參數資料
型號： AD7877ACBZ-REEL7
廠商： Analog Devices Inc
文件頁數： 24/45頁
文件大?。?/td> 0K
描述： IC CTRLR TOUCH SCREEN 25-WLCSP
標準包裝： 1
類型： 電阻
觸摸面板接口： 4 線
輸入數/鍵： 1 TSC
分辨率（位）： 12 b
評估套件： 可供
數據接口： 串行，SPI?
數據速率/采樣率 (SPS，BPS)： 125k
電壓基準： 外部，內部
電源電壓： 2.7 V ~ 5.25 V
電流 - 電源： 1µA
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 25-UFBGA，WLCSP
供應商設備封裝： 25-WLCSP
包裝： 標準包裝
產品目錄頁面： 779 (CN2011-ZH PDF)
配用： EVAL-AD7877EBZ-ND - BOARD EVALUATION FOR AD7877
其它名稱： AD7877ACBZ-REEL7DKR
Data Sheet
AD7877
Rev. D | Page 29 of 44
WRITE TIMING
No serial interface operations can take place when CS is high.
To write to the AD7877, CS must be taken low. To write to the
device, a burst of 16 clock pulses is input to DCLK while the write
data is input to DIN. Data is clocked in on the rising edge of
DCLK. If multiple write operations are to be performed, CS must
be taken high after the end of each write operation before another
write operation can be performed by taking CS low again.
READING DATA
Data is available on the DOUT pin following the falling edge of
CS, when the device is being clocked. The MSB is clocked out
on the falling edge of CS, with subsequent data bits clocked out
on the falling edge of DCLK.
After CS is taken low and the device is clocked, the AD7877
outputs data from the register whose read address is currently
stored in Control Register 1. Once this data has been output,
the address increments automatically. CS must be taken high
between reads. When CS is taken low again, reading continues
from the register whose read address is in Control Register 1,
provided that a write operation does not change the address. If
the register read address reaches 11111b, it is then reset to zero.
This feature allows all registers to be read out in sequence with-
out having to explicitly write all their addresses to the device.
Note that because data-words are 16 bits long, but the data
registers are only 12 bits long, or 8 bits in the case of GPIO
registers, the first four bits of a readback data-word are zeros, or
the first 8 bits in the case of a GPIO register.
VDRIVE PIN
The supply voltage to all pins associated with the serial interface
(DAV, DIN, DOUT, DCLK, CS, PENIRQ, and ALERT) is
separate from the main VCC supply and is connected to the
VDRIVE pin. This allows the AD7877 to be connected directly to
processors whose supply voltage is less than the minimum
operating voltage of the AD7877, in fact, as low as 1.7 V.
相關PDF資料
PDF描述
MS27484T22A35SB CONN PLUG 100POS STRAIGHT W/SCKT
MS27468T25B35SD CONN RCPT 128POS JAM NUT W/SCKT
MS27468E25B35SD CONN RCPT 128POS JAM NUT W/SCKT
MAX11811ETP+ IC TOUCH SCREEN 12BIT I2C 20TQFN
MXB7843EEE+ IC CNTRLR TOUCH RES 16QSOP
相關代理商/技術參數
參數描述
AD7877ACP 制造商:Analog Devices 功能描述:TOUCH SCREEN CNTRLR 32LFCSP - Bulk
AD7877ACP-500RL7 制造商:Analog Devices 功能描述:TOUCH SCREEN CONTROLLER
AD7877ACP-REEL 制造商:AD 制造商全稱:Analog Devices 功能描述:Touch Screen Controller
AD7877ACP-REEL7 制造商:Analog Devices 功能描述:TOUCH SCREEN CONTROLLER
AD7877ACPZ 制造商:Analog Devices 功能描述:TOUCH SCREEN CNTRLR 32LFCSP - Bulk
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*