- 您現在的位置：買賣IC網 > PDF目錄1909 > CS4205-KQZ (Cirrus Logic Inc)IC CODEC AC97 I2S 48-LQFP PDF資料下載
參數資料
| 型號： | CS4205-KQZ |
| 廠商： | Cirrus Logic Inc |
| 文件頁數： | 55/81頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC CODEC AC97 I2S 48-LQFP |
| 標準包裝： | 250 |
| 類型： | 音頻編解碼器 '97 |
| 數據接口： | 串行 |
| 分辨率（位）： | 18，20 b |
| ADC / DAC 數量： | 1 / 2 |
| 三角積分調變： | 是 |
| 動態范圍，標準 ADC / DAC (db)： | 90 / 90 |
| 電壓 - 電源，模擬： | 4.75 V ~ 5.25 V |
| 電壓 - 電源，數字： | 4.75 V ~ 5.25 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-LQFP |
| 供應商設備封裝： | 48-TQFP（9x9） |
| 包裝： | 托盤 |
| 產品目錄頁面： | 754 (CN2011-ZH PDF) |
| 其它名稱： | 598-1182 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁當前第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁
CS4205
DS489PP4
59
10. POWER MANAGEMENT
10.1
AC ’97 Reset Modes
The CS4205 supports four reset methods, as de-
fined in the AC ’97 Specification: Cold Reset,
Warm Reset, New Warm Reset, and Register Reset.
A Cold Reset results in all AC ’97 logic (registers
included) initialized to its default state. A Warm
Reset or New Warm Reset leaves the contents of
the AC ’97 register set unaltered. A Register Reset
initializes only the AC ’97 registers to their default
states.
10.1.1
Cold Reset
A Cold Reset is achieved by asserting RESET# for
a minimum of 1 s after the power supply rails
have stabilized. This is done in accordance with the
minimum timing specifications in the AC ’97 Seri-
al Port Timing section on page 10. Once de-assert-
ed, all of the CS4205 registers will be reset to their
default power-on states and the BIT_CLK and
SDATA_IN signals will be reactivated.
10.1.2
Warm Reset
A Warm Reset allows the AC-link to be reactivated
without losing information in the CS4205 registers.
A Warm Reset is required to resume from a D3hot
state where the AC-link had been halted yet full
power had been maintained. A primary codec
Warm Reset is initiated when the SYNC signal is
driven high for at least 1 s and then driven low in
the absence of the BIT_CLK clock signal. The
BIT_CLK clock will not restart until at least 2 nor-
mal BIT_CLK clock periods (162.8 ns) after the
SYNC signal is de-asserted. A Warm Reset of the
secondary codec is recognized when the primary
codec on the AC-link resumes BIT_CLK genera-
tion. The CS4205 will wait for BIT_CLK to be sta-
ble to restore SDATA_IN activity, S/PDIF and/or
serial data port transmission on the following
frame.
10.1.3
New Warm Reset
The New Warm Reset also allows the AC-link to
be reactivated without losing information in the
registers. A New Warm Reset is required to resume
from a D3cold state where AC-link power has been
removed. New Warm Reset is recognized by the
low-high transition of RESET# after the AC-link
has been programmed into PR4 powerdown. The
New Warm Reset functionality can be disabled by
setting the CRST bit in the Misc. Crystal Control
Register (Index 60h).
10.1.4
Register Reset
The last reset mode provides a Register Reset to the
CS4205. This is available only when the CS4205
AC-link is active and the Codec Ready bit is ‘set’.
The audio (including extended audio) control reg-
isters (Index 00h - 3Ah) and the vendor specific
registers (Index 5Ah - 7Ah) are reset to their de-
fault states by a write of any value to the Reset Reg-
ister (Index 00h). The modem (including GPIO)
registers (Index 3Ch - 56h) are reset to their default
states by a write of any value to the Extended Mo-
相關PDF資料 |
PDF描述 |
|---|---|
| CS4207-DNZ | IC CODEC AUD HDPN AMP AUTO 48QFN |
| CS4265-CNZ | IC CODEC 24BIT 104DB 32QFN |
| CS4270-DZZ | IC CODEC 24BIT 105DB 24TSSOP |
| CS4271-DZZ | IC CODEC 24BIT 114DB 28-TSSOP |
| CS4272-DZZ | IC CODEC 24BIT 114DB 28-TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CS4205-KQZR | 功能描述:接口—CODEC IC AC’97 Codec for Docking Stations RoHS:否 制造商:Texas Instruments 類型: 分辨率: 轉換速率:48 kSPs 接口類型:I2C ADC 數量:2 DAC 數量:4 工作電源電壓:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-81 封裝:Reel |
| CS4207 | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:Low-power, 4-in / 6-out HD Audio CODEC with Headphone Amp |
| CS4207-CNZ | 功能描述:接口—CODEC IC Lo Pwr,4/6 HD Aud Codec w/HP Amp RoHS:否 制造商:Texas Instruments 類型: 分辨率: 轉換速率:48 kSPs 接口類型:I2C ADC 數量:2 DAC 數量:4 工作電源電壓:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-81 封裝:Reel |
| CS4207-CNZ/C1 | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:Low-power, 4-in / 6-out HD Audio CODEC with Headphone Amp |
| CS4207-CNZR | 功能描述:接口—CODEC IC Lo Pwr,4/6 HD Aud Codec w/HP Amp RoHS:否 制造商:Texas Instruments 類型: 分辨率: 轉換速率:48 kSPs 接口類型:I2C ADC 數量:2 DAC 數量:4 工作電源電壓:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-81 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。