- 您現在的位置：買賣IC網 > PDF目錄1909 > CS61884-IRZ (Cirrus Logic Inc)IC LN INTERF T1/E1/J1 160-LFBGA PDF資料下載
參數資料
| 型號： | CS61884-IRZ |
| 廠商： | Cirrus Logic Inc |
| 文件頁數： | 19/72頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC LN INTERF T1/E1/J1 160-LFBGA |
| 標準包裝： | 126 |
| 功能： | 線路接口單元（LIU） |
| 接口： | E1，J1，T1 |
| 電路數： | 8 |
| 電源電壓： | 3.14 V ~ 3.47 V |
| 功率（瓦特）： | 1.73W |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 160-LFBGA |
| 供應商設備封裝： | 160-TFGBA（13x13） |
| 包裝： | 散裝 |
| 包括： | AMI 編碼器和解碼器，B8ZS 編碼器和解碼器，HDB3 編碼器和解碼器，LOS 檢測 |
| 產品目錄頁面： | 759 (CN2011-ZH PDF) |
| 其它名稱： | 598-1717 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁
CS61884
26
DS485F3
In host mode, TAOS is generated for a particular
channel by asserting the associated bit in the TAOS
Since MCLK is the reference clock, it should be of
adequate stability.
9.6 Automatic TAOS
While a given channel is in the LOS condition, if
the corresponding bit in the Automatic TAOS
set, the device will drive that channel’s TTIP and
TRING with the all ones pattern. This function is
only available in host mode. Refer to Loss-of-Sig-
9.7 Driver Failure Monitor
In host mode, the Driver Failure Monitor (DFM)
function monitors the output of each channel and
sets a bit in the DFM Status Register (05h) (See
Section 14.6 on page 35) if a secondary short cir-
cuit is detected between TTIP and TRING. This
generates an interrupt if the respective bit in the
tion 14.8 on page 36) is also set. Any change in the
page 35) will result in the corresponding bit in the
tion 14.10 on page 36) being set. The interrupt is
cleared by reading the DFM Interrupt Status
This feature works in all modes of operation E1 75
Ω, E1 120 Ω and T1/J1 100 Ω.
9.8 Driver Short Circuit Protection
The CS61884 provides driver short circuit protec-
tion when current on the secondary exceeds 50 mA
RMS during E1/T1/J1 operation modes.
10. RECEIVER
The CS61884 contains eight identical receivers that
utilize an internal matched impedance technique
that provides for the use of a common set of exter-
nal components for 100
Ω (T1/J1), 120 Ω (E1), and
75
Ω (Ε1) operation (Refer to Figure 17 on
page 51). This feature enables the use of a one
stuffing option for all E1/T1/J1 line impedances.
The appropriate E1/T1/J1 line matching is selected
via the LEN[2:0] and the CBLSEL pins in hard-
ware mode, or via the Line Length Channel ID
bits[3:0] of the Line Length Data Register (11h)
(See Section 14.18 on page 39) in host mode. The
receivers can also be configured to use different ex-
ternal resistors to match the line impedance for E1
75
Ω, E1 120Ω or T1/J1 100Ω modes (Refer to
The CS61884 receiver provides all of the circuitry
to recover both data and clock from the data signal
input on RTIP and RRING. The matched imped-
ance receiver is capable of recovering signals with
12 dB of attenuation (referenced to 2.37 V or 3.0V
nominal) while providing superior return loss. In
addition, the timing recovery circuit along with the
jitter attenuator provide jitter tolerance that far ex-
ceeds jitter specifications (Refer to Figure 20 on
page 58).
The recovered data and clock is output from the
CS61884 on RPOS/RNEG and RCLK. These pins
output the data in one of three formats: bipolar, un-
ipolar, or RZ. The CLKE pin is used to configure
RPOS/RNEG, so that data is valid on either the ris-
ing or falling edge of RCLK.
10.1 Bipolar Output Mode
Bipolar mode provides a transparent clock/data re-
covery for applications in which the line decoding
is performed by an external framing device. The re-
covered clock and data are output on RCLK,
RNEG/BPV, and RPOS/RDATA.
10.2 Unipolar Output Mode
In unipolar mode, the CS61884 decodes the recov-
ered data with either B8ZS, HDB3 or AMI line de-
coding. The decoded data is output on the
相關PDF資料 |
PDF描述 |
|---|---|
| CS8130-CS | IC IR TRANSCEIVER 2-5V 20-SSOP |
| CS8190EDWF20G | IC TACH/SPEEDO DRVR PREC 20SOICW |
| CS8191XNF16 | IC DRVR AIRCORE TACH/SPEED 16DIP |
| CS82C5296 | IC UART/BRG 5V 16MHZ 28-PLCC |
| CS82C59A-1296 | IC CTRL INTERRUPT 12.5MHZ 28PLCC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CS61884-IRZR | 功能描述:網絡控制器與處理器 IC IC Octal T1/E1/J1 Line Interface Unit RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| CS6193-000 | 功能描述:多芯電纜 RoHS:否 制造商:Alpha Wire 導體數量:3 線規 - 美國線規（AWG）:16 絞合:19 x 29 屏蔽:Shielded 長度:100 ft 電壓額定值:600 V 外殼材料:Polytetrafluoroethylene (PTFE) 絕緣材料:Polytetrafluoroethylene (PTFE) 類型:Communication and Control |
| CS61N | 功能描述:CM SCREWDRIVER,6IN1,INTERCHANGEA 制造商:apex tool group 系列:* 零件狀態:在售 標準包裝:1 |
| CS62 | 制造商:Thomas & Betts 功能描述:Cable Accessories Compression Splice Aluminum |
| CS6-20 | 制造商:SUPERWORLD 制造商全稱:Superworld Electronics 功能描述:POWER TRANSFORMER |
發布緊急采購，3分鐘左右您將得到回復。