- 您現在的位置：買賣IC網 > PDF目錄1993 > DS1318E+ (Maxim Integrated Products)IC COUNTER ELAPSED TIME 24-TSSOP PDF資料下載
參數資料
| 型號： | DS1318E+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 5/15頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC COUNTER ELAPSED TIME 24-TSSOP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 62 |
| 類型： | 耗用時間計數器 |
| 特點： | 警報器，方波輸出 |
| 時間格式： | 二進制 |
| 數據格式： | 二進制 |
| 接口： | 并聯 |
| 電源電壓： | 3 V ~ 3.6 V |
| 電壓 - 電源，電池： | 1.6 V ~ 3.7 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 24-TSSOP |
| 包裝： | 管件 |
| 產品目錄頁面： | 1433 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁
Bit 7: Oscillator Stop Flag (OSF). A logic 1 in this bit
indicates that the oscillator either is or was stopped for
some period of time and may be used to judge the
validity of the timekeeping data. This bit is set to logic 1
any time the oscillator stops. The following are exam-
ples of conditions that can cause the OSF bit to be set:
1)
The first time power is applied.
2)
The voltage present on both VCC and VBAT is
insufficient to support oscillation.
3)
The ENOSC bit is turned off in battery-backed
mode.
4)
External influences on the crystal (i.e., noise, leak-
age, etc.)
Any write to the status register while this flag is active
clears the bit to 0.
Bit 6: Update-In-Progress Flag (UIP). A logic 1 in the
update-in-progress bit indicates that the internal clock
registers may be in the process of updating the user
registers. Writing to any seconds or subseconds regis-
ters when this bit is logic 1 may cause a collision with
the internal update and corrupt one or more of the user
registers until the next update occurs. If the UIP bit is
read and is logic 0, the user has at least 60s to write
to the device without the possibility of causing a colli-
sion with the internal update. The internal timekeeping
update is gated by the falling edge of UIP.
Reading the subseconds and or seconds registers
while UIP is logic 1 may result in reading inconstant val-
ues. If the UIP bit is read and is logic 0, the user has at
least 60s to read from the device without the possibili-
ty of getting inconstant values.
Bit 1: Periodic Flag (PF). The periodic flag bit is set to
1 at the rate determined by the PRS bits in register 0Bh.
If the PF bit is already 1 when the selected frequency
attempts to set it to 1 again, no change occurs. The
user must clear the PIF flag faster than the part
attempts to set it to see the desired PF rate. If the PIE
bit in register 0Ah is also set to logic 1, the IRQ pin is
driven low in response to PF transitioning to 1. Any
write to the status register while this flag is active clears
the bit to 0.
Bit 0: Alarm Flag (ALMF). A logic 1 in the alarm flag
bit indicates that the contents of the seconds registers
matched the contents of the alarm registers. If the AIE
bit in register 0Ah is also set to logic 1, the IRQ pin is
driven low in response to ALMF transitioning to 1. Any
write to the status register while this flag is active clears
the bit to 0.
DS1318
Parallel-Interface Elapsed Time Counter
____________________________________________________________________
13
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
BIT 0
OSF
UIP
0
PF
ALMF
Status Register (0Ch)
60
μs
8kHz
4kHz
UIP
UIP vs. Update Timing
相關PDF資料 |
PDF描述 |
|---|---|
| DS1337S+C01 | IC RTC SERIAL 2WIRE LP 8-SOIC |
| DS1338C-33#T&R | IC RTC 56BYTE NV SRAM 16SOIC |
| DS1339AU+ | IC RTC I2C W/ALARM 8USOP |
| DS1339C-2# | IC RTC I2C W/ALARM 16-SOIC |
| DS1340Z-33/T&R | IC RTC I2C W/CHARGER 3.3V 8-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1318E/GG8 | 制造商:Maxim Integrated Products 功能描述:44 BIT PARALLEL INTFACE ETC 24P TSS - Rail/Tube |
| DS1318E+ | 功能描述:實時時鐘 Parallel-Interface Elapsed Time Cntr RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS1318E+T&R | 制造商:Maxim Integrated Products 功能描述:44 BIT PRLLEL INTFC ETC TRL LF - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC COUNTER ELAPSED TIME 24TSSOP |
| DS1318E+T&R | 功能描述:實時時鐘 PARALLEL-INTERFACE ELAPSED TIME COUNTER RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 總線接口:I2C 日期格式:DW:DM:M:Y 時間格式:HH:MM:SS RTC 存儲容量:64 B 電源電壓-最大:5.5 V 電源電壓-最小:1.8 V 最大工作溫度:+ 85 C 最小工作溫度: 安裝風格:Through Hole 封裝 / 箱體:PDIP-8 封裝:Tube |
| DS13-1Y | 功能描述:固態繼電器-工業安裝 RoHS:否 制造商:Crydom 控制電壓范圍:4 VDC to 32 VDC 負載電壓額定值:7 VDC to 72 VDC 負載電流額定值:160 A 觸點形式: 輸出設備:SSR 安裝風格:Panel |
發布緊急采購，3分鐘左右您將得到回復。