參數資料
型號： AD7851KNZ
廠商： Analog Devices Inc
文件頁數： 22/36頁
文件大小： 0K
描述： IC ADC 14BIT SRL 333KSPS 24-DIP
標準包裝： 15
位數： 14
采樣率（每秒）： 333k
數據接口： 8051，QSPI?，串行，SPI? µP
轉換器數目： 2
功率耗散（最大）： 89.25mW
電壓電源： 模擬和數字
工作溫度： 0°C ~ 85°C
安裝類型： 通孔
封裝/外殼： 24-DIP（0.300"，7.62mm）
供應商設備封裝： 24-PDIP
包裝： 管件
輸入數目和類型： 1 個偽差分，單極；1 個偽差分，雙極
–29–
REV. B
AD7851
SERIAL
INTERFACE
MODE
?
NO
YES
TRANSFER
DATA
DURING
CONVERSION
?
APPLY
SYNC (IF REQUIRED), SCLK, READ
CURRENT CONVERSION RESULT ON DOUT PIN,
AND WRITE ALL 0s ON DIN PIN
WAIT FOR BUSY SIGNAL TO GO LOW
OR WAIT FOR BUSY BIT = 0
APPLY
SYNC (IF REQUIRED), SCLK, WRITE TO CONTROL
REGISTER SETTING
CONVST BIT TO 1, READ CURRENT
CONVERSION RESULT ON DOUT PIN
2, 3
INITIATE
CONVERSION
IN
SOFTWARE
?
WAIT APPROXIMATELY 200ns
AFTER
CONVST RISING EDGE
APPLY
SYNC (IF REQUIRED),
SCLK, READ PREVIOUS CONVERSION
RESULT ON DOUT PIN,
AND WRITE ALL 0s ON DIN PIN
NO
YES
TRANSFER
DATA DURING
CONVERSION
APPLY
SYNC (IF REQUIRED), SCLK, WRITE TO CONTROL
REGISTER SETTING
CONVST BIT TO 1, READ PREVIOUS
CONVERSION RESULT ON DOUT PIN (SEE NOTE)
YES
NO
NOTE: WHEN USING THE SOFTWARE CONVERSION START AND
TRANSFERRING DATA DURING CONVERSION, THE USER MUST ENSURE
THE CONTROL REGISTER WRITE OPERATION EXTENDS BEYOND THE
FALLING EDGE OF BUSY. THE FALLING EDGE OF BUSY RESETS THE
CONVST BIT TO 0 AND ONLY AFTER THIS TIME CAN IT BE REPROGRAMMED
TO 1 TO START THE NEXT CONVERSION.
START
POWER ON, APPLY CLKIN SIGNAL,
WAIT FOR AUTOMATIC CALIBRATION
PULSE
CONVST PIN
WAIT FOR BUSY SIGNAL TO GO
LOW OR WAIT FOR BUSY BIT = 0
Figure 41. Flowchart for Setting Up, Reading, and Writing in Interface Modes 2 and 3
Writing to the AD7851
For accessing the on-chip registers, it is necessary to write to the
part. To enable Serial Interface Mode 1, the user must also write
to the part. Figures 41, 42, and 43 shows how to configure the
AD7851 for each of the different serial interface modes. The
continuous loops on all diagrams indicate the sequence for more
than one conversion. The options of using a hardware (pulsing
the
CONVST pin) or software (setting the CONVST bit to 1)
conversion start, and reading/writing during or after conversion
are shown in Figures 41 and 42. If the
CONVST pin is never
used, then it should be tied to DVDD permanently. Where refer-
ence is made to the BUSY bit equal to a Logic 0, to indicate the
end of conversion, the user in this case would poll the BUSY bit
in the status register.
Interface Modes 2 and 3 Configuration
Figure 41 shows the flowchart for configuring the part in Inter-
face Modes 2 and 3. For these interface modes, the read and
write operations take place simultaneously via the serial port.
Writing all 0s ensures that no valid data is written to any of the
registers. When using the software conversion start and transfer-
ring data during conversion, the Figure 41 note must be obeyed.
相關PDF資料
PDF描述
VE-25Y-MX CONVERTER MOD DC/DC 3.3V 49.5W
MS27474E12F4P CONN RCPT 4POS JAM NUT W/PINS
ADM3072EYRZ-REEL7 IC TXRX RS485 3.3V HD 8-SOIC
VE-25X-MY CONVERTER MOD DC/DC 5.2V 50W
MS27467E21A41S CONN PLUG 41POS STRAIGHT W/SCKT
相關代理商/技術參數
參數描述
AD7851KR 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述:
AD7851KR-REEL 制造商:Analog Devices 功能描述:
AD7851KRZ 功能描述:IC ADC 14BIT SRL 333KSPS 24-SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極
AD7851KRZ3 制造商:AD 制造商全稱:Analog Devices 功能描述:14-Bit 333 kSPS Serial A/D Converter
AD7851KRZ-REEL 功能描述:IC ADC 14BIT SRL 333KSPS 24-SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*