
Serial Communications Interface (SCI)
Technical Data
MC68HC08AZ32A — Rev 1.0
210
Serial Communications Interface (SCI)
For More Information On This Product,
Go to: www.freescale.com
MOTOROLA
Controls idle character detection
Enables parity function
Controls parity type
LOOPS — Loop Mode Select Bit
This read/write bit enables loop mode operation. In loop mode the
RxD pin is disconnected from the SCI, and the transmitter output goes
into the receiver input. Both the transmitter and the receiver must be
enabled to use loop mode. Reset clears the LOOPS bit.
1 = Loop mode enabled
0 = Normal operation enabled
ENSCI — Enable SCI Bit
This read/write bit enables the SCI and the SCI baud rate generator.
Clearing ENSCI sets the SCTE and TC bits in SCI status register 1
and disables transmitter interrupts. Reset clears the ENSCI bit.
1 = SCI enabled
0 = SCI disabled
TXINV — Transmit Inversion Bit
This read/write bit reverses the polarity of transmitted data. Reset
clears the TXINV bit.
1 = Transmitter output inverted
0 = Transmitter output not inverted
NOTE:
Setting the TXINV bit inverts all transmitted values, including idle, break,
start, and stop bits.
Address:
$0013
Bit 7
6
5
4
3
2
1
Bit 0
Read:
LOOPS
ENSCI
TXINV
M
WAKE
ILLTY
PEN
PTY
Write:
Reset:
0
0
0
0
0
0
0
0
Figure 15-11. SCI Control Register 1 (SCC1)
F
Freescale Semiconductor, Inc.
n
.