- 您現在的位置：買賣IC網 > PDF目錄17086 > DC1110A (Linear Technology)BOARD DAC LTC2751-16 PDF資料下載
參數資料
| 型號： | DC1110A |
| 廠商： | Linear Technology |
| 文件頁數： | 6/22頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD DAC LTC2751-16 |
| 軟件下載： | QuikEval System |
| 設計資源： | DC1110A Design File DC1110A Schematic |
| 標準包裝： | 1 |
| 系列： | QuikEval™, SoftSpan™ |
| DAC 的數量： | 1 |
| 位數： | 16 |
| 數據接口： | 并聯 |
| 設置時間： | 2µs |
| DAC 型： | 電流 |
| 工作溫度： | 0°C ~ 70°C |
| 已供物品： | 板 |
| 已用 IC / 零件： | LTC2751-16 |
| 相關產品： | DC590B-ND - BOARD DEMO USB SERIAL CONTROLLER LTC2751BIUHF-16#TRPBF-ND - IC DAC 16BIT CUR OUT 38-QFN LTC2751BIUHF-16#PBF-ND - IC DAC 16BIT CUR OUT 38-QFN LTC2751BCUHF-16#TRPBF-ND - IC DAC 16BIT CUR OUT 38-QFN LTC2751BCUHF-16#PBF-ND - IC DAC 16BIT CUR OUT 38-QFN LTC2751AIUHF-16#TRPBF-ND - IC DAC 16BIT CUR OUT 38-QFN LTC2751AIUHF-16#PBF-ND - IC DAC 16BIT CUR OUT 38-QFN LTC2751ACUHF-16#TRPBF-ND - IC DAC 16BIT CUR OUT 38-QFN LTC2751ACUHF-16#PBF-ND - IC DAC 16BIT CUR OUT 38-QFN |
LTC2751
14
2751fa
operaTion
isatwo-functionpin.Theupdatefunctionisdisabledwhen
READ is high, and the UPD pin instead selects the input
or DAC register for readback. Table 1 shows the readback
functions for the LTC2751.
The most common readback task is to check the contents
of an input register after writing to it, before updating the
new data to the DAC register. To do this, bring READ high
while holding UPD low. The contents of the selected port’s
input register are output by the data or span I/O pins.
To read back the contents of a DAC register, bring READ
high, then bring UPD high. The contents of the selected
data or span DAC register are output by the data or span
I/O pins. Note: if no update is desired after the readback
operation, UPD must be returned low before bringing
READ low, otherwise the UPD pin will revert to its primary
function and update the DAC.
System Offset Adjustment
Many systems require compensation for overall system
offset. The RVOS offset adjustment pin is provided for this
purpose. For noise immunity and ease of adjustment, the
control voltage is attenuated to the DAC output:
VOS = –0.01 V(RVOS) [0V to 5V, ±2.5V spans]
VOS = –0.02 V(RVOS) [0V to 10V, ±5V,
–2.5V to 7.5V spans]
VOS = –0.04 V(RVOS) [±10V span]
The nominal input range of this pin is ±5V; other refer-
ence voltages of up to ±15V may be used if needed. The
RVOS pin has an input impedance of 1MW. To preserve the
settling performance of the LTC2751, this pin should be
driven with a Thevenin-equivalent impedance of 10k
W or
less. If not used, RVOS should be shorted to IOUT2.
Table 2. Span Codes
S2
S1
S0
SPAN
0
Unipolar 0V to 5V
0
1
Unipolar 0V to 10V
0
1
0
Bipolar –5V to 5V
0
1
Bipolar –10V to 10V
1
0
Bipolar –2.5V to 2.5V
1
0
1
Bipolar –2.5V to 7.5V
Codes not shown are reserved and should not be used.
Readback
The contents of any one of the four interface registers can
be read back by using the READ pin in conjunction with
the D/S and UPD pins.
A readback operation is initiated by bringing READ to logic
high.TheI/Opins,whicharehigh-impedancedigitalinputs
when READ is low, selectively change to low-impedance
logic outputs during readback.
The I/O pins comprise two ports, data and span. The data
I/O port consists of pins D0-D11, D0-D13 or D0-D15
(LTC2751-12, LTC2751-14 or LTC2751-16, respectively).
The span I/O port consists of pins S0, S1 and S2 for all
parts.
Each I/O port has one dedicated input register and one
dedicated DAC register. The register structure is shown
in the Block Diagram.
The D/S pin is used to select which I/O port (data or span)
isconfiguredtoreadbackthecontentsofitsregisters. The
unselected I/O port’s pins remain high-impedance inputs.
Once the I/O port is selected, its input or DAC register is
selected for readback by using the UPD pin. Note that UPD
相關PDF資料 |
PDF描述 |
|---|---|
| EEM36DRSI | CONN EDGECARD 72POS DIP .156 SLD |
| RP40-2405SGW/N-HC | CONV DC/DC 40W 9-36VIN 05VOUT |
| R-532.5DA | CONV DC/DC 3A 4.5-18VIN 2.5V |
| 0210390972 | CABLE JUMPER 1MM .127M 27POS |
| EEM36DRMI | CONN EDGECARD 72POS .156 SQ WW |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DC1111 | 制造商:TUTH 功能描述: |
| DC-111-1 | 制造商:INTRONICS 制造商全稱:INTRONICS 功能描述:1 WATT SINGLE OUTPUT DC-DC CONVERTERS |
| DC1111A | 功能描述:BOARD DAC LTC2753-16 RoHS:是 類別:編程器，開發系統 >> 評估板 - 數模轉換器 (DAC) 系列:QuikEval™, SoftSpan™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- DAC 的數量:4 位數:12 采樣率（每秒）:- 數據接口:串行，SPI? 設置時間:3µs DAC 型:電流/電壓 工作溫度:-40°C ~ 85°C 已供物品:板 已用 IC / 零件:MAX5581 |
| DC1111C | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:D_1111C Series, Ultra Compact InGaN/SiC SMT LED |
| DC1111C-TR | 功能描述:LED BLUISH-GREEN 0603 SMD RoHS:是 類別:光電元件 >> LED - 1111C 標準包裝:500 系列:Screenmaster® 顏色:琥珀 Millicandela 等級:2260mcd 正向電壓:2.1V 電流 - 測試:20mA 波長 - 主:590nm 波長 - 峰值:- 視角:- 透鏡類型:散射，有色 透鏡樣式/尺寸:圓頂橢圓，5.1mm x 3.7mm 封裝/外殼:徑向 尺寸/尺寸:- 高度:7.00mm 安裝類型:通孔 包裝:散裝 在特定電流下的光通量 - 測試:- |
發布緊急采購，3分鐘左右您將得到回復。