參數資料
型號: AD8150ASTZ
廠商: Analog Devices Inc
文件頁數: 15/44頁
文件大小: 0K
描述: IC CROSSPOINT SWIT 33X17 184LQFP
標準包裝: 1
系列: XStream™
功能: 交叉點開關
電路: 1 x 33:17
電壓電源: 雙電源
電壓 - 電源,單路/雙路(±): ±3 V ~ 5.25 V
工作溫度: 0°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 184-LQFP
供應商設備封裝: 184-LQFP(20x20)
包裝: 管件
AD8150
Rev. A | Page 22 of 44
RE Input
Second-rank read enable. Forcing this pin to logic low enables
the output drivers on the bidirectional D[6:0] pins, entering the
readback mode of operation. By selecting an output address
with the A[4:0] pins and forcing RE to logic low, the 7-bit data
stored in the second-rank latch for that output address will be
written to the D[6:0] pins. Data should not be written to the
D[6:0] pins externally while in readback mode. The RE and WE
pins are not exclusive and may be used at the same time, but
data should not be written to the D[6:0] pins from external
sources while in readback mode.
CS Input
Chip select. This pin must be forced to logic low to program or
receive data from the logic interface, with the exception of the
RESET pin, described below. This pin has no effect on the
signal pairs and does not alter any of the stored control data.
RESET Input
Global output disable pin. Forcing the RESET pin to logic low
will reset the enable bit, D6, in all 17 second-rank latches,
regardless of the state of any other pins. This has the effect of
immediately disabling the 17 output signal pairs in the matrix.
It is useful to momentarily hold RESET at a logic low state when
powering up the AD8150 in a system that has multiple output
signal pairs connected together. Failure to do this may result in
several signal outputs contending after power-up. The reset pin
is not gated by the state of the chip-select pin, CS. It should be
noted that the RESET pin does not program the first rank,
which will contain undefined data after power-up.
CONTROL INTERFACE TRANSLATORS
The AD8150 control interface has two supply pins, VDD and VSS.
The potential between the positive logic supply VDD and the
negative logic supply VSS must be at least 3 V and no more than
5 V. Regardless of supply, the logic threshold is approximately
1.6 V above VSS, allowing the interface to be used with most
CMOS and TTL logic drivers.
The signal matrix supplies, VCC and VEE, can be set independent
of the voltage on VDD and VSS, with the constraints that (VDD
VEE) ≤ 10 V. These constraints will allow operation of the
control interface on 3 V or 5 V while the signal matrix is
operated on 3.3 V or 5 V PECL, or on 3.3 V or 5 V ECL.
相關PDF資料
PDF描述
AD8151ASTZ IC CROSSPOINT SWIT 33X17 184LQFP
AD8152JBP IC CROSSPOINT SWIT 34X34 256BGA
AD8153ACPZ-RL7 IC SW MUX/DEMUX SGL BUFF 32LFCSP
AD8155ACPZ IC MUX/DEMUX DUAL BUFFER 64LFCSP
AD8156ABCZ IC SWITCH XPT 4X4 W/EQ 49CSPBGA
相關代理商/技術參數
參數描述
AD8150ASTZ 制造商:Analog Devices 功能描述:IC DIGITAL CROSSPOINT SWITCH
AD8150-EVAL 制造商:Analog Devices 功能描述:EVAL KIT FOR 33 17, 1.5 GBPS DGTL CROSSPOINT SWIT - Bulk
AD8151 制造商:AD 制造商全稱:Analog Devices 功能描述:33 x 17, 3.2 Gb/s Digital Crosspoint Switch
AD8151AST 制造商:AD 制造商全稱:Analog Devices 功能描述:33 x 17, 3.2 Gb/s Digital Crosspoint Switch
AD8151ASTZ 功能描述:IC CROSSPOINT SWIT 33X17 184LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 模擬開關,多路復用器,多路分解器 系列:XStream™ 其它有關文件:STG4159 View All Specifications 標準包裝:5,000 系列:- 功能:開關 電路:1 x SPDT 導通狀態電阻:300 毫歐 電壓電源:雙電源 電壓 - 電源,單路/雙路(±):±1.65 V ~ 4.8 V 電流 - 電源:50nA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:7-WFBGA,F(xiàn)CBGA 供應商設備封裝:7-覆晶 包裝:帶卷 (TR)