/電壓 工作溫度:-40°C ~ 85°C 已供物品:板 已用 IC / 零件:MAX5581
EVAL-AD5687RSDZ 功能描述:數據轉換 IC 開發工具 RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V
EVAL-AD5689RSDZ 功能描述:數據轉換 IC 開發工具 EVALUATION BOARD RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V
EVAL-AD5694RSDZ 功能描述:BOARD EVAL FOR AD5694R RoHS:是 類別:編程器，開發系統 >> 評估板 - 數模轉換器 (DAC) 系列:nanoDAC™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- DAC 的數量:4 位數:12 采樣率（每秒）:- 數據接口:串行，SPI? 設置時間:3µs DAC 型:電流/電壓 工作溫度:-40°C ~ 85°C 已供物品:板 已用 IC / 零件:MAX5581
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*